Manual de instrucciones de Hunter,R.F EX5 4RJ

Resumen del contenido incluido en la página 1

Hunter Hawk
Gas Stove
User
Instructions







Please leave this instruction booklet with the user after the installation is
complete. Leave the system ready for operation and instruct the user in the
correct use of the appliance and operation of its controls.
Please refer to the appliance data plate for the specific model type.

Resumen del contenido incluido en la página 2

PLEASE READ THESE INSTRUCTIONS CAREFULLY It is important that your stove is correctly installed and operated, as Hunter Stoves Limited cannot accept responsibility for any fault arising from incorrect installation of this product. IMPORTANT POINTS FOR THE USER 1. Read all instructions carefully before attempting to operate this appliance. 2. If you have any doubts about the suitability of your chimney for the appliance please consult your local Hunter Stoves stockist/dealer.

Resumen del contenido incluido en la página 3

Points regarding the ‘Fire-bed’ • The stove is supplied with a ceramic matrix and coals/logs, which are to be arranged by the fitter in strict accordance with the installation instructions. The purchaser must not alter the layout of the coals/logs or add any extra coals/logs. • The coals/logs used in this stove to produce a realistic coal/log effect are made from ceramic fibre based material. The ‘coals/logs’ may change colour after use, which is quite normal. • Replacement cerami

Resumen del contenido incluido en la página 4

Lighting the Pilot Flame With the gas control knob in the fully ‘off’ position, press the control knob in fully and turn anti-clockwise towards the ‘piezo ignition’ position on the control tap backplate. An audible click of the piezo igniter should be heard and a spark should be seen arcing between the pilot head and the pilot electrode. Repeat the procedure until a small flame can be seen at the pilot head. Once the pilot flame is established, keep the control knob depressed for 10-20

Resumen del contenido incluido en la página 5

Care, Maintenance and Servicing Check your chimney and flue arrangement at least annually and have the chimney system swept at least once a year. The outside of the appliance is finished with a heat resistant paint and can be cleaned with a soft brush. Do not attempt to clean the appliance if it is hot. If required the finish can be renovated using either Hunter Stoves stove polish or Hunter Stoves stove paint. A CORGI registered fitter must carry out servicing at least annuall