Resumen del contenido incluido en la página 1
User Guide
Resumen del contenido incluido en la página 2
DA FI Nokia erklærer hermed, at denne digitale modtager, Nokia toteaa, että sen Mediamaster 260 S - Mediamaster 260 S, er i overensstemmelse med væsent- digitaalivastaanotin täyttää direktiivin 1999/5/EY lige krav og andre relevante bestemmelser i direktivet olennaiset vaatimukset ja laitteeseen sovellettavat 1999/5/EC. määräykset. Dette terminaludstyr er beregnet til tilslutning til det Tämä päätelaite on tarkoitettu liitettäväksi yleiseen analoge, offentlige telefonnetværk (Public Switched kyt
Resumen del contenido incluido en la página 3
Contents Control folder — User preferences 19 General information 4 Control folder — Edit channels 19 Remote control 5 Control folder — Edit satellites 22 Front and rear panels 6 Viewing images received from an The smart card and CA module 7 external device 24 General 7 Control folder — Connections 24 The right-hand card slot 7 Control folder — Timer 26 Inserting a CA module with a smart card 7 Control folder — System info 27 Connecting the Mediamaster 8 Control folder — CA Menu 27 Preparing
Resumen del contenido incluido en la página 4
General information The operation of your Mediamaster is based on a series of user-friendly on-screen displays and menus. These menus will help you get the most from your Mediamaster. In addition, they will guide you through installation, channel selection, viewing and many other functions. All functions can be carried out using the buttons on the remote control, and some of the functions can also be carried out using the buttons on the front panel. Please notice that new software may change t
Resumen del contenido incluido en la página 5
Remote control This section describes how to operate the Mediamaster using the buttons on the remote control. Some of the functions can also be carried out using the buttons on the front panel. Press and hold for a few seconds to switch the Mediamaster in and out of standby mode. In viewing mode: press once to turn the sound off/on (mute). red, To be used within a downloaded application , e. g. the Electronic green, Program Guide (EPG); also used in some games. yellow, blue Stop all kind
Resumen del contenido incluido en la página 6
Front and rear panels Front panel to change channels and Lid to move through menus open the lid in order to insert the CA module and the smart card Slot for a CA module with a smart card Slot for inserting a Conax smart card Indicator 1 Indicator 2 Button push the button to release a CA module to put the Mediamaster into and that has been inserted. take it out of standby mode Function LED indicator 1 LED indicator 2 ON Green Green Standby Red - Channel locked Green Red if not locked
Resumen del contenido incluido en la página 7
The smart card and CA module General In order to receive scrambled digital channels, you need a CA module and a smart card, which can be obtained from a Service Provider. CA module There are several different CA modules available on the European market. Each of the CA modules supports a certain kind of encryption system. The Mediamaster supports CA modules that work according to the DVB standard. Depending on the channels you might want to watch, your local dealer will provide you with the righ
Resumen del contenido incluido en la página 8
Connecting the Mediamaster The Mediamaster receiver should have the following items: • the Mediamaster • a remote control with 2 AAA batteries • a SCART cable (fully connected, 1.0 meter) •a mains cable • a User Guide and a software license agreement The SCART sockets The rear panel of the Mediamaster contains 2 SCART sockets (see SCART Mains Remote User cable cable control Guide diagram). When you connect other devices to any of these sockets, always use fully connected SCART cables (as s
Resumen del contenido incluido en la página 9
Connecting the Mediamaster Connecting to the TV • Connect the SCART cable between the main SCART socket on the TV and the TV SCART socket on the Mediamaster. • Connect the TV aerial to the TV. SCART Connecting a TV and VCR Refer to your VCR’s manual for complete instructions. • Connect one SCART cable from the main SCART socket on the TV to the TV SCART socket on the Mediamaster. VCR • Connect another SCART cable from the VCR to the AUX SCART RF socket on the Mediamaster. • Connect the RF ca
Resumen del contenido incluido en la página 10
Installation First-time installation Once you have correctly connected the Mediamaster, you will also have to perform a "First-time installation." During this procedure, helpful information is displayed at the bottom of the menus. The OK button always confirms a selection within the menus, and pressing it will take you to the next step in the installation procedure. However, more than one value often has to be entered in a menu. First, make all necessary setting changes. Then, confirm them all
Resumen del contenido incluido en la página 11
Installation One antenna/one LNB configuration Select this alternative if you have one (1) LNB mounted on the antenna. •Press opt to view the predefined channel. Press opt to turn it off. LNB type Select the correct LNB for your configuration. The most common values, including Universal LNB, can be selected using the cursor left/right button. LNB offset voltage If the cable from the antenna is very long, the voltage at the LNB could be too low to change the polarization. You can increase th
Resumen del contenido incluido en la página 12
Installation Typical connection of a two-way DiSEqC switch: • Connect the cable from the LNB that is intended for channels from the ASTRA satellite (or THOR) to the connector marked LNB 1 (A) on the switch. • Connect the cable from the HOTBIRD satellite (or SIRIUS) to the connector marked LNB 2 (B). • Then, connect the antenna cable to the connector marked OUT on the switch. • Connect the other end of this cable to the ANTENNA input at the rear of the Mediamaster. For each LNB that you
Resumen del contenido incluido en la página 13
Installation Motor antenna configuration If you have an antenna motor to control your satellite antenna, you must configure the following settings. • From the "Antenna/Satellite selection" menu, select option 3 "Motor Antenna Configuration" and press OK. Type of motor • Select SATSCAN (ASTRA) if you have a Nokia SatScan motor. • Select DiSEqC (Hotbird) if the motor that you have is controlled by DiSEqC commands. LNB type • Select the correct LNB type for your configuration, e.g., "Univers
Resumen del contenido incluido en la página 14
Installation Remove limits If you need to remove the east/west limits. When you activate this command, the motor will turn itself to the 0° (Zero) position. However, the next time you select a channel, the motor will return to its proper position. Channel search The Channel search procedure can be carried out in different ways. The menu will look different depending on what option you selected in the "Antenna/satellite selection" menu. If you selected "One antenna/one LNB configuration", se
Resumen del contenido incluido en la página 15
Installation Advanced manual search The information that must be entered in this menu is available in satellite TV magazines or on the Internet. You can use this menu if you are looking for some "special" channels (i.e., non-DVB standard channels) that can only be found when you have entered the necessary settings here. Transponder frequency: Specify the frequency in MHz. polarization: Select Horizontal, Vertical, Circular left or right. Symbol rate: Enter the symbol rate with the number bu
Resumen del contenido incluido en la página 16
Watching TV & listening to the radio General You can watch digital TV or listen to digital radio via satellite with the Mediamaster receiver. • If no TV channel is automatically shown after you finish the installation procedure, press the P+ or P- button to select a channel. • If that does not work, open the Navi Bars with the navi button. • Scroll to the TV channels folder and select a channel. For more information on Navi Bars, see page 18. During the Channel Search procedure, the Media
Resumen del contenido incluido en la página 17
Watching TV & listening to the radio Temporary settings By pressing opt, a menu appears that allows you to configure temporary settings for the channel that you are currently watching. If you leave the channel and return to it later, the temporary settings will be deleted. Audio language If available, you can select from the different languages that are currently being broadcast. Subtitle language If available, you can select from different subtitle languages. TV screen format If you have
Resumen del contenido incluido en la página 18
Navi Bars Navigating with Navi Bars Bookmark Navi Bars are used for selecting TV/Radio channels and changing name Bookmark settings. 1. Display Navi Bars by pressing the navi button and then hide it by pressing the navi or back button. 2. When Navi Bars are displayed, you can move around with the 4- way cursor key. The horizontal bar (row) contains folders, e.g., All TV, Settings, etc. Each folder contains bookmarks. When a folder has been highlighted, i.e., it is where the two bars cross,
Resumen del contenido incluido en la página 19
Navi Bars Control folder — User preferences Banner time-out When you switch channels, a program information banner will be shown for a few seconds. You can select the duration that the banner will be shown. Volume bar Select whether or not you want the volume bar to appear on the screen when you change the volume. Volume bar time-out Select the length of time that the volume bar will be visible on the screen. Subtitles Select whether or not you want subtitles (if available) to be visible
Resumen del contenido incluido en la página 20
Navi Bars Important information about editing channels Before you start, you must select the list, TV or radio, that you want to edit. If you are watching TV and press OK and choose Edit channels, you can only edit TV channels. If you are listening to radio channels, you can only edit radio channels. After selecting radio or TV, use the cursor left/right button to select the name of the list that you want to edit. Create list This feature allows you to create your own favorite lists, containi
