Manual de instrucciones de Bowens QUAD BWL-0350/1

Resumen del contenido incluido en la página 1

QUAD
imaging power
QUAD2400 GENERATOR INSTRUCTIONS BWL-0350/1
BOWENS INTERNATIONAL LIMITED
355 Old Road
Clacton on Sea
Essex CO15 3RH UK
QUAD2400
Tel: +44 (0)1255 422807
Fax: +44 (0)1255 436342
BW-7620
www.bowensinternational.com

Resumen del contenido incluido en la página 2

Table of Contents Specifications Description Page 2 2 (1 per channel) Manual Selection - Channel A = Symmetric Introduction and Safety Notes 3 2 f-stops in one-stop increments 1 3 f-stops in /3-stop increments on each channel 2400w/s Channel A only or split 1200W-s Channel A + 1200W-s Channel B Control Panel Guide 4 – 5 37 to 2400w/s (6-stops) 640 (feet/100 ISO) with UV-coated tube Fast: <3 seconds (230V) <4 seconds (117V) Slow: <5 seconds (230V) <6 seconds (117V) Flash and Modelling Functi

Resumen del contenido incluido en la página 3

Introduction Dear Valued Customer, Thank you for choosing the Bowens QUAD2400 professional flash system. Number of Channels Accurate, ergonomic, powerful and simple to use, the QUAD2400 power pack was designed by Number of Head Sockets working closely with photographers to develop a flash that meets the standards demanded in professional studios today. Symmetric/Asymmetric Heads and accessories from the QUAD range can be used with the QUAD2400 power packs. For Master Power Control details of

Resumen del contenido incluido en la página 4

Control Panel Guide Warnings Signs and Troubleshooting Top Control Panel If the unit appears to have developed a problem, first establish that it is a genuine internal problem and not a case of normal operation such as overheating. Carry out the following checks to eliminate any external causes. If no obvious problem can be found and replacement of the modelling lamp, flash tube or flash head fuse does not eliminate the problem, then it is likely that an internal problem has Sync Sockets develop

Resumen del contenido incluido en la página 5

Getting Started Control Panel Guide Before first using your power pack or after an extended storage period, it is recommended that the unit be checked for basic operation as follows: Rear Panel 1. Remove the packaging and ensure that the unit is switched off. 2. Set up a flash head. Be sure the protective cap is removed and the modelling lamp is fitted and switched on. 3. Plug the head into the socket of Channel A. 4. Set the Overall Power Selector to Symmetric/2400 and the Channel A Var

Resumen del contenido incluido en la página 6

Function Overview Function Overview Test Button and Ready Indicator Light Flash Power Control The green Test Button is lit whenever the power pack reaches 100% charge and is ready to be The power pack is divided into two channels, A and B, and each is fitted with one head socket. An LED triggered. This light flashes when the pack is automatically dumping excess energy after a power-level display for each channel indicates the available power in watt/seconds available at the head fitted to that a