Resumen del contenido incluido en la página 1
Operators Manual
Installation, Operation & Service
Electric T1 Skillets
MODELS:
SEL-30-T1
SEL-40-T1
1333 East 179th St., Cleveland, Ohio, U.S.A. 44110
Enodis
Phone: (216) 481-4900 Fax: (216) 481-3782
Visit our web site at www.clevelandrange.com
SE95051
Resumen del contenido incluido en la página 2
FOR THE USER WARNING: Improper installation, adjustment, alteration, service or maintenance can cause property damage, injury or death. ! Read the Installation, Operating & Service instructions thoroughly before installing or servicing this equipment. IMPORTANT THE INSTALLATION AND CONNECTION MUST COMPLY WITH THE LOCAL AND NATIONAL ELECTRICAL CODES. ENSURE ELECTRICAL SUPPLY CONFORMS WITH ELECTRICAL CHARACTERISTICS SHOWN ON THE RATING LABEL ALL SERVICE MUST BE PERFORMED BY A QUALIFIED CLEVELAND R
Resumen del contenido incluido en la página 3
TABLE OF CONTENTS Installation General. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Inspection / Unpacking . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Shipping Damage Instructions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Wire Connection. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Resumen del contenido incluido en la página 4
INSTALLATION GENERAL SHIPPING DAMAGE INSTRUCTIONS Installation of the unit must be accomplished by qualified electrical installation personnel working If shipping damage to the unit is discovered or to all applicable local and national codes. suspected, observe the following guidelines in Improper installation of product could cause injury preparing a shipping damage claim. or damage. 1. Write down a description of the damage or the This equipment is built to comply with applicable reason for
Resumen del contenido incluido en la página 5
WIRE CONNECTION INSTALLATION CHECKS Although the unit has been thoroughly tested before Note: Ensure main power is turned off before leaving the factory, the installer is responsible for ensur- connecting wires. ing the proper operation of unit once installed. General Information 1. Supply power to the unit by placing the fused dis- Install in accordance with local codes and/or the connect switch to the "ON" position. National Electric Code ANSI/NFPA No. 70-1990 2. Turn Temperature Dial to 150°
Resumen del contenido incluido en la página 6
SPECIFICATION DRAWING DIMENSIONS CAPACITIES MODEL A B C D F G APPROXIMATE In 4 oz. servings. Other sizes may be calculated. SHIPPING WEIGHTS 30 gallons / 115 Liters.............960 SEL-30-T1 39 1/8" 24 1/2" 31 3/4" 12" 18 1/4" 5 3/4" 40 gallons / 150 Liters...........1280 SEL-30-T1 (994mm) (623mm) (807mm) (305mm) (464mm) (146mm) 390 LBS. (178 KG.) 51 1/8" 36 1/2" 43 3/4" 18" 24 1/4" 5 3/4" SEL-40-T1 SEL-40-T1 (1299mm) (928mm) (1112mm) (458mm) (616mm) (146mm) 410 LBS. (187 KG) SPECIFICATIONS ELEC
Resumen del contenido incluido en la página 7
OPERATING INSTRUCTIONS KE95604-1 3 1 8 2 4 5 General Parts Drawing ITEM # DESCRIPTION FUNCTION 1. Power Switch Lower position - power to the unit is OFF. Upper position - power to the unit is ON. 2. Temperature Dial Regulates the surface temperature of the pan. 3. Heat Indicator Light Turns ON when heating system is on and OFF when system is off. 4. Hand Tilt Wheel Used for tilting the pan up or down. Some units have an optional Power Tilt with the tilt switch located in the same position. 5. M
Resumen del contenido incluido en la página 8
OPERATING THE UNIT OPEN LID BEFORE 1. Ensure electrical supply to the unit is in the ON TILTING PAN position. ! 2. Turn Power Switch (1) to the ON position. The yel- low Heat Indicator Light (3) will indicate power is on. 1 3. MANUAL TILT (4): Cleveland skillets are equipped with a manual tilt mechanism for raising 2 and lowering the pan. To raise pan, raise the cover and turn the crank clockwise. To lower pan, turn counterclockwise. POWER TILT: Cleveland skillets can also be equipped with an op
Resumen del contenido incluido en la página 9
CLEANING INSTRUCTIONS NOTE: The best time to clean the skillet is immediately after each use, ✔ as soon as possible after cooking. 3. Remove food soil inside the skillet pan using a nylon brush. CARE AND CLEANING 4. Loosen food which is stuck to the skillet by allow- Your skillet must be cleaned regularly to maintain its ing it to soak at a low temperature setting. fast, efficient cooking performance, and to ensure its continued safe, reliable operation. 5. If the skillet is equipped with a dra
Resumen del contenido incluido en la página 10
SERVICE PARTS WARRANTY Our Company supports a worldwide network of Maintenance and Repair Centers. Contact your nearest Maintenance and Repair Centre for replacement parts, service, or information regarding the proper mainte- nance and repair of your cooking equipment In order to preserve the various agency safety certification (UL, NSF, ASME/Ntl. Bd., etc.), only factory-sup- plied replacement parts should be used. The use of other than factory supplied replacement parts will void warranty. FA
Resumen del contenido incluido en la página 11
PAN MOUNT ASSEMBLY 28 18 24 ITEM PART DESCRIPTION QTY. 9 11 18 10 27 NO. NO. 24 1. HEATING ELEMENTS . . . . . . . . . . . .6 3 30 0 G GA AL LL LO ON N 8 SK50845-1 ELEMENT, 2.00 KW, 480 VAC 14 12 SK50845-2 ELEMENT, 2.67 KW, 416 VAC 13 23 21 SK50845-3 ELEMENT, 2.00 KW, 416 VAC 12 SK50845-4 ELEMENT, 2.67 KW, 240 VAC 26 18 ELEMENT, 2.00 KW, 208 VAC 17 SK50845-5 ELEMENT, 2.00 KW, 240 VAC 16 19 SK50845-6 ELEMENT, 2.67 KW, 208 VAC 22 7 20 SK50845-8 ELEMENT, 2.67 KW, 480 VAC 4 40 0 G GA AL LL LO ON N
Resumen del contenido incluido en la página 12
TILT COMPONENTS 32 33 57 24 25 26 24 25 23 19 20 56 21 20 31 22 30 29 20 27 28 21 44 20 47 19 45 48 55 17 18 46 42 16 43 1 40 41 39 2 3 9 10 36 4 35 52 5 49 53 11 34 50 54 58 4 51 5 12 37 13 38 14 7 8 15 59 ITEM NO. PART NO. DESCRIPTION QTY. 1. KE51730 TILT SHAFT BEARING . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 2. FA31010 LOCK WASHER, 3/8 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 3. FA20030 HEX N
Resumen del contenido incluido en la página 13
TILT COMPONENTS (continued) 17. KE50315 WORM . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 18. FA95005 TENSION PIN . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 19. KE52193 THRUST BEARING SPACER . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 20. KE52192 THRUST WASHER . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Resumen del contenido incluido en la página 14
CONTROL BOX 1 2 3 4 ASSEMBLY 9 5 6 7 WARNING: Improper installation, adjustment, alteration, service or HOT maintenance can cause property damage, injury or death. Read the installation, operating and maintenance CHAUD instructions thoroughly before installing or servicing this equipment. 8 AVERTISSEMENT: Une mauvaise installation, un réglage inadapté ou un manque d'entretien peuvent occasionner des dommages matériels ou corporels. Il est donc indispensable de lire attent
Resumen del contenido incluido en la página 15
COMPONENT PLATE ASSEMBLIES ITEM PART DESCRIPTION QTY. NO. NO. M MA AN NU UA AL L T TIIL LT T 5 13 1. SK00411 COMPONENT PLATE WELDMENT .1 7 2 2. SK2475500 RELAY . . . . . . . . . . . . . . . . . . . . . . . .1 4 3. SK2475600 HOLDER . . . . . . . . . . . . . . . . . . . . . .1 3 4. SK2475700 SPRING . . . . . . . . . . . . . . . . . . . . . .1 1 5. KE50750-7 CONTACTOR . . . . . . . . . . . . . . . . . .2 7. KE54833-4 SNAP-IN BUSHING . . . . . . . . . . . . .1 11. F904 6-32 X 5/8 . . . . . .
Resumen del contenido incluido en la página 16
23 24 25 26 FRAME / LID ASSEMBLY 2 19 20 21 22 1 4 18 9 5 10 11 17 OPEN END OF SPRING TO BE 6 LOCATED ON TOP 7 APPLY REMOVABLE 8 LOCKTITE 13 12 27 ITEM NO. PART NO. DESCRIPTION QTY. 1. SK00392-1 FRAME WELDMENT (30 GALLON) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 SK00392-3 FRAME WELDMENT (40 GALLON) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 2. SK2457192 LID ASSEMBLY (30 GALLON) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Resumen del contenido incluido en la página 17
2" TANGENT DRAW-OFF VALVE 7 6 5 4 3 2 1 ITEM NO. PART NO. DESCRIPTION QTY. 1. - 7. KE50972-B DRAW-OFF ASSEMBLY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 1. FA95049 WING NUT . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 2. KE527551 KNOB . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 3. KE52754 HEX NUT . . . . . . . . . .
Resumen del contenido incluido en la página 18
MAINTENANCE WARNING: Any maintenance or service involving disassembly of components should be made by a qualified service technician. Ensure electrical ! and water supply (if applicable) to the unit are shut off. HINGE ADJUSTMENT INSTRUCTIONS 1. 3. FULLY LIFT COVER WHEN PROPERLY TO RELEASE SPRING ADJUSTED, COVER TENSION SHOULD REST AT 70˚ 2. SPRING USING A 7/16" DEEP SOCKET ADJUST LEFT AND RIGHT BOLTS EVENLY LUBRICATION PROCEDURE Lubricate the following parts every three months
Resumen del contenido incluido en la página 19
11. With the Tilt switch in the Down position SEQUENCE OF OPERATIONS ■ 120 VAC is sent to the Bridge Rectifier When using these instructions refer to the SEL-TI wiring ❏ 115 DC is sent from the rectifier through the schematic. 30-ohm resistor to the normally open RY 10 1. Supply Voltage is sent to the primary of the 120 and RY 11 relay contacts. VAC transformer. ■ 120 VAC is sent to the RY11 relay coil. 2. Supply voltage is sent to the normally open con- ■ The normally open RY 11 contact close a
Resumen del contenido incluido en la página 20
SPARE PARTS LIST PART NO. DESCRIPTION QTY. H HE EA AT TIIN NG G E EL LE EM ME EN NT TS S . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 30 GALLON SK50845-1 ELEMENT, 2.00 KW, 480 VAC SK50845-2 ELEMENT, 2.67 KW, 416 VAC SK50845-3 ELEMENT, 2.00 KW, 416 VAC SK50845-4 ELEMENT, 2.67 KW, 240 VAC ELEMENT, 2.00 KW, 208 VAC SK50845-5 ELEMENT, 2.00 KW, 240 VAC SK50845-6 ELEMENT, 2.67 KW, 208
