Manual de instrucciones de Harbor Freight Tools 40544

Resumen del contenido incluido en la página 1

PORTABLE GARAGE
CAR CANOPY
40544
ASSEMBLY INSTRUCTIONS
®
3491 Mission Oaks Blvd., Camarillo, CA 93011
© ®
Copyright 1999 by Harbor Freight Tools . All rights reserved. No portion of this
manual or any artwork contained herein may be reproduced in any shape or form
without the express written consent of Harbor Freight Tools.
For technical questions and replacement parts, please call 1-800-444-3353.
Cover Page Rev 12/04

Resumen del contenido incluido en la página 2

Save This Manual You will need the manual for the safety warnings and precautions, assembly instructions, operating and maintenance procedures, parts list and diagram. Keep your invoice with this manual. Write the invoice number on the inside of the front cover. Keep the manual and invoice in a safe and dry place for future reference. Safety Warnings and Precautions WARNING: When using product, basic safety precautions should always be fol- lowed to reduce the risk of personal injury and dama

Resumen del contenido incluido en la página 3

11. Replacement parts. When servicing, use only identical replacement parts. Use of any other parts will void the warranty. 12. Do not assemble if under the influence of alcohol or drugs. Read warning labels on prescriptions to determine if your judgment or reflexes are impaired while taking drugs. If there is any doubt, do not assemble the product. 13. Heavy, wet snow or extremely windy conditions could damage the Car Canopy. It is recommended that the Tarp be removed under these conditions

Resumen del contenido incluido en la página 4

2. Connect 3-way and 4-way Tube Fittings (2 and 3) as shown below. At each junction, there is a hole through the side of the Fitting that lines up with the hole in the side of the Tube. Line up these holes on the inside of the structure and insert Self-tapping Screws (8), but tighten them only slightly at this time. 3. Drape Tarp (7) over assembled frame and secure the corners (first) onto the frame using the Ball Tie Downs (4) as shown in 4A, B, and C, below. 4. Once the corner

Resumen del contenido incluido en la página 5

6. Insert the Metal Base (5) onto each vertical leg. 7. Secure each Metal Base to the ground using the T-Stakes (6). Tighten all Self-tapping Screws (8) securely. Maintenance 1. Periodically clean Tarp using mild soap and water. 2. Periodically disassemble and apply a light oil to the Steel Tubes to prevent rusting. Parts List In tem #Dy escriptio Qt 1sS5 teel Pipe 2 2g36 -way Pipe Fittin 3g46 -way Pipe Fittin 4nB8 all Tie Dow 4 5eM8 etal Bas 6sT6 -stake 1 7pT1 ar 8wS2 elf-tapping Scre 4 PLEASE