Resumen del contenido incluido en la página 1
Resumen del contenido incluido en la página 2
This manual covers operation and maintenance of the F200 tiller. All information in this publication is based on the latest product information available at the time of approval for printing. Honda Motor Co., Ltd. reserves the right to make changes at any time without notice and without incurring any obligation. The manual should be considered a permanent part of the tiller and remain with the tiller when sold. Read the manual carefully. Pay special attention to statements preceded by the fo
Resumen del contenido incluido en la página 3
IMPORTANT NOTICE I This tiller is not equipped with a spark arrester. Operation on forest, bush or grass covered land may be illegal in some states. Check local laws and regulations before operation.
Resumen del contenido incluido en la página 4
CONTENTS ...... . 4 SAFE OPERATION . . . . . . . . . ....................... ....... COMPONENT IDENTIFICATION ....................... ....... ...... . 5 OPERATION . . . . . . . . . . . . . . ....................... ....... ...... . 7 ....................... ....... ...... 17 MAINTENANCE . . . . . . . . . . . TRANSPORTING/STORAGE . . ....................... ....... ...... 24 SPECIFICATIONS . . . . . . . . . . ....................... ....... ...... 27 3
Resumen del contenido incluido en la página 5
SAFE OPERATION B To ensure safe operation l Wear suitable clothing and shoes while using the l Never permit anyone to operate the tiller with- tiller. out proper instruction. l Whenever carrying the tiller, make sure to stop l Know how to stop the tiller quickly and under- the engine; or the rotor may turn even if the stand the operation of all the controls - READ THIS OWNER’S MANUAL CAREFULLY. clutch is disengaged. l Keep children and pets at a safe distance when tilling. l Clear t
Resumen del contenido incluido en la página 6
COMPONENT IDENTIFICATION 1. Fuel tank cap 2. Fuel valve 3. Air cleaner 4. Muffler 5. Throttle lever 6. Front wheel 7. Engine switch
Resumen del contenido incluido en la página 7
1. Clutch lever 2. Recoil starter 3. Spark plug 4. Drag bar 5. Mission oil level check bolt 6. Mission oil filler cap 7. Engine oil filler cap 8. Engine oil drain bolt 9. Rotor 6
Resumen del contenido incluido en la página 8
OPERATION Pre-Operation Check Always check the following before using the tiller: (A) Engine oil level (B) Transmission oil level. (C) Air cleaner condition. (D) Fuel level. A. ENGINE OIL LEVEL CAUTION: Engine oil is a major factor affecting engine performance and service life. Non-detergent or vegetable oils are not recommended. 7
Resumen del contenido incluido en la página 9
Other viscosities shown in the chart below may be Oil Recommendation used when the average temperature in your area is Use Honda 4-stroke oil or an equivalent. within the indicated range. Use only high detergent, premium quality motor oil With the tiller on a level surface, remove the oil certified to meet or exceed US automobile manufac- filler cap and check the oil level. turer’s requirements for Service Classification SE, in If the level is low, fill to the upper level with the the
Resumen del contenido incluido en la página 10
B. TRANSMISSION OIL LEVEL With the tiller on a level surface remove the oil level check bolt and check if the oil flows out of the bolt hole. If the oil level is low, reffi with the recommended oil till it flows out of the bolt hole. (1) Oil level check bolt (2) Oil filler cap C. AIR CLEANER CONDITION Remove the cover and inspect the elements, clean them if necessary (see p. 19). (3) Air cleaner cover (4) Air cleaner elements 9
Resumen del contenido incluido en la página 11
E. FUEL Use any automotive gasoline with a research octane ( y) of 86 or of 91 or higher or a pump octane higher. l Gasoline is extremely flammable and explosive under certain conditions. Refuel in a well venti- lated area with the engine stopped. Do not smoke or allow flames or sparks in the area where the tiller is refueled or stored. l Never fill the tank above the level. (1) Fuel filler holk CAUTION: Gasoline substitutes are not recommend- ed, they may be harmful to the fuel sys
Resumen del contenido incluido en la página 12
Starting the Engine - l Exhaust contains poisonous carbon monoxide gas. Never run the engine in a green house or confined area. Be sure to provide adequate ventilation. l The muffler becomes very hot during operaton, and it remains hot for a time after the engine is turned of5 Avoid touching a hot muffler. l Keep away from rotating parts while the engine is running. (1) Fuel valve (2) ON 1. Turn the fuel valve ON. 2. Turn the engine switch to ON. (3) Engine switch
Resumen del contenido incluido en la página 13
3. Move the choke lever to CLOSE, when the out- side temperature is low or the engine is cold. I (1) Choke lever (2) CLOSE 4. Move the throttle lever about 30 degrees from the extreme right (idle position). (3) Throttle lever 12
Resumen del contenido incluido en la página 14
NOTE: The clutch is engaged by pulling in the clutch lever and disengaged by releasing the lever. (1) Clutch lever (2) Engaged (3) Disengaged 5. Make sure the clutch is disengaged, then pull the starter rope briskly to start the engine. CAUTION : l Be sure the clutch is disengaged to prevent sudden uncontrolled movement when the engine starts. l Release the starter rope gradually. Allowing it to snap back can damage the mechanism. (4) Starter
Resumen del contenido incluido en la página 15
6. Allow the enigne to warm up, then move the choke lever to OPEN. (1) OPEN 7. Move the throttle lever to the left as desired to increase engine speed. 14
Resumen del contenido incluido en la página 16
Stopping the Engine 1. Disengage the clutch (release the lever). 2. Move the throttle lever to the extreme right. (1) Throttle lever 3. Turn the engine switch OFF to stop the engine. (2) Engine switch (3) OFF 4. Turn the fuel valve OFF. NOTE: To stop the engine in an emergency, dis- engage the clutch and turn the engine switch OFF. (4) Fuel valve
Resumen del contenido incluido en la página 17
Handlebar Height Adjustment CAUTION: Before adjusting the handlebar, place the tiller on jim level ground to prevent the handle from falling accidentally. To adjust the handlebar height, loosen the adjuster, select the appropriate holes and tighten the adjuster. (1) Handle height adjuster Tilling depth adjustment The tilling depth adjustment can be made by remov- ing retainer and sliding drag bar up or down as necessary. 0 , (2) Drag bar (3) Retainer 16
Resumen del contenido incluido en la página 18
MAINTENANCE Regular Service Period r lrsr I.. f Initial ” m Shut off the engine indicated month or Before pi A- before performing any maintenance. operation interval. whichever CAUTION: To maintain the safety operation operation operation operation and rt%izbility of your HONDA tiller Engine oil Check level 1 do not mod@ the tiller. Use only genuine HONDA parts or their equivalent when servicing or repair- Air cleaner eleme ing. MAINTENANCE GUIDE Periodic inspection and adjus
Resumen del contenido incluido en la página 19
Engine Oil Change NOTE: Change the oil when the engine is warm to assure rapid and complete draining. 1. Remove the oil drain bolt and the filler cap to drain. 2. Reinstall the drain bolt and fill the crankcase to the upper level with the recommended oil. 3. Reinstall and tighten the filler cap. Oil capacity: 0.45 R (0.95 US pt) (1) Oil filler cap (2) Oil drain bolt (3) Upper level (4) Lower level 18
Resumen del contenido incluido en la página 20
Air Cleaner Service A dirty air cleaner will restrict air flow to the carburetor. To prevent carburetor malfunction, service the air cleaner frequently. 1. Remove the screws and air cleaner cover. Remove the elements and separate them. 2. Wash the foam element in liquid detergent and water and flush until water is clear. Dry it thoroughly by applying compressed air. After drying, soak in oil and squeeze out the excess. 3. Remove dust from paper element by applying compressed air or t
