Resumen del contenido incluido en la página 1
™
Adhancer
™
BR 800S TRIO EDS
Instructions for Use
Advance Models: 56316025 (R28-C), 56316026 (R32-C)
Nilfi sk Model: 56316038 (BR 800S TRIO EDS)
A-English
B-Español
7/06 revised 2/07 Form No. 56041647
Resumen del contenido incluido en la página 2
A-2 / ENGLISH TABLE OF CONTENTS page Introduction ........................................................................................... A-2 Cautions and Warnings ........................................................................ A-3 Consignes de prudence et de sécurité ................................................. A-4 Know Your Machine .............................................................................. A-5 Control Panel ................................................
Resumen del contenido incluido en la página 3
ENGLISH / A-3 CAUTIONS AND WARNINGS SYMBOLS Nilfi sk-Advance uses the symbols below to signal potentially dangerous conditions. Always read this information carefully and take the necessary steps to protect personnel and property. DANGER! Is used to warn of immediate hazards that will cause severe personal injury or death. WARNING! Is used to call attention to a situation that could cause severe personal injury. CAUTION! Is used to call attention to a situation that could cause minor persona
Resumen del contenido incluido en la página 4
A-4 / ENGLISH CONSIGNES DE PRUDENCE ET DE SÉCURITÉ SYMBOLES Les symboles reproduits ci-dessous sont utilisés pour attirer l’attention de l’opérateur sur des situations dangereuses. Il est donc conseillé de lire attentivement ces indications et de prendre les mesures adéquates en vue de protéger le personnel et le matériel. DANGER! Ce symbole est utilisé pour mettre l’opérateur en garde contre les risques immédiats pouvant provoquer des dommages corporels graves, voire entraîner la mort. ATTE
Resumen del contenido incluido en la página 5
ENGLISH / A-5 KNOW YOUR MACHINE As you read this manual, you will occasionally run across a bold number or letter in parentheses - example: (2). These numbers refer to an item shown on these pages unless otherwise noted. Refer back to these pages whenever necessary to pinpoint the location of an item mentioned in the text. NOTE: Refer to the service manual for detailed explanations of each item illustrated on the next 2 pages. 1 Recovery Tank Cover 16 Battery Compartment (under seat) 2 Sol
Resumen del contenido incluido en la página 6
A-6 / ENGLISH CONTROL PANEL A Scrub OFF Indicator B Scrub OFF Switch C Scrub Pressure Decrease Indicator D Scrub Pressure Decrease Switch E Scrub Pressure Increase Indicator F Scrub Pressure Increase Switch G Scrub Pressure / Hourmeter Display H Speed Select Switch I Wand Switch J Key Switch K Battery Condition Indicator L Battery Green Indicator M Battery Yellow Indicator N Battery Red Indicator O Vacuum Switch P Horn Switch Q Solution Switch F D B C E A Q G O P I H J K M N L ™ ™ A-6 - 56041
Resumen del contenido incluido en la página 7
ENGLISH / A-7 DESCRIPTION OF THE BATTERY CONDITION INDICATORS The battery condition indicator (K) consists of three lights, a green (L), a yellow (M), and a red (N). The voltage indication will change based on the cutoff level (standard or alternate) selected in the control unit. The battery voltage ranges for the various indications are listed below: Standard Alternate Green 34.00+ 34.50+ Green & Yellow 33.00-33.99 34.00-34.49 Yellow 32.00-32.99 33.50-33.99 Yellow & Red 31.50-31.99 33.00-33.
Resumen del contenido incluido en la página 8
A-8 / ENGLISH INSTALL THE BRUSHES CAUTION ! Turn the key switch off (O) and remove the key, before changing the brushes, and before opening any access panels. 1 Make sure the Key Switch (J) is off (O). See Figure 2. To access the brushes, remove both side skirt assemblies. Note: The skirts are held in place by a two large Knobs, loosen these knobs and slide the skirt assemblies off of the Scrub Deck. 2 Loosen the black knobs (one on each side) on top of the idler assemblies and remove the i
Resumen del contenido incluido en la página 9
ENGLISH / A-9 INSTALL THE SQUEEGEE 1 Make sure the Squeegee (19) is up (O) and the Key Switch (J) is off (O). Hold the squeegee tool so that the curved ends point forward, then slide the squeegee tool onto the Mount (A) (see Figure 3). 2 Hand tighten the Thumb Nuts (B) and then connect the vacuum hose to the Squeegee Tube (C) (vacuum hose should loop to the right). FILL THE SOLUTION TANK Read the cleaning chemical label and fi gure the proper amount of chemical to mix for a tank that holds 30 U
Resumen del contenido incluido en la página 10
A-10 / ENGLISH DETERGENT SYSTEM PREPARATION AND USE COMMON INSTRUCTIONS: REFILLABLE CARTRIDGE SPECIFIC INSTRUCTIONS: The system should be purged of previous detergent when switching to a different Fill the detergent cartridge with a maximum of 1.25 gallons (4.73 Liters) detergent. SERVICE NOTE: Move machine over fl oor drain before purging because a of detergent. SERVICE NOTE: Remove the detergent cartridge from the small amount of detergent will be dispensed in the process. detergent box
Resumen del contenido incluido en la página 11
ENGLISH / A-11 DETERGENT SYSTEM PREPARATION AND USE ™ ™ revised 2/07 Adhancer R28-C, R32-C / BR 800S TRIO EDS - 56041647 - A-11
Resumen del contenido incluido en la página 12
A-12 / ENGLISH OPERATING THE MACHINE WARNING! Be sure you understand the operator controls and their functions. While on ramps or inclines, avoid sudden stops when loaded. Avoid abrupt sharp turns. Use low speed down hills. Clean only while ascending (driving up) the ramp. To Scrub... Follow the instructions in preparing the machine for use section of this manual. 1 While seated on the machine, adjust the seat and steering wheel to a comfortable operating position using the adjustment contr
Resumen del contenido incluido en la página 13
ENGLISH / A-13 AFTER USE 1 When fi nished scrubbing, press the Scrub Off Switch (B) twice, this will automatically raise, retract and stop all the machine systems (brush, squeegee, vacuum, solution and detergent (AXP/EDS models)). Then drive the machine to a service area for daily maintenance and review of other needed service up keep. 2 To empty the solution tank, remove the Solution Drain Hose (4) from its storage clamp. Direct the hose to a designated “DISPOSAL SITE” and remove the plug.
Resumen del contenido incluido en la página 14
A-14 / ENGLISH CHARGING THE BATTERIES Charge the batteries each time the machine is used, or whenever the Battery Condition Meter (K) is showing a yellow, red or fl ashing red indicator light(s). WARNING ! Do not fi ll the batteries before charging. Only charge batteries in a well-ventilated area. Do not smoke while servicing the batteries. When Servicing Batteries... • Remove all jewelry. • Do not smoke. • Wear safety glasses, a rubber apron and rubber gloves. • Work in a well-ventilated area. •
Resumen del contenido incluido en la página 15
ENGLISH / A-15 SQUEEGEE MAINTENANCE If the squeegee leaves narrow streaks or water, the blades may be dirty or damaged. Remove the squeegee, rinse it under warm water and inspect the blades. Reverse or replace the blades if they are cut, torn, wavy or worn. To Reverse or Replace the Rear Squeegee Wiping Blade... 1 See Figure 4. Raise the squeegee tool off the fl oor, then unsnap the Center Latch (A) on the squeegee tool. 2 Remove the Tension Straps (B). 3 Slip the rear blade off the alignment
Resumen del contenido incluido en la página 16
A-16 / ENGLISH SIDE SKIRT MAINTENANCE The side skirts’ function is to channel the waste water to the squeegee, helping contain the water within the machines cleaning path. During normal use the blades will wear in time. The operator will notice a small amount of water leaking out underneath the side skirts. A height adjustment can easily be made to lower the blades so that all the water can be picked up by the squeegee. To replace the scrub system side skirt(s) ... 1 See Figure 5. Loosen t
Resumen del contenido incluido en la página 17
ENGLISH / A-17 GENERAL MACHINE TROUBLESHOOTING Problem Possible Cause Remedy Poor water pick-up Worn or torn squeegee blades Reverse or replace Adjust so blades touch fl oor evenly Squeegee out of adjustment across entire width Recovery tank full Empty recovery tank Recovery tank drain hose leak Secure drain hose cap or replace Recovery tank cover gasket leak Replace gasket / Seat cover properly Debris caught in squeegee Clean squeegee tool Vacuum hose clogged Remove debris Using too much solutio
Resumen del contenido incluido en la página 18
A-18 / ENGLISH TECHNICAL SPECIFICATIONS (as installed and tested on the unit) ™ ™ ™ Model Adhancer R28-C Adhancer R32-C BR 800S TRIO EDS Model No. 56316025 56316026 56316038 Voltage, Batteries V 36V 36V 36V Battery Capacity Ah 305 305 305 Protection Grade IEC 65 IPX3 IPX3 IPX3 Sound Pressure Level LpA ISO 11201 dB(A)/20 μPa 77.8 77.8 77.8 Sound Pressure Uncertainty KpA ISO 11201 dB(A)/20 μPa 2.5 2.5 2.5 Sound Power Level LwA ISO 3744 dB(A)/20 μPa 85.7 85.7 85.7 Sound Power Uncertainty KwA ISO 37
Resumen del contenido incluido en la página 19
Resumen del contenido incluido en la página 20
B-2 / ESPAÑOL ÍNDICE página Introducción .......................................................................................... B-2 Precauciones y advertencias ................................................................ B-3 Conozca su máquina ............................................................................ B-4 Panel de control .................................................................................... B-5 Preparación de la máquina para el uso Instalación de las bat
