Manual de instrucciones de APC SMT 3000 VA

Resumen del contenido incluido en la página 1

Installation Guide SMT 2200/3000 VA
Input/Output Hardwire Kit
Safety
Adhere to all national and local electrical codes. A certified electrician must perform all electrical
connections.
1. Disconnect equipment connected to the UPS.
2. Press the OFF button located on the front of the UPS.
3. Disconnect the batteries in the UPS.
4. Disconnect the UPS from utility power.
NOTE: When removing the panels from the UPS, note which cable is connected to the AC input. There are two
4-pin connectors on t

Resumen del contenido incluido en la página 2

Installation Note: It is recommended that the input and output cables be connected to the terminal block prior to installing the terminal block in the UPS. Remove the five screws that secure the factory installed PDU panels to the UPS. Save the screws. Disconnect the PDU input and output cables as shown in the diagram. AC Input Connector Secure the replacement input and output panels (supplied), to the UPS. Secure the panels with four of the screws removed from the factory installed PDU pa

Resumen del contenido incluido en la página 3

Secure the terminal block and label to the UPS with two screws (supplied), as shown in the diagram. Refer to the diagram below. Use the screws supplied. Connect the ground wires with the grounding screws. Connect the input and output cables. Primary Ground Green Wire Input Line1 Hot Ground Input Line2 or Neutral Output Line2 Output Line1 or Neutral Hardwire Kit SMT2200/3000 VA 100/120/230 VAC Tower 3 su0672a su0671a

Resumen del contenido incluido en la página 4

Connect the terminal block and UPS connectors as shown in the diagram. NOTE: The two pin connector will not be utilized with the replacement input and output panels. AC Input Connector AC Input Connectors Secure the blank panel to the UPS with three screws (supplied). APC Worldwide Customer Support Customer support for this or any other APC product is available at no charge in any of the following ways: • Visit the APC Web site to access documents in the APC Knowledge Base and to submit custom

Resumen del contenido incluido en la página 5

Customer support and warranty information is available at the APC Web site, www.apc.com. © 2011 APC by Schneider Electric. APC, the APC logo, and Smart-UPS are owned by Schneider Electric Industries S.A.S., American Power Conversion Corporation, or their affiliated companies. 990-3933 All other trademarks are property of their respective owners. 6/2011