Manual de instrucciones de Event electronic PS6

Resumen del contenido incluido en la página 1

Your warranty will be in effect when you send in your warranty card
Event, Event Electronics and PS Project Studio are trademarks of Event Electronics, LLC.
Specifications subject to change without notice
© 1996, 1997, 1998, 1999 Event Electronics, LLC Printed in USA 9/99 1715A
Event Electronics, LLC
P.O. Box 4189
Santa Barbara, CA 93140-4189
Voice: (805) 566-7777
INTRODUCTION …………………….……….………….…………….……
Fax: (805) 566-7771
1
Web: www.event1.com
UNPACKING ……..……

Resumen del contenido incluido en la página 2

LF Driver: PS5: 5 ¼”; PS6: 6½”; PS8: 8" magnetically shielded mineral Our engineers have spent years designing transducers, studio filled polypropylene cone with high temperature voice coil electronics and high performance studio monitoring systems, including some of and damped rubber surround. the most popular professional speakers used today. Now, using the latest in HF Driver: 1" magnetically shielded natural silk dome with ferrofluid digital acoustic design tools, along with high performan

Resumen del contenido incluido en la página 3

with a durable vinyl laminate that can be cleaned with a soft damp cloth. Avoid either speaker. This is the common “equal length triangle” rule for speaker touching the exposed speaker elements. Do not expose the rear panel controls, placement shown in Figure 1. connectors, or the speaker elements to moisture or chemicals. The AC mains fuse is internal and serviceable by a qualified technician. It will only open if there is another problem. Mix at reasonable levels to protect your speakers an

Resumen del contenido incluido en la página 4

balanced or unbalanced. The LINE 2 INPUT connector is hardwired in parallel with the LINE 1 INPUT connector, so either may be used as an input or a pass-through connection. Input specifications apply to both inputs. 3 1 LINE 1 INPUT This jack accepts a ¼” TRS connector, wired either balanced or unbalanced. For balanced wiring, a 3-conductor ¼" TRS plug is necessary. See the INPUT CONNECTIONS wiring chart below or on the amplifier panel. Unbalanced wiring works with either a 2 or 3-conductor ¼

Resumen del contenido incluido en la página 5

FIGURE 2. REAR PANEL 4