Résumé du contenu de la page N° 1
WV-CW964 Cover(中とじ) 05.10.18 11:12 AM ページ2
Color CCTV Camera
Operating Instructions
Model No. WV-CW964
Before attempting to connect or operate this product,
please read these instructions carefully and save this manual for future use.
Résumé du contenu de la page N° 2
WV-CW964 Cover(中とじ) 05.10.18 11:12 AM ページ3 ENGLISH VERSION For U.S.A NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This CAUTION equipment generates, uses, and can radiate radio frequency RISK OF ELECTRIC SHOCK energy and, if not installed and used in ac
Résumé du contenu de la page N° 3
WV-CW964 05.10.18 11:09 AM ページ3 IMPORTANT SAFETY INSTRUCTIONS 1) Read these instructions. 2) Keep these instructions. 3) Heed all warnings. 4) Follow all instructions. 5) Do not use this apparatus near water. 6) Clean only with dry cloth. 7) Do not block any ventilation openings. Install in accordance with the manufacturer's instructions. 8) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 9) Do not d
Résumé du contenu de la page N° 4
WV-CW964 05.10.18 11:09 AM ページ4 LIMITATION OF LIABILITY THIS PUBLICATION IS PROVIDED “AS IS” WITHOUT THIS PUBLICATION COULD INCLUDE TECHNICAL WARRANTY OF ANY KIND, EITHER EXPRESS OR INACCURACIES OR TYPOGRAPHICAL ERRORS. IMPLIED, INCLUDING BUT NOT LIMITED TO, THE CHANGES ARE ADDED TO THE INFORMATION IMPLIED WARRANTIES OF MERCHANTABILITY, HEREIN, AT ANY TIME, FOR THE IMPROVEMENTS OF FITNESS FOR ANY PARTICULAR PURPOSE, OR NON- THIS PUBLICATION AND/OR THE CORRESPONDING INFRINGEMENT OF THE THIRD
Résumé du contenu de la page N° 5
WV-CW964 05.10.18 11:09 AM ページ5 FEATURES This Color CCTV Camera is a video surveillance device ■ Privacy Zone Function that incorporates a 1/4-type {1/4"} CCD, a 30x zoom The privacy zone function can mask specific areas of lens, preset and pan and tilt capabilities in a dome the scene from view. configuration. ■ Patrol Function 3 3 3 3 ■ Super Dynamic (SUPER-D ) The patrol function can store manual camera move- SUPER-D 3 can capture clear images of subjects ment routines for automatic pl
Résumé du contenu de la page N° 6
WV-CW964 05.10.18 11:09 AM ページ6 PRECAUTIONS 1. Do not attempt to disassemble the camera. 10.Do not operate the camera beyond the specified To prevent electric shock, do not remove screws or temperature, humidity or power source ratings. covers. Do not use the camera in an extreme environment There are no user-serviceable parts inside. where high temperature or high humidity exists. Do Ask qualified service personnel for servicing. not place the camera near heat sources such as radiators, sto
Résumé du contenu de la page N° 7
WV-CW964 05.10.18 11:09 AM ページ7 OPERATING PRECAUTIONS ■ The camera does not have a power switch. ■ Do not point the camera at a strong light source. Intense light such as that produced by a spotlight ■ What to do if OVER HEAT appears on the display. concentrated on one part of the screen can cause This message indicates that the inside of the camera blooming (rainbow around the strong light) or smearing has become extremely hot. (vertical stripes above and below the strong light). Immedi
Résumé du contenu de la page N° 8
WV-CW964 05.10.18 11:09 AM ページ8 ■ Downloading (saving) or uploading (recovering) camera setting information Camera setting information that can be downloaded to the system controller etc, includes existing preset position settings and menu settings. However, the following items are not included. • Patrol function (page 35) • Area title function (page 37) • Blemish compensation pattern (page 42) • RS485 settings (page 21) • Password settings (page 45) Be sure the camera is not moving and
Résumé du contenu de la page N° 9
WV-CW964 05.10.19 4:36 PM ページ9 CONTENTS IMPORTANT SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 LIMITATION OF LIABILITY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 DISCLAIMER OF WARRANTY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 FEATURES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Résumé du contenu de la page N° 10
WV-CW964 05.10.20 10:39 AM ページ10 CONSTRUCTION Alarm Input Connector Alarm Output Connector Video Output Connector Data Port Camera Safety Wire Power Cord for Heater Power Connector Attachment Pipe Upper Base Rear sun shield (provided) Front sun shield (provided) Sun shield (pre-attached at factory) Dome cover (do not remove) Lens The lens cannot replaced. Ensuring Trouble-free Operation • This camera uses a “slip ring” for transmission of electrical power and signals. A dirty slip ring c
Résumé du contenu de la page N° 11
WV-CW964 05.10.19 5:26 PM ページ11 INSTALLATION PRECAUTIONS Warning: • Near an air conditioner outlet or any areas subject to • Select a place that is strong enough for the sudden changes in temperature. (Such conditions installation. If you install the camera on a ceiling or can cause clouding and condensation formation on wall, except for accidents caused by fault in the the dome cover.) camera, Panasonic holds absolutely no ■ Wiring power to the camera responsibility for accidents caused b
Résumé du contenu de la page N° 12
WV-CW964 05.10.18 11:09 AM ページ12 ■ About effects on image quality The camera does not have a wiper. If the camera is installed in the following conditions image quality may deteriorate or the image may be invisible. (1) In the rain The picture may be hard to see if the wind blows rain onto the dome cover while it is raining. (2) In the snow When it snows, snow may collect on the dome cover and block some of the picture. (The amount of snow that collects on the dome cover depends on the qua
Résumé du contenu de la page N° 13
ON 1 2 3 4 5 6 7 8 DIP SW1 SW1 START AC100V AC100V専用 専用 RS485Setting WV-CW964 05.10.18 11:09 AM ページ13 DIP SWITCH SETTINGS In a configuration, the camera's RS485 data port is used for camera control by the system controller, the camera's DIP switches must be configured to specify the unit number and communication parameters. You need to set the DIP switches before installing the camera in the ceiling or on a wall. 1. Attaching and removing the Upper Base 3. Set the DIP switches as the fol
Résumé du contenu de la page N° 14
WV-CW964 05.10.18 11:09 AM ページ14 ■ Unit Number (DIP Switch 1) The factory default settings of these DIP switches are all OFF. (Coaxial Multiplex System) Unit Unit Unit DIP Switch 1 DIP Switch 1 DIP Switch 1 Number Number Number ON ON ON 1 ~ 96 * 23 46 1234 5678 1234 5678 1234 5678 ON ON ON 1 24 47 1234 5678 1234 5678 1234 5678 ON ON ON 2 25 48 1234 5678 1234 5678 1234 5678 ON ON ON 3 26 49 1234 5678 1234 5678 1234 5678 ON ON ON 4 27 50 1234 5678 1234 5678 1234 5678 ON ON ON 5 28 51 1234 5
Résumé du contenu de la page N° 15
WV-CW964 05.10.18 11:09 AM ページ15 Unit Unit Unit DIP Switch 1 DIP Switch 1 DIP Switch 1 Number Number Number ON ON ON 69 78 87 1234 5678 1234 5678 1234 5678 ON ON ON 70 79 88 1234 5678 1234 5678 1234 5678 ON ON ON 71 80 89 1234 5678 1234 5678 1234 5678 ON ON ON 72 81 90 1234 5678 1234 5678 1234 5678 ON ON ON 73 82 91 1234 5678 1234 5678 1234 5678 ON ON ON 74 83 92 1234 5678 1234 5678 1234 5678 ON ON ON 75 84 93 1234 5678 1234 5678 1234 5678 ON ON ON 76 85 94 1234 5678 1234 5678 1234 5678 ON
Résumé du contenu de la page N° 16
WV-CW964 05.10.19 4:36 PM ページ16 CAMERA INSTALLATION Precautions • Make sure that the place you are installing the camera is strong enough to support it. If it is not strong enough, then the camera may fall and hurt someone. • The following steps of installation and connection work should be done by qualified service personnel or system installers and should conform to all local codes. • Be sure to turn the power off before installation and connection. • Do not install the camera near the air
Résumé du contenu de la page N° 17
S TA RT WV-CW964 05.10.18 11:09 AM ページ17 3. Mounting the Bracket 4. Mounting the camera (1) Fix the bracket to the installation surface using (1) Aim the "START" arrow at the bent portion of the appropriate bolts, nuts or the like (not supplied). leaf spring. Bending Leaf Spring Attachment Pipe (2) Be sure to hook the fall prevention wire into the bracket. (2) Fix the attachment pipe to the bracket. (3) Thread cables through the bracket. Connect cables, referring to CONNECTIONS. Fall Prevent
Résumé du contenu de la page N° 18
WV-CW964 05.10.18 11:09 AM ページ18 3. Before clamping the sun shield, close the front and ■ Installing the brackets rear sun shields (first latch the hook on the wire Refer to the installation guides provided with the side, and then do the other side). brackets. * Take care that the camera safety wire does not go ■ Attach the brackets to the camera on the inside. 1. Put the waterproof caps (provided) onto the tops of the screws. Camera Safety wire Sun shield 4. Align the arrow ( ) on the r
Résumé du contenu de la page N° 19
WV-CW964 05.10.18 11:09 AM ページ19 CONNECTIONS Precautions • The following connections should be made by qualified service personnel or system installers in accordance with all local codes. • Turn off the power at the fuse box before starting the installation work, or it so could result in fire, electric shock, personal injury, and material damage. 24 V AC Cable for Heater Separate 2-wire 24 V AC Cable for camera 24 V AC RS485 Data Port Twisted Pair Cable*1 To Matrix Switcher, (RJ-12) e
Résumé du contenu de la page N° 20
WV-CW964 05.10.18 11:09 AM ページ20 How to Assemble the Cable with the Accessory Connector Strip back the cable jacket approx. 3 mm {0.1"} and separate the individual conductors. Approx. Approx. 3 mm {0.1"} 3 mm {0.1"} Wire Wire A Up Up Contact Contact Insert Insert the wire until A position Insert the wire until A position and clamp the contacts. and clamp the contacts. Prepare the individual conductors for clamping. Use MOLEX band tool part number 57027-5000 (for UL- Style Cable UL1015) or 57
