Résumé du contenu de la page N° 1
TFT-LCD TV
OWNER'S MANUAL
Please READ this manual carefully before
operating your TV, and retain it for future
reference.
MODELS :
HL26ATB
HL32ATB
Résumé du contenu de la page N° 2
CAUTION RISK ELECTRIC SHOCK DO NOT OPEN These servicing instructions are for use by qualified service personnel only. To reduce the risk of electric shock do not perform any servicing other than that contained in the operating instructions unless you are qualified to do so. Safety of operators has been taken into consideration at the design and manufacture phase, but inappropriate operation may cause electric shock or fire. To prevent the product from being damaged, the followin
Résumé du contenu de la page N° 3
IMPORTANT SAFETY INSTRUCTIONS Read all of the instructions before using this appliance. When using this appliance, always exercise basic safety precautions, including the following: 1) Read these instructions. 2) Keep these instructions. 3) Heed all warnings. 4) Follow all instructions. 5) Do not use this apparatus near water. 6) Clean only with dry cloth. 7) Do not block any ventilation openings. Install in accordance with the manufacturer`s instructions. 8) Do
Résumé du contenu de la page N° 4
SAVE THESE INSTRUCTIONS Thank you for using our Haier product. This easy-to-use manual will guide you in getting the best use of your product. Remember to record the model and serial number. They are on label in back of the unit. Model number serial number Date of purchase Staple your receipt to your manual. You will need it to obtain warranty service. Contents Warnin g . . . . . . . ... ... ... ... .. . . . . . . . . . . . . . . . . . . . . . . . Audio Menu Bass,Treble and Balance Setup...
Résumé du contenu de la page N° 5
Introduction Controls -This is a simplified representation of front panel. -Here shown may be somewhat different from your TV. Front panel controls HL26ATB HL32ATB INPUT 1 CH 2 VOL 3 MENU 4 5 1.INPUT: All input source display and OK confirm. 2.CH( ) Program minus and plus, menu options 3.VOL( ) Volume increase and decrease, menu reset and entry 4.MENU Menu display 5. POWER : Is used to activate the display or return to standby mode. Owner s Manual 5
Résumé du contenu de la page N° 6
Introduction Connection Options Back panel controls Antenna Input PC VIDEO Input Connect cable or PC/DVI AUDIO Input Connect the monitor antenna signals to connect the audio AV Input AUDIO output the TV, either directly output connector from from an external Earphone jack: Connects the video connect to or through your device. a PC to the jack and audio signal Earphone audio external cable box. from a video device. amplifier device. output terminal. YPbPr -L/R EARPHONE CVBS CVB
Résumé du contenu de la page N° 7
E X IT IN F O A R C NPUT Introduction Universal Remote Controller - The remote controller cannot be operated unless the batteries are properly loaded. - When using the remote control, aim it at the remote control sensor on the TV. TV DVD VCR SETBOX CABLE AUDIO Function introduction Press the SELECT button repeatedly to select one of the system modes in which the remote control can be used. When the desired device is selected, the corresponding POWER LED lights on 5seconds. Turns your TV or an
Résumé du contenu de la page N° 8
EXIT INFO ARC NPUT Installation External Equipment Connections Accessories S E LECT CH.LIST FAV.LIST AUDIOLIST PIP SWAP AUDIOSWAPPOSITION P.MODE S.MODE CC FREEZE OK VOL+ CH+ VOL- CH- Q.VIEW Power cable Alkaline battery(AAA) 2 Remote controller Owner`s manual Antenna Connection Generally speaking, to enjoy a clearer picture, we recommend that you use a CATV system or an outdoor antenna .In different places, the suitable antenna type and position are different. Multi-family Dwellings/Apart
Résumé du contenu de la page N° 9
Installation External Equipment Connections NOTE: All cables shown are not included with the TV. Choose Your Connection There are several ways to connect your television, depending on the components you want to connect and the quality of the signal you want to achieve. The following are examples of some ways to connect your TV. Choose the connection which is best for you. VCR connection - To avoid picture noise (interference), leave an adequate distance between the VCR and TV Connection Opti
Résumé du contenu de la page N° 10
Installation External Equipment Connections External A/V Source Setup How to connect Connect the audio and video cables from the external equipment's output jacks to the TV input jacks, as shown in the figure. When connecting the TV to external equipment, match the YPbPr -L/R jack colors (Video = yellow, Audio Left = white, and Audio CVBS CVBS-L/R L/R EARPHONE Y S-VIDEO S-Video -L/R Pb Pr Audio Out Right = red). How to use 1. Select the input source with using the INPUT button on the re
Résumé du contenu de la page N° 11
Installation External Equipment Connections DTV connection - This TV can receive Digital Over-the-Air/Cable signals without an external digital set-top box. However, if you do receive Digital signals from a digital set-top box or other digital external device, refer to the figure as shown below. - This TV supports HDCP (High-bandwidth Digital Contents Protection) protocol for Digital Contents (480p,720p,1080i). How to connect Use the TV`s (Y, PB, PR) , VGA or HDMI jack for video connections,
Résumé du contenu de la page N° 12
Installation Cable sample HDMI Cable (not supplied with the product) HDMI to DVI Cable (not supplied with the product) Analog Audio Cable (Stereo to RCA type) (not supplied with the product) 12 TV LCD-TFT
Résumé du contenu de la page N° 13
Installation External Equipment Connections PC connection How to connect 1. To get the best picture quality, adjust the PC graphics card to 1024x768 . 2. Use the TV`s PC or DVI (Digital Visual Interface) port for video connections, depending on your PC connector. If the graphic card on the PC does not output analog and digital RGB simultaneously, connect only one of eitherVGA IN or DVI IN to display the PC on the TV. If the graphic card on the PC does output analog and digital RGB simult
Résumé du contenu de la page N° 14
Installation External Equipment Connections Connecting Headphones You can connect a set of headphones to your set if you wish to watch a TV programme without disturbing the other people in the room. Plug a set of headphones into the 3.5mm mini-jack socket on the rear panel of the set. L/R EARPHONE Audio Out Note Prolonged use of headphones at a high volume may damage your hearing. You will not receive sound from the speakers when you connect headphones to the system. Power Source AC Outlet
Résumé du contenu de la page N° 15
Operation Operation -In the manual, the OSD (on screen display) may be different from your TV`s, because it is just an example to help you with the TV operation. -There are several options you might need to set up in order for your TV to work properly. Read the instructions that follow. Switching On/Off the TV set 1. First, connect power cord correctly. 2. Select the viewing source by using INPUT button on the remote control. 3. When finished using the TV, press the POWER button on th
Résumé du contenu de la page N° 16
Operation Channel menu This TV set has two methods to set channels, which are respectively Scan Channel, Add Channel. In this section, how to use the remote control to set channel is explained. You can also use buttons on the TV set to set channel. Note Make sure you are in an open environment where there is a good signal while scanning so that it is able to find all channels more easily. Scan Channel - Automatically finds all channels available through antenna or cable inputs, and stores
Résumé du contenu de la page N° 17
Operation Channel menu Favorites You can create your own Favorite List. when a channel is highlighted and then you can add or delete the channel to/from the Favorite List. You can skip some channel; 1 Press the MENU button and then use / button to select the Channels menu. 2 Press the button and then use / button to select Favorites. 3 Press the button to call up favorites list menu. 4 Use / / / button to select option, and then use the OK button to conf
Résumé du contenu de la page N° 18
Operation Video menu The TV menu gives you an overview of the menus you can select. Note: Depending on the input signal, one or more menu items may not be selectable. 1 Press the MENU button and then use / button to select the Video menu. 2 Press the button and then use / button to select the desired items. 3 Press the button and then use / button to adjust the setting. 4 Press the OK button to confirm. 5 When you are satisfied with your choice, press MENU button to return
Résumé du contenu de la page N° 19
Operation Video menu Aspect Ratio Control - Lets you choose the way an analog picture with a 4:3 aspect ratio is displayed on your TV with a 16:9 ratio picture format. - Note: If a fixed image is displayed on the screen for a long time, it image may become imprinted on the screen and remain visible. 1 Press the MENU button and then use / button to select the Video menu. 2 Press the button and then use / button to select the Aspect Ratio. 3 Press the button and then use / butto
Résumé du contenu de la page N° 20
Operation Video menu Screen adjustment 1 Press the MENU button and then use / button to select the Video menu. 2 Press the button and then use / button to select the Screen Adjustment. 3 Press the button and then use / button to select option. 4 Press / button to adjust the setting and press OK button. 5 When you are satisfied with your choice, press or MENU button to return to the previous menu or press the EXIT button to return to TV viewing. Horizontal:
