Résumé du contenu de la page N° 1
Responder LC Model 20.7
Remote Start Keyless Entry
Owner’s Guide
© 2008 Directed Electronics, Vista, CA
G4702X 2008-08
Résumé du contenu de la page N° 2
Résumé du contenu de la page N° 3
Contents Government regulations .....................................................................................4 Warning! Safety first .........................................................................................5 What’s included ................................................................................................8 Important information ........................................................................................8 Your warranty.............................
Résumé du contenu de la page N° 4
Government regulations This device complies with Part 15 of FCC rules. Operation is subject to the fol- lowing two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesirable operation. This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection aga
Résumé du contenu de la page N° 5
Control Center To satisfy FCC RF exposure compliance requirements, the device and its antenna must maintain a separation distance of 20 cm or more from the person’s body, except for the hand and wrists, to satisfy RF exposure compliance. This device complies with the Industry Canada Radio Standards Specification RSS 210. Its use is authorized only on a no-interference, no-protection basis; in other words, this device must not be used if it is determined that it causes harm- ful interference
Résumé du contenu de la page N° 6
Warning! Safety first The following safety warnings must be observed at all times: Due to the complexity of this system, installation of this product must only be performed by an authorized Directed dealer. When properly installed, this system can start the vehicle via a command signal from the remote control transmitter. Therefore, never operate the system in an enclosed area or partially enclosed area without ventilation (such as a garage). When parking in an enclosed or partially enclosed
Résumé du contenu de la page N° 7
cy brake properly functions. Failure to do so can result in personal injury or prop- erty damage. We recommend the owner have the parking / emergency brake system inspected and adjusted by a qualified automotive shop bi-annually. Use of this product in a manner contrary to its intended mode of operation may result in property damage, personal injury, or death. (1) Never remotely start the vehicle with the vehicle in gear, and (2) Never remotely start the vehicle with the keys in the ignition
Résumé du contenu de la page N° 8
This product should not be installed in any convertible vehicles, soft or hard top with a manual transmission. Installation in such vehicles may pose certain risk. © 2008 Directed Electronics. All rights reserved. 8
Résumé du contenu de la page N° 9
What’s included • One five-button/2-way Supercode Responder LC Remote Control • One five-button/1-way Supercode companion remote • The control module • Control center with integrated status LED and Valet override switch • A remote start defeat toggle switch • Window decals • Your warranty registration Important information Congratulations on the purchase of your state-of-the-art remote start system. Due to the complexity of this system, it must be installed by an authorized dealer only. Instal
Résumé du contenu de la page N° 10
➤ Out of range notification If a command is issued from the remote, but the remote is beyond the range of the vehicle to receive the command, the remote will respond with an out-of range notification. If this occurs, the out-of-range icon displays on the LCD and the remote emits an error tones. Since conditions will vary in different areas (ie: Weather, RF interference, etc) range may be affected and require you to be closer to the vehicle for successful transmission. ➤ System maintenance
Résumé du contenu de la page N° 11
AUTO OFF DUAL SC OUTPUT ANTENNA AM/FM CD/AUX SAT RADIO SEEK SKIP Headunit bus cableSiriusConnect Cable HON-SC1 Honda Bus outline stops flashing and the remote becomes operational while still displaying Compatible Translator CHARGE. Sirius-Ready, SAT Radio Ready or select OEM headunits with optional Honda Bus Compatible Translator Warning! The temperature range over which the battery can be charged is 0ºC TO 45ºC (32ºF TO 113ºF). Charging the battery at temperatures outside this range may c
Résumé du contenu de la page N° 12
ALL ALL ➤ Multi-car control capability ALL You can use the Responder LC 2-way remote control system for two cars, with ALL full command capability for both vehicles. A U X To change the car to be operated: 1. Press/hold the button for 3 seconds or until the remote beeps. The car or flashes. The LC text area displays the current vehicle A U X selected. 2. Change Car: While in car selection mode, press and release the button. to scroll between car and . The car icon flashes to to
Résumé du contenu de la page N° 13
1 4 5 6 2 7 3 8 1 4 5 6 7 2 3 8 Responder LC 2-way 1 4 5 6 7 2 3 8 Feature Description 1 LCD (2-way) Activity/icon display 2 Lock button Press for one second to arm. 3 Unlock button Press for one second to disarm. 4 Auxiliary button Press and hold for 1.5 second to activate optional trunk release. 5 Remote start button Press for one second to activate remote start. 6 Function button Allows access to programming and modi- fies operation of the other buttons. 7 Charge Port (2-way) P
Résumé du contenu de la page N° 14
10 8 2 9 3 5 4 6 8 10 2 9 3 5 A U X 4 6 ➤ LC 1-way companion 10 8 2 3 5 4 9 6 See call out table for 2-way ➤ Transmitter configuration A U X A U X A U X A U X Direct Access Level x 1 x 2 x 3 x 4 Button Lock Silent Lock Unlock Silent Unlock Valet Mode Car Finder Remote Start Reset Timer Mode Smart Start Rear A U X Runtime Defogger A U X A U X Trunk Release AUX 1 AUX 2 AUX 3 A U A U X X Function Shift Cabin Runtime Temperature Check request (2-way only) (2-way only) © 2008 Di
Résumé du contenu de la page N° 15
Using the system Please note the screen shot to the right of a feature indicates what the display looks like when this feature is activated. Lock Command: Press one time to Lock Feedback: Lock Icon appears, and parking lights flash once. Notes: Press/hold for 1.5 seconds to Lock the A U X system and activate the panic feature. Details: The horn in the vehicle “honks” once. (if the op- tion is installed), and the parking lights flash one time. If the power door locks have been connec
Résumé du contenu de la page N° 16
Unlock Command: Press one time to Unlock Feedback: Unlock icon appears. A U X Notes: The vehicle horn, honks two-times and the parking lights flash two-times. The door locks (if connected) unlock, the 2-way remote beeps two-times and the LCD displays the icon. AUX A U X Unlocking without the honk (Silent Lock) Press the button on the remote once, and then press the button. The AUX system unlocks without the confirmation honk. The parking lights flash once. The 2-way remote displa
Résumé du contenu de la page N° 17
Points to remember: If the hood is open or if the brake pedal is pressed, the vehicle will not remote start. The remote start shuts down: • When the brake pedal is pressed. • The hood is opened. • When the remote start command is sent again from a remote control. • When the runtime expires. To drive your vehicle after it has been remote started: 1. Get in without stepping on the brake. 2. Insert the ignition key and turn it to the ON position. 3. Now, step on the brake. The remote control wi
Résumé du contenu de la page N° 18
A U X Aux Command: Press and hold for 1.5 seconds to acti- vate the Trunk Release. Feedback: The trunk icon appears and the remote plays a short tone. Notes: This is an optional feature. See your sales rep/installer for details. The factory default screen displays the trunk icon and text. The text can be changed by your A U X installer using the Bitwriter programming tool. Function shift Command: Press 1 to 4 times. (See Transmitter configuration table) Feedback: Display s
Résumé du contenu de la page N° 19
Valet mode AUX Command: Press two-times and then . AUX Feedback: Unlock icon appears hollow, "Valet" dis- plays in the text area when entering Valet mode. Notes: If the system is already locked the remote beeps one time when entering Valet mode. When exiting Valet mode the unlock appears solid, Valet is displayed in the text area, and the remote beeps two times. The REVISIONS unlock icon is displayed but the doors stay locked. REV. DESCRIPTION DRN. DATE 1 To enter or exit valet m
Résumé du contenu de la page N° 20
AUX Car finder Command: Press three-times and then . AUX Feedback: Remote beeps 1 short beep, the vehicle emits 1 long horn honk (if connected), and the parking lights flash 10 times. Notes: Lock/Unlock cancels the light flashes. Cabin temperature AUX Command: Press one time, then Hold for 1.5 seconds. Feedback: Screen will display current in cabin tem- perature. Notes: Cabin temperature is displayed on the remote. AUX Silent Lock Command: Press one- ti
