Instruction d'utilisation Demco TP20047

Résumé du contenu de la page N° 1

6-03
TP20047,Rev.2
ASSEMBLY
OPERATION

95-97 Honda Odyssey
REPLACEMENT PARTS
BOLT TORQUE SPECIFICATIONS READ complete manual CAREFULLY
BEFORE attempting operation.
STANDARD BOLTS: METRIC BOLTS:
Size Grade Torque
Size Torque
5/16" 5 20 ft/lbs.
8mm 22 ft/lbs.
3/8" 5 35 ft/lbs.
10mm 42 ft/lbs.
7/16" 5 56 ft/lbs.
12mm 70 ft/lbs.
7
1/2" 5 85 ft/lbs.
14mm 95 ft/lbs.
4
4
2
10
2
6
6
5
5
9
3
3
1
1
8
4
1
2
1
1
9517047 PARTS LIST
REF. PART
NO. NO. QTY. DESCRIPTION
1. 00523 8 3/8"-16UNC x 1-1/4" Hex Bolt G

Résumé du contenu de la page N° 2

WARNING: FAILURE TO FOLLOW THESE INSTRUCTIONS CAN RESULT IN LOSS OF TOWING VEHICLE CONTROL, SEPARATION OF THE TOW BAR FROM THE TOWING VEHICLE, SEPARATION OF THE TOWED VEHICLE FROM THE TOW BAR, CAUSING SEVERE PERSONAL INJURY, DEATH, OR PROPERTY DAMAGE. IMPORTANT INSTALLATION ITEMS DEMCO products and accessories are intended to

 be installed by professional installers with experi- ence, proper equipment and the ability to do modifi- Safety is of utmost importance at all times. There are s

Résumé du contenu de la page N° 3

2. Attach right and left mounting bracket with two previously existing bolts on each side. 3. Install cross member with three 3/8" x 1- 1/4" hex bolts, lockwashers and hex nuts on each side. 4. Install center support brace by taking two bolts out of vehicles center brace. (NOTE: Be sure to leave in the third bolt, only remove two bolts.) Attach center support to vehicle using two 10mm x 1.25 x 30mm bolts and 10mm lockwashers. Snug tighten these bolts and secure front of support using two 3/8" x

Résumé du contenu de la page N° 4

5. Trim splash shield according to photos and install. Note: Lower photos show where ears of splash panel will have to be trimmed off.