Instruction d'utilisation Performance Teknique Re-Speed F-250

Résumé du contenu de la page N° 1

TS Performance Products















Re-Speed



Tire Calibration and Speed Limiter
Removal Operation & Installation Manual

Installation of the TS Performance Re-Speed

Read all instructions and fully understand them before installing your TS Performance Re-Speed
module. Disconnect the battery terminals and remove keys from ignition before installation.

Résumé du contenu de la page N° 2

Contents: (1) Switch (2) Butt Connectors (2) Zip ties (2) T-taps (1) Eyelet Connector (2) Blue, (1) Pink Connector Installation: 1) Use supplied pink connector, crimp to RED wire on ReSpeed; crimp supplied eyelet to BLACK wire. 2) Use the supplied T-tap and tap RED wire into KEY ON +12 V usually located under the dash. 3) Connect the black wire to good clean ground. 4) Put the other T-tap on black wire to add speed limiter switch later (Figure 1). Speed Sensor Hook-up 5) T

Résumé du contenu de la page N° 3

Disable speed limiter 1) Leave key off and locate the push button next to the dip switches on re-speed board (Figure 5). This button allows the re-speed to go into SET mode if pushed while powering up. 2) Hold the button down and turn the vehicle on then release the button. 3) The re-speed is now in SET mode. Get the vehicle to the maximum speed desired and push the button again. Now the maximum speed is stored. This lets the computer only to see the maximum speed; disabling the spe

Résumé du contenu de la page N° 4

Calibration Charts Tire Ratios Chart A Gear Ratios Chart B Dip Switch Chart

Résumé du contenu de la page N° 5

%Change in Speed Dip Switch Values %Change in Speed Dip Switch Value 30% 11001100 0% 11111111 29% 10101100 -1% 00111111 28% 00011100 -2% 01011111 27% 01011100 -3% 11101111 26% 10111100 -4% 00101111 25% 11111100 -5% 10001111 24% 01000010 -6% 01110111 23% 00100010 -7% 11010111 22% 11100010 -8% 00010111 21% 10010010 -9% 10100111 20% 00110010 -10% 01000111 19% 11110010 -11% 11111011 18% 10001010 -12% 11011011 17% 00101010 -13% 00011011 16% 01101010 -14% 10101011 15% 1001101

Résumé du contenu de la page N° 6

TS Perforamance Re-Speed Guide Part # Make Model Tears Sensor Wire Color, Location 1992-1996 VSS Red/Pink, behind speedometer F-150 1997-1998 VSS Grey/ Blk, behind speedometer 1992-1996 VSS Red/Pink, behind speedometer 1997 HD VSS Red/Pink, behind speedometer F-250 1997-1998 LD VSS Grey/BLK, behind speedometer 1999-2006 ABS Grey/Blk, from ABS 1190101 Ford 1992-1997 VSS Red/Pink, behind speedometer F-350 1999-2006 ABS Grey/Blk, from ABS 1992-1996 2W ABS VSS Red/Pink, behind speed

Résumé du contenu de la page N° 7

DISCLAIMER READ CAREFULLY BEFORE INSTALLING ANY TS PERFORMANCE PRODUCT REMEMBER THIS IS A HIGH PERFORMANCE PRODUCT. USE AT YOUR OWN RISK. FOR OFF ROAD USE ONLY. Do not use this product until you have carefully read the following agreement. This agreement sets forth the terms and conditions for the use of the TS Performance product. The installation of this product indicates that the buyer has read and fully understands this agreement and accepts its terms and conditions. DISCLA