Résumé du contenu de la page N° 1
cover_NX-PN10[C].fm Page 1 Wednesday, May 19, 2010 9:34 AM
COMPACT COMPONENT SYSTEM
SYSTEME DE COMPOSANTS COMPACT
NX-PN10
INSTRUCTIONS
MANUEL D’INSTRUCTIONS
LVT2011-002B
[C]
Résumé du contenu de la page N° 2
safety_NX-PN10[C].fm Page 1 Monday, April 27, 2009 4:22 PM Warnings, Cautions and Others Mises en garde, précautions et indications diverses CAUTION The button in any position does not disconnect the mains line. Disconnect the mains plug to shut the power off completely (the STANDBY lamp goes off). For U.S.A. The MAINS plug or an appliance coupler is used This equipment has been tested and found to as the disconnect device, the disconnect device comply with the limits for a Class B digi
Résumé du contenu de la page N° 3
safety_NX-PN10[C].fm Page 2 Monday, April 27, 2009 4:22 PM For Canada/pour le Canada CAUTION THIS DIGITAL APPARATUS DOES NOT � Do not block the ventilation openings or EXCEED THE CLASS B LIMITS FOR RADIO holes. NOISE EMISSIONS FROM DIGITAL (If the ventilation openings or holes are APPARATUS AS SET OUT IN THE blocked by a newspaper or cloth, etc., the INTERFERENCE-CAUSING heat may not be able to get out.) EQUIPMENT STANDARD ENTITLED � Do not place any naked flame sources, such “DIGITAL AP
Résumé du contenu de la page N° 4
safety_NX-PN10[C].fm Page 3 Monday, April 27, 2009 4:22 PM Caution: Proper Ventilation To avoid risk of electric shock and fire, and to prevent damage, locate the apparatus as follows: 1. Front: No obstructions and open spacing. 2. Sides/Top/Back: No obstructions should be placed in the areas shown by the dimensions below. 3. Bottom: Place on the level surface. Maintain an adequate air path for ventilation by placing on a stand with a height of 10 cm or more. Attention: Aération correcte Pou
Résumé du contenu de la page N° 5
NX-PN10[C].BOOK Page 1 Friday, May 21, 2010 11:24 AM Contents Introduction.................................................2 Precautions ................................................................2 Getting Started............................................3 Connections................................................................4 Canceling the Display Demonstration (Demo) ..........6 Turning on the Power Automatically (Motion Sensor) ..........................................
Résumé du contenu de la page N° 6
NX-PN10[C].BOOK Page 2 Friday, May 21, 2010 11:24 AM Introduction Thank you for purchasing a JVC product. Please read all instructions carefully before operation, to ensure your complete understanding and to obtain the best possible performance from the unit. Precautions Installation • Install in a place which is level, dry and neither too hot nor too cold—between 5°C and 35°C. • Install the unit in a location with adequate ventilation to prevent internal heat buildup inside the unit. DO NO
Résumé du contenu de la page N° 7
NX-PN10[C].BOOK Page 3 Friday, May 21, 2010 11:24 AM Getting Started Replacing the battery in the remote control • In this manual, operations using the remote Insert the battery into the remote control by control are mainly explained; however, you matching the polarity (+ and –) correctly. can use the buttons and controls on the unit • If the range or effectiveness of the remote if they have the same (or similar) name and control decreases, replace the battery. marks. Rear side • In thi
Résumé du contenu de la page N° 8
NX-PN10[C].BOOK Page 4 Friday, May 21, 2010 11:24 AM Connections Do not connect the AC power cord until all other connections have been made. Connecting the Antenna FM antenna (supplied): Extend it so that you can obtain the best reception. Rear side For better FM reception Disconnect the supplied FM antenna and Outdoor FM antenna connect to an outdoor FM antenna using a 75 Ω (not supplied) wire with coaxial type connector. FM 75Ω COAXIAL terminal (on the rear panel) NOTES: • Make sure t
Résumé du contenu de la page N° 9
NX-PN10[C].BOOK Page 5 Friday, May 21, 2010 11:24 AM Connecting the Video Cord to View a Video/Picture from iPod When viewing a video/picture from iPod on your TV, use a composite video cord (not supplied) to connect the VIDEO OUT jack on the unit and the composite video input on your TV. • After you have connected the unit, change the video input mode on your TV. For details, also refer to the instruction manual for your TV. Video cord (not supplied) To video input Rear side Connecting the
Résumé du contenu de la page N° 10
NX-PN10[C].BOOK Page 6 Friday, May 21, 2010 11:24 AM Canceling the Display Demonstration (Demo) When you connect the AC power cord for the first time, the display demonstration starts automatically. • When you operate the unit, the display demonstration stops temporarily. If no operation is done for about 2 minutes, the unit starts the display demonstration again. Button Operation On the unit Hold down until “DEMO OFF” appears on the display. • To activate again, hold down DEMO until “DEMO
Résumé du contenu de la page N° 11
NX-PN10[C].BOOK Page 7 Friday, May 21, 2010 11:24 AM Basic Operations Main Unit Dock A Dock B Illumination panel (P.13) (P.13) (P.10) Motion sensor (P.6) Display (P.8) Remote STANDBY control lamp sensor Operating on the Main Unit Buttons Operations Turns on or off (standby) the power. Activates or deactivates Motion Sensor (P.6). 7
Résumé du contenu de la page N° 12
NX-PN10[C].BOOK Page 8 Friday, May 21, 2010 11:24 AM Buttons Operations Activates or deactivates the display demonstration (P.6). Adds the powerfulness to the sound (P.11). Stops the timer sound and restarts it 5 minutes later (P.22). • iPod (P.14): Press: Reverse skip/forward skip. Hold down: Reverse search/forward search. • FM (P.17): Tunes in to a station. • Changes the source to iPod /iPod (P.14). • Starts playback and pauses for iPod (P.14). Changes the source to FM (P.17) or FM AUDIO
Résumé du contenu de la page N° 13
NX-PN10[C].BOOK Page 9 Friday, May 21, 2010 11:24 AM Symbols Description ST Lights up when FM stereo broadcast is received. MONO Lights up when FM monaural reception mode is activated. TUNED Lights up when an FM station of sufficient signal strength is tuned in. FM Lights up when FM is selected as the source. 1/2/3 • Lights up when Timer is set (P.21). • 1/2/3 icon flashes while Timer is working. SLEEP Lights up when Sleep Timer is activated (P.11). Remote Control P.11 P.10 P.20, P.22 P
Résumé du contenu de la page N° 14
NX-PN10[C].BOOK Page 10 Friday, May 21, 2010 11:24 AM Buttons Main operations Changes the display information. • For iPod A/iPod B/AUDIO IN: • When the unit is turned off: Source name Clock Clock Day of the week Day of the week •For FM: Frequency Clock Day of the week Changes the source to FM (P.17) or AUDIO IN (P.19). • Changes the source to iPod /iPod (P.14). • Starts playback and pauses for iPod (P.14). Adjusts the volume level (VOL MIN/VOL 0 to VOL MAX/VOL 30). Drops the volume in a mome
Résumé du contenu de la page N° 15
NX-PN10[C].BOOK Page 11 Friday, May 21, 2010 11:24 AM To turn off the unit after a certain period of time—Sleep Timer Press repeatedly to specify the time (in minutes) as follows: 10 20 30 60 90 OFF 180 150 120 (Canceled) • To check the time remaining before the shut-off time, press SLEEP once. If you press the button repeatedly, you can change the shut-off time. To emphasize the sound—Sound Turbo You can add the powerfulness to the sound. Press to activate Sound Turbo. “S-TURBO” appears for
Résumé du contenu de la page N° 16
NX-PN10[C].BOOK Page 12 Friday, May 21, 2010 11:24 AM Playing Back from iPod Devices You can connect 2 iPod devices to the unit and enjoy sound and video from them. Compatible iPod Models: iPod model Audio Video √ iPod nano 1GB/2GB/4GB — √ iPod nano (2nd Generation) 2GB/4GB/8GB — √√ iPod nano (3rd Generation) 4GB/8GB √ iPod nano (4th Generation) 8GB/16GB √ √ iPod mini 4GB — √ iPod mini (2nd Generation) 4GB/ 6GB — √ iPod (4th Generation) 20GB/40GB — *1 √√ iPod photo (4th Generation) 20GB/30GB/
Résumé du contenu de la page N° 17
NX-PN10[C].BOOK Page 13 Friday, May 21, 2010 11:24 AM Connecting iPod Connect iPod to dock A or B on the unit. You can have 2 iPod devices connected at the same time. • Make sure the unit is on standby when you connect iPod. Dock adapter (supplied with iPod or sold separately) Dock A Dock B To detach the dock adapter from the dock: Pull up the dock adapter with your fingernail or a sharp-pointed tool using the slot. • Be careful not to injure your fingertips or damage the terminal of the doc
Résumé du contenu de la page N° 18
NX-PN10[C].BOOK Page 14 Friday, May 21, 2010 11:24 AM Operations For details, also refer to the instruction manual for iPod. NOTES: • Before viewing a video/picture from iPod on your TV, make the appropriate video setting on iPod. For details of the setting, see the instruction manual for iPod. • For iPhone and iPod touch Operate iPhone or iPod touch itself in the following cases: – when operating the home button – when selecting application icons on the home screen – when dragging the slide
Résumé du contenu de la page N° 19
NX-PN10[C].BOOK Page 15 Friday, May 21, 2010 11:24 AM Buttons Control of Operations On the iPod On the unit remote Confirms an item on the menu/screen. Center — * button Press: Applies Shuffle Play to iPod or iPod selected as the source. Select the desired shuffle mode. “SHUFFLE” appears for a while. • The shuffle icon lights up on the display of iPod. • To cancel, press again until the shuffle icon disappears. Hold down: Applies Shuffle Play to both iPod — — and iPod if con
Résumé du contenu de la page N° 20
NX-PN10[C].BOOK Page 16 Friday, May 21, 2010 11:24 AM NOTES: • JVC is not responsible for any loss of or damage to iPod that might result from the use of this product. • Do not touch or hit the terminals of the dock and of iPod. It might cause damage to these terminals. • When you connect iPod to the dock, make sure the terminal on the dock is fully inserted into iPod. • Always set the volume to the minimum level when connecting or disconnecting iPod. • Do not carry the unit with iPod conne
