Résumé du contenu de la page N° 1
Transport GT20
B3970-U
Service Engineer’s Manual
Résumé du contenu de la page N° 2
Résumé du contenu de la page N° 3
PREFACE Copyright This publication, including all photographs, illustrations, and soft- ware, is protected under international copyright laws, with all rights reserved. Neither this manual, nor any material contained herein, may be reproduced without written consent of the manufacturer-. Copyright 2006 Version 1.0 Disclaimer Information contained in this document is furnished by TYAN Com- puter Corporation and has been reviewed for accuracy and reliability prior to printing. TYAN assumes no l
Résumé du contenu de la page N° 4
Federal Communications Commission (FCC) Notice for the USA Compliance Information State- ment (Declaration of Conformity Procedure) DoC FCC Part 15: This device complies with part 15 of the FCC Rules Operation is subject to the following conditions: 1) This device may not cause harmful interference, and 2) This device must accept any interference received including inter- ference that may cause undesired operation. If this equipment does cause harmful interference to radio or television rec
Résumé du contenu de la page N° 5
About this Manual This manual provides you with instructions on installing your Transport GT20. This manual is intended for experienced users and integrators with hardware knowledge of personal computers. This manual consists of the following parts Chapter 1: Provides an Introduction to the Transport GT20 B3970-U bare-bones, packing list, describes the external components, gives a table of key compo- nents, and provides block diagrams of the system. Chapter 2: Covers procedures on installin
Résumé du contenu de la page N° 6
SAFETY INFORMATION Before installing and using the Transport GT20, take note of the fol- lowing precautions: – Read all instructions carefully. – Do not place the unit on an unstable surface, cart, or stand. – Do not block the slots and opening on the unit, which are pro- vided for ventilation. – Only use the power source indicated on the marking label. If you are not sure, contact the Power Company. – The unit uses a three-wire ground cable, which is equipped with a third pin to ground the un
Résumé du contenu de la page N° 7
Table of Contents Chapter 1:Overview 1.1 About the Transport GT20 B3970-U . . . . . . . . . . . . . . . . . . . . . . . 1 1.2 Product Model. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 1.3 Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 1.4 Unpacking . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 1.5 About the Product . . . . . . . . . . . . . . . . . . . . . .
Résumé du contenu de la page N° 8
3.7 Replacing the M1012 Adapter Board . . . . . . . . . . . . . . . . . . . . . . 41 3.7.1 M1012 Adapter Board Features for B3970-U . . . . . . . . . . 43 3.7.2 M1012 Adapter Board Connector Pin Definition . . . . . . . 44 3.8 Replacing the SATA Backplane . . . . . . . . . . . . . . . . . . . . . . . . . . 49 3.8.1 SAS/SATA Backplane (M1208) Features. . . . . . . . . . . . . 51 3.9 Replacing the Power Supply . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 53 Appendix I: BIOS Difference
Résumé du contenu de la page N° 9
Chapter 1: Overview 1.1 About the Transport GT20 B3970-U TM Congratulations on your purchase of the TYAN Transport GT20 (B3970-U), a highly-optimized rack-mountable bareb- one system. The Transport GT20 (B3970-U) is designed to ® support AMD Opteron™ 2000 940-pin processor, providing a rich feature set and incredible performance. Leveraging ® advanced technology from AMD , the Transport GT20 (B3970-U) server system is capable of offering scalable 32 and 64-bit computing, high-bandwidth memo
Résumé du contenu de la page N° 10
1.3 Features –Reset Enclosure –ID Industry 19” rack-mountable 1U chassis Storage – (4) 3.5” HDD bays Pre-installed slim type 24x CD-ROM – (1) slim CD-ROM bay (4) hot-swappable, SATA HDD Dimension: D 22.4 x W 17.2 x H Networking 1.72 inch (568x436x43.6mm) (2) Intel i8254PI GbE LAN control- Processor lers ® (1) 1207-pin ZIF socket for AMD Video Opteron 2000 Series processors ® ATI XGI Volari Z7 (XG20) Integrated 144-bit DDR2 memory 16MB frame buffer memory controller Motherbo
Résumé du contenu de la page N° 11
1.4 Unpacking If any items are missing or appear damaged, contact your retailer or browse to TYAN’s Web site for service: http://www.tyan.com. The Web site also provides information on other TYAN prod- ucts, plus FAQs, compatibility lists, BIOS settings, and more. 1 x Tyan driver CD Heatsink HDD Screws Air Duct Power Cables Left to right: Europe, US Mounting Ears & Screws FDD Kit FDD Cable FDD Installing Rails & Screws FDD Backplane Cable Chapter 1: Overview 3
Résumé du contenu de la page N° 12
Barebone Manual Mainboard Manual Rail Kit Screws Kit Mounting Bracket x 4 Sliding Rails x 2 Sliding Brackets Front L-Bracket x 2 Rear L-Bracket x 2 4 Chapter 1: Overview
Résumé du contenu de la page N° 13
1.5 About the Product The following views show you the product. 1.5.1 Front View Reset switch Warning LED NMI switch HDD activity LED ID switch Power LED ID LED Power switch USB ports 2 x LAN LEDs CD-ROM Drive Hard Drive Bay x 4 1.5.2 Rear View Power Supply Fan Aperture Power Supply Socket PCI-X Slot PS/2 Mouse/Keyboard Ports Opening ID LED 2 USB Ports LAN Port (NIC1) Serial Port LAN Port (NIC2) VGA Port Chapter 1: Overview 5
Résumé du contenu de la page N° 14
1.5.3 LED Definition Front Panel LED Color State Description Power Green ON Power ON OFF OFF Power OFF HDD Activity Amber Random Blink HDD access activity OFF OFF No disk activity LAN1/LAN2 Activity Green ON LAN linked Green Blinking LAN accessing OFF OFF No LAN linked Warning Red ON Fan fails OFF OFF Normal ID LED Blue ON System is identified OFF OFF System is not identified Hot Swappable HDD Green ON Power connected Tray Power LED OFF OFF Power disconnected Hot Swappable SATA Amber Random Blin
Résumé du contenu de la page N° 15
1.5.4 Internal View 1 2 3 4 9 5 6 10 7 8 11 12 13 1. PCI-X Slot 8. LED Control Board Cable 2. Memory Slots 9. SATA Cables (4) 3. Power Connector 10. USB Cable 4. EPS Power Supply 11. CD-ROM Cable 5. System Fans 12. Four SATA HDD Bays 6. M1012 Adapter Board 13. Slim CD-ROM 7. SATA Backplane Chapter 1: Overview 7
Résumé du contenu de la page N° 16
1.5.5 Motherboard (S3970) Block Diagram 8 Chapter 1: Overview
Résumé du contenu de la page N° 17
1.5.6 Motherboard Layout Chapter 1: Overview 9
Résumé du contenu de la page N° 18
Jumpers & Connectors Jumper Function /Connector J2/J3 3-pin Back Panel Fan Connector J4/J22/J23/ 4-pin Fan Connector with Speed Control J35 J6 COM2 Header J24 USB Front Panel Connector J25 Front Panel SATA LED Pin Header J26 Front Panel Header J27 LCM Pin Header J29 IPMB Pin Header JP1 VGA Enable/Disable Jumper (Close 1-2) Default, Enabled (Close 2-3) Disabled JP2/JP3 SMDC/ASF2.0 Select Jumper (Close 1-2) Default, support ASF2.0 (Close 2-3) support SMDC car
Résumé du contenu de la page N° 19
Chapter 2: Setting Up 2.0.1 Before You Begin This chapter explains how to install the CPU, CPU heatsink, memory modules, and hard drives. Instructions on inserting a PCI-X card are also given. Take note of the precautions mentioned in this section when installing your system. 2.0.2 Work Area Make sure you have a stable, clean working environment. Dust and dirt can get into components and cause malfunc- tions. Use containers to keep small components separated. Putting all small components in
Résumé du contenu de la page N° 20
2.0.4 Precautions Components and electronic circuit boards can be damaged by discharges of static electricity. Working on a system that is connected to a power supply can be extremely dangerous. Follow the guidelines below to avoid damage to the Transport GT20 or injury to yourself. Ground yourself properly before removing the top cover of the system. Unplug the power from the power supply and then touch a safely grounded object to release static charge (i.e. power supply case). If ava
