Résumé du contenu de la page N° 1
180A,187A
EvolutionrLineAirConditioners
withPuronRefrigerant
2to5NominalTons(Sizes024to060)
InstallationInstructions
NOTE: Read the entire instruction manual before starting the IndoorThermostatControlOptions
installation.
Evolution Standard2---stage
Unless otherwise noted, information in these installation
Model
Control Thermostat
instructions pertain to both 180A and 187A series units.
Information that is unique to the 180A series will be identified as
such; likewise information that is unique
Résumé du contenu de la page N° 2
can be no deviation. Consult the Application Guideline and INSTALLATIONRECOMMENDATIONS Service Manual – Air Conditioners and Heat Pumps Using Puron NOTE: In some cases noise in the living area has been traced to Refrigeranttoobtain requiredunitchangesforspecificapplications gaspulsationsfrom improperinstallation ofequipment. andforR--22retrofit. 1. Locate unit away from windows, patios, decks, etc. where CheckEquipmentandJobSite unitoperation sound may disturb customer. UnpackUnit 2. Ensure that
Résumé du contenu de la page N° 3
On rooftop applications,locateunitatleast6 in.(152.4 mm)above roof surface. ! CAUTION OperatingAmbient UNITDAMAGEHAZARD The minimum outdoor operating ambient in cooling mode is Failure to follow this caution may result in equipment 55_F/12.78_C without low ambient cooling enabled, and the damageorimproperoperation. maximum outdoor operating ambient in cooling mode is If ANY refrigerant tubing is buried, provide a 6 in. (152.4 125_F/51.67_C. On Evolution communicating systems only, for mm) vertic
Résumé du contenu de la page N° 4
Table2–AccessoryUsage REQUIREDFOR REQUIREDFORSEACOAST LOW---AMBIENT COOLING REQUIREDFORLONG LINE Accessory APPLICATIONS APPLICATIONS APPLICATIONS* (Within2miles/3.22km) (Below55 °F/12.8_C) Accumulator No No No CompressorStartAssistCapacitorand Standardon 187Amodels. Standardon 187Amodels. Standardon 187Amodels. Relay} Notrequiredfor 180Amodels. Notrequiredfor 180Amodels. Notrequiredfor 180Amodels. Crankcase Heater Standard Standard Standard Standardwith Evolution Control EvaporatorFreeze Protect
Résumé du contenu de la page N° 5
Refrigerant tubes and indoor coil should be evacuated using the recommended deep vacuum method of 500 microns. The alternate ! WARNING triple evacuation method may be used. See Service Manual for triple evacuation method. Always break a vacuum with dry ELECTRICALSHOCKHAZARD nitrogen._ Failure to follow this warning could result in personal DeepVacuumMethod injuryordeath. The deep vacuum method requires a vacuum pump capable of The unit cabinet must have an uninterrupted or unbroken pulling a vac
Résumé du contenu de la page N° 6
MakeAirflowSelections START--UP AirflowSetupforEvolutionControlFurnaceofFE Fancoil(communicating) ! CAUTION When using an Evolution User Interface, airflow is UNITOPERATIONANDSAFETYHAZARD automatically selected based on equipment size. See User Interface Installation Instructions for available Failure to follow this caution may result in minor personal injury,equipmentdamageorimproperoperation. adjustments. Topreventcompressordamageorpersonalinjury, AirflowSelectionforVariableSpeedFurnacesfor ob
Résumé du contenu de la page N° 7
products.ThegreenLEDwillremain OFFuntilcommunicationsis SystemFunctionsAndSequenceOfOperation established. Once a valid command isreceived, thegreen LEDwill The outdoor unit control system has special functions. The turn ON continuously. If no communication is received within 2 following isan overview ofthe2--stagecontrolfunctions: minutes, the LED will be turned OFF until the next valid CoolingOperation communication. 187A and 180A (containing circuit board HK38EA015 or newer) AmberStatusLight
Résumé du contenu de la page N° 8
In low ambient cooling (below 55_F/12.78_C)on187A and180A CompressorOperationon180AModels models,thecontrolboard cyclesthefan offand on. The basic scroll design has been modified with the addition of an TimeDelays internalunloading mechanism thatopensaby--passportin thefirst compression pocket, effectively reducing the displacement of the Theunittimedelaysinclude: scroll. The opening and closing of the by--pass port is controlled S Five minute time delay to start cooling or heating operation by
Résumé du contenu de la page N° 9
Table4–ModelPlugInformation CheckCharge PINRESISTANCE All180Aand187Aunitsmustbechargedinhighstageonly. MODEL MODEL PLUG (K---ohms) NUMBER NUMBER Factory charge amount and desired subcooling are shown on unit Pins 1---4 Pins2---3 rating plate. Charging method is shown on information plateinside 187A024 HK70EZ001 5.1 11 unit. To properly check or adjust charge, conditions must be 187A036 HK70EZ003 5.1 24 favorable for subcooling charging. Favorable conditions exist 187A048 HK70EZ005 5.1 39 when th
Résumé du contenu de la page N° 10
The control is shipped with the brownout active. The change in 187AModelsOnly,CompressorStartDetection status is remembered until toggled to a new status. A power In low--stage, if the specified start voltage at VR terminal is not down/power up sequence will not reset the status. It may be achieved, the start relay is de--energized after 1 second and the necessary to do the toggle twice to cycle to the desired state of the controlwillflash theappropriatefaultcode. defeat. In high--stage, if the
Résumé du contenu de la page N° 11
Table5–2---StageCompressor (Winding Resistance at 70_F ± 20_ / 21.11_C ± 11.11_C) Winding 187A024 187A036 187A048 187A060 Start (S---C) 2.74 1.98 1.55 0.74 Run(R---C) 0.80 0.75 0.48 0.36 Winding 180A024 180A036 180A048 180A060 Start (S---C) 1.40 1.29 1.52 0.60 Run (R---C) 1.32 0.89 0.64 0.49 MAJORCOMPONENTS THERMISTOR CURVE 2--StageControl 90 The2--stagecontrolboard controlsthefollowing functions: 80 -- Low-- and high--stagecompressorcontactoroperation 70 -- Outdoorfan motoroperation 60 -- Low a
Résumé du contenu de la page N° 12
OATThermistormustbe lockedin OCTThermistormustbe place withsphericalnib endfacing to- securedtightonthe liquid wards the frontofthe controlbox tube. Fig.8 -- OutdoorAirThermistor(OAT)Attachment Fig.9 -- OutdoorCoilThermistor(OCT)Attachment FINALCHECKS CAREANDMAINTENANCE IMPORTANT:Beforeleaving job,besureto do thefollowing: For continuing high performance and to minimize possible equipment failure, periodic maintenance must beperformed on this 1. Ensure that all wiring is routed away from tubing
Résumé du contenu de la page N° 13
between short flash and first long flash is 1.0 second. Time StatusCodes between coderepeating is2.5 secondswith LED OFF. Table 6 shows the status codes flashed by the amber status light. Count the number of short and long flashes to determine the Mostsystem problemscan bediagnosed by readingthestatuscode appropriate flash code. Table 6 gives possible causes and actions asflashed by theamberstatuslighton thecontrolboard. related to each error. The codes are flashed by a series of short and long
Résumé du contenu de la page N° 14
Two-Stage Variable Speed Variable Speed 2-Stage Thermidistat Air Conditioner Fan Coil Furnace Air Conditioner Thermidistat O Y1 Heat Stage 2 O/B W2 W2 Y1 RVS/Heat Stage 2 O/W2/B Heat Stage 1 W/W1 W1 W1 Heat Stage 1 W/W1 REMOVE J2 Cool Stage 1 Y1 / W2 Y1 JUMPER FOR Compressor Low Y1 W2 HEAT STAGING Cool Stage 2 Y/Y2 Y/Y2 Y/Y2 Compressor High Y/Y2 Y2 Y/Y2 Fan G G Fan G G 24VAC Hot Heating Rh R R 24VAC Hot Heating Rh R R 24VAC Hot Cooling Rc REMOVE J1 FOR 24VAC Hot Cooling Rc DEHUMIDIFY Dry Conta
Résumé du contenu de la page N° 15
Communicating AC//HP User Interface Fan Coil D D D C C C B B B A A A Humidifier A03076 Fig.11 -- EvolutionFurnaceorFanCoilWiringwithCommunicating2--stageAC PURONR(R--410A)REFRIGERANTQUICKREFERENCEGUIDE SPuron refrigerantoperatesat50--70 percenthigherpressuresthan R--22.Besurethatservicing equipmentand replacementcomponents aredesignedtooperatewithPuronrefrigerant SPuronrefrigerantcylindersarerosecolored. SRecoverycylinderservicepressureratingmustbe400psig,DOT4BA400orDOTBW400. SPuronrefrigerantsy
Résumé du contenu de la page N° 16
E2009 BryantHeating &Cooling SystemsD7310 W. MorrisSt.DIndianapolis, IN 46231 Printed inU.S.A. EditionDate:07/09 CatalogNo. II180A---06 Manufacturer reserves therighttodiscontinue,or changeatanytime,specifications or designs withoutnoticeandwithoutincurringobligations. Replaces:II180A---05 16 180A/187A
