Résumé du contenu de la page N° 1
Portable Projector
VT670/VT570/VT470/VT47
User’s Manual
Résumé du contenu de la page N° 2
Important Information Safety Cautions Precautions Please read this manual carefully before using your NEC VT670/VT570/VT470/VT47 Projector and keep the manual handy for future reference. Your serial number is located on the bottom of your projector. Record it here: CAUTION To turn off main power, be sure to remove the plug from power outlet. The power outlet socket should be installed as near to the equipment as possible, and should be easily accessible. CAUTION TO PREVENT SHOCK, DO NOT OPEN THE
Résumé du contenu de la page N° 3
Important Information RF Interference (for USA only) WARNING The Federal Communications Commission does not allow any modifications or changes to the unit EXCEPT those specified by NEC Solutions (America), Inc. in this manual. Failure to comply with this government regulation could void your right to operate this equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide re
Résumé du contenu de la page N° 4
Important Information Fire and Shock Precautions 1. Ensure that there is sufficient ventilation and that vents are unobstructed to prevent the build-up of heat inside your projector. Allow at least 4 inches (10 cm) of space between your projector and a wall. 2. Prevent foreign objects such as paper clips and bits of paper from falling into your projector. Do not attempt to retrieve any objects that might fall into your projector. Do not insert any metal objects such as a wire or screwdriver into
Résumé du contenu de la page N° 5
Important Information Lamp Replacement •To replace the lamp, follow all instructions provided on page 53. • Be sure to replace the lamp when the message “The lamp has reached the end of its usable life. Please replace the lamp.” appears. If you continue to use the lamp after the lamp has reached the end of its usable life, the lamp bulb may shatter, and pieces of glass may be scattered in the lamp case. Do not touch them as the pieces of glass may cause injury. If this happens, contact your NEC
Résumé du contenu de la page N° 6
Table of Contents Important Information......................................................................... i 1. Introduction ...................................................................................... 1 What's in the Box? ........................................................................................................ 1 Introduction to the Projector ......................................................................................... 2 Part Names of the Projecto
Résumé du contenu de la page N° 7
Table of Contents 4. Convenient Features.................................................................... 33 Turning Off the Image and Sound ............................................................................... 33 Freezing a Picture (VT670/VT470 only) ..................................................................... 33 Enlarging and Moving a Picture (VT670/VT470 only) ................................................ 33 Using the Remote Mouse Function (VT670/VT470 only) .
Résumé du contenu de la page N° 8
Quick Setup Guide Important Information OFF ON POWER MAGNIFY PIC-MUTE PAGE UP DOWN MENU ENTER EXIT L-CLICK R-CLICK MOUSE VIDEO COMPUTER AUTO ADJ. 1 S-VIDEO 2 VOLUME ASPECT HELP PICTURE FREEZE SELECT SOURCE PIC-MUTE ASPECT POWER 1. Introduction What's in the Box? Make sure your box contains everything listed. If any pieces are missing, contact your dealer. Please save the original box and packing materials if you ever need to ship your projector. Projector Power cable (US: VT670/VT470: 7N080213
Résumé du contenu de la page N° 9
1. Introduction Introduction to the Projector This section introduces you to your new VT670/VT570/VT470/VT47 Projector and describes the features and con- trols. Congratulations on Your Purchase of The VT670/VT570/VT470/VT47 Projector The VT670/VT570/VT470/VT47 is one of the very best projectors available today. The VT670/VT570/VT470/VT47 enables you to project precise images up to 300 inches across (measured diagonally) from your PC or Macintosh computer (desktop or notebook), VCR, DVD player
Résumé du contenu de la page N° 10
1. Introduction NOTE: Composite video standards are as follows: NTSC: U.S. TV standard for video in U.S. and Canada. PAL: TV standard used in Western Europe. PAL-N: TV standard used in Argentine, Paraguay and Uruguay. PAL-M: TV standard used in Brazil. PAL60: TV standard used for NTSC playback on PAL TVs. SECAM: TV standard used in France and Eastern Europe. NTSC4.43: TV standard used in Middle East countries. •You can use the supplied wireless remote control and remote mouse receiver to operate
Résumé du contenu de la page N° 11
FOCUS LAMP STATUS POWER VIDEO S-VIDEO COMPUTER-1 COMPUTER-2 ON/STAND BY ADJ. AUTO VIDEO IN L/MONOAUDIO R AUDIO COMPUTER 1 IN AUDIO COMPUTER 2 IN S-VIDEO IN AUDIO AUDIO OUT PC CONTROL L/MONO R COMPUTER OUT AC IN ZOOM SELECT 1. Introduction Part Names of the Projector Front/Top Zoom Lever (VT670/VT570/VT470) Controls Digital Zoom Button (VT47) (See page 6) (See page 28) Ventilation (inlet) / Filter Cover (See page 51) Focus Ring (See page 28) Remote sensor (See page 10 for VT670/VT470) (See pag
Résumé du contenu de la page N° 12
1. Introduction Bottom Lamp Cover (See page 53) Adjustable Tilt Foot (See page 27) Adjustable Tilt Foot Lever (See page 27) Adjustable Tilt Foot Lever (See page 27) For VT670 and VT470 only Attaching the supplied carrying handle You can carry the projector by attaching the supplied carrying handle securely to the projector. To attach the supplied carrying handle, use the supplied flathead screwdriver and two screws. Place a soft cloth on the working surface before turning the projector over to p
Résumé du contenu de la page N° 13
1. Introduction Top Features VT670/VT570/VT470 VT47 COMPUTER 11 10 2 3 4 9 7 LAMP AUTO STATUS ADJ. POWER VIDEO S-VIDEO COMPUTER-1 COMPUTER-2 SELECT 8 ON/STAND BY AUTO ADJ. 12 13 15 6 7 8 1. POWER Button (ON / STAND BY) ( ) 7. COMPUTER1 and 2 Buttons (one COMPUTER Use this button to turn the power on and off when the port on VT47) Button main power is supplied and the projector is in standby Press this button to select an RGB source from com- mode. puter or component equipment connected to your
Résumé du contenu de la page N° 14
1. Introduction Terminal Panel Features 4 1 VIDEO IN COMPUTER 1 IN AUDIO COMPUTER 2 IN L/MONO AUDIO R VT670/VT570/VT470 S-VIDEO IN AUDIO AUDIO OUT PC CONTROL L/MONO R MONITOR OUT 32 5 4 1 VIDEO IN COMPUTER IN AUDIO AUDIO L/MONO R VT47 S-VIDEO IN PC CONTROL MONITOR OUT 3 2 5 1. COMPUTER 1 and 2 IN / Component Input Connector For example, when a cable mini-plug is inserted into (Mini D-Sub 15 Pin) (One COMPUTER port on VT47) the left AUDIO IN jack only, only left sound is output. Connect your co
Résumé du contenu de la page N° 15
1. Introduction Part Names of the Remote Control For VT670/VT470 5. PIC-MUTE Button 1 This button turns off the image and sound for a short period of time. Press again to restore the image and OFF ON sound. POWER 3 2 MAGNIFY PIC-MUTE PAGE 6. PAGE UP/DOWN Button UP Use these buttons to operate your computer with the 4 6 supplied remote mouse receiver. See page 34. You DOWN can use these buttons to scroll the viewing area of the 5 window or to move to the previous or next slide in MENU 7 PowerPo
Résumé du contenu de la page N° 16
1. Introduction 1 OFF ON POWER 3 2 MAGNIFY PIC-MUTE PAGE UP 4 6 DOWN 5 MENU 7 8 ENTER EXIT 10 9 L-CLICK R-CLICK MOUSE 12 11 VIDEO COMPUTER AUTO ADJ. 1 16 13 S-VIDEO 15 2 14 18 VOLUME ASPECT HELP 20 PICTURE FREEZE 17 21 19 16. AUTO ADJ. Button Use this button to adjust an RGB source for an opti- mal picture. See page 31. 17. VOLUME (+)(–) Button Press (+) to increase the volume and (–) to decrease it. 18. ASPECT Button Press this button once to display the Aspect Ratio select menu. Keep pressing
Résumé du contenu de la page N° 17
1. Introduction Battery Installation 1 2 3 Slip the cover back over the bat- Press firmly and slide the Remove both old batteries and teries until it snaps into place. Do battery cover off. install new ones (AAA). Ensure not mix different types of batter- that you have the batteries' po- ies or new and old batteries. larity (+/–) aligned correctly. Remote Control Precautions • Handle the remote control carefully. • If the remote control gets wet, wipe it dry immediately. •Avoid excessive heat an
Résumé du contenu de la page N° 18
1. Introduction For VT570/VT47 1 2 3 SELECT 4 5 6 7 SOURCE PIC-MUTE 8 9 ASPECT POWER 1. Infrared Transmitter 7. PIC-MUTE Button Direct the remote control toward the remote sensor This button turns off the image and sound for a short on the projector cabinet. period of time. Press again to restore the image and sound. 2. MENU Button Displays the menu for various settings and adjust- 8. ASPECT Button ments. Press this button once to display the Aspect Ratio select menu. Keep pressing will change a
Résumé du contenu de la page N° 19
1. Introduction Battery Installation 1 2 3 Push the battery holder back into Push the catch to the right Remove the old Lithium coin cell the remote control until you feel a and remove the battery and install new one (CR2032). holder. click. Ensure that the side with the mark “+” is up. Remote Control Precautions • Handle the remote control carefully. • If the remote control gets wet, wipe it dry immediately. •Avoid excessive heat and humidity. • If you will not be using the remote control for a
Résumé du contenu de la page N° 20
300" 240" 200" 180" 150" 120" 100" 80" 60" 40" 30" 21" AC IN 2. Installation and Connections This section describes how to set up your projector and how to connect video and audio sources. Your projector is simple to set up and use. 1 But before you get started, you must first: z Set up a screen and the projector. x Connect your computer or video equip- ment to the projector. See pages 17 to 21. c Connect the supplied power cable. See page 22. 3 2 NOTE: Ensure that the power cable and any other
