Résumé du contenu de la page N° 1
Owner’s Manual
MEDIAMASTER
9200 S
9600 S
GB 1
Résumé du contenu de la page N° 2
Important Information Wiring the plug (UK and Eire only) The mains lead on this product is already fitted with a non-rewireable (moulded) plug incorporating a fuse, the value of which is indicated on the pin face of the plug. Should the fuse need to be replaced, an ASTA or BSI approved BS 1362 fuse must be used of the same rating, marked thus: If the fuse cover is detachable always refit the cover after replacing the fuse. NEVER use the plug with the fuse cover omitted. If the fitted plug is not
Résumé du contenu de la page N° 3
Mediamaster 9200 S and 9600 S The sky is the limit with your Mediamaster. It‘s easy to use, al- ways at your command and adaptable for future advances. To begin with, you will find it necessary to read these instructions but you will soon find yourself competent without them. Contents For your safety For your safety 3 • Keep a clear space around Rear panel, Front panel 4 the Mediamaster to allow Installation of the Mediamaster 5 for sufficient ventilation. Connecting the Mediamaster to differen
Résumé du contenu de la page N° 4
Rear panel Mains lead 0/12 VOLT TV SCART SAT SCART LNB * 230 V AC for an for the audio / for an analogue Satellite dish +/- 15%, external LNB video input of receiver input (F- 50 Hz switch the TV set connector) AUDIO L R VCR SCART RS232 SCSI Stereo outputs for a video for a printer, For a CD-ROM for connection recorder PC or a high player or other to a HiFi system speed modem high-speed data equipment * LNB cables also feed the LNB with a supply voltage of 13/18 V (V/H polarisa- tion) and a 0/
Résumé du contenu de la page N° 5
Installation The box for your Mediamaster should contain the following items: • the Mediamaster 2 3 1 6 4 5 8 9 TV 7 0 GUIDE MENU • a remote control handset with batteries. EXIT OK • a fully featured SCART cable which can be used to connect TEXT your Mediamaster to the TV or video recorder. • Owner’s Manual. SCART cable About the SCART sockets • On the back side the Mediamaster is equipped with 3 SCART sockets (see figure). When you connect external sets to any of theese sockets, always use full
Résumé du contenu de la page N° 6
Connecting the Mediamaster to a TV set • Do not remove the cable from the TV to the TV aerial. TV • Connect one end of the SCART cable to the TV SCART socket on the back of the Mediamaster and the other end to the SCART input socket on your TV. SCART Connecting to a TV and a video recorder Refer to your video recorder manual for full instructions. • Connect one SCART cable between the TV and the TV SCART socket on the Mediamaster. • Connect the other SCART cable between the video recorder and th
Résumé du contenu de la page N° 7
Connecting to an analogue satellite receiver and a video recorder • Connect one SCART cable between the TV set and the TV With Video recorder SCART socket on the Mediamaster. • Connect one SCART cable between the TV SCART socket on NOKIA Smart priority switch the analogue satellite receiver and the SAT SCART socket on B A the Mediamaster. VCR • Connect one SCART cable between the video recorder and the VCR SCART socket on the Mediamaster. • Connect the RF cable from the RF output on the video re
Résumé du contenu de la page N° 8
CA module and Smart Card. Model 9600 S only CA modules and Smart Cards are licenced to Service Provid- ers. If you want to watch TV programmes from a Service Provider you must use a CA module (Conditional Access) with a Smart Card. Please note, that the CA module and the Smart Card may give special menus not described in this Manual. If no CA module is used you can only watch ”free to air” TV programmes. Note: The mains plug must not be plugged in before insert- ing the CA module! • Insert the
Résumé du contenu de la page N° 9
Remote control This section describes how to operate the Mediamaster using the buttons on the remote control. You can also change programmes by pressing buttons on the Mediamaster‘s front panel. To turn the Mediamaster on/off (standby). Press once to switch to audio language/audio track (if available). Press twice to switch to Radio mode. TV To leave a menu and go back to watch a TV pro- gramme. To switch from Radio Mode to TV Mode. To toggle between terrestrial TV, VCR, analogue and the digita
Résumé du contenu de la page N° 10
About the Smart Card and CA Module. Model 9600 S only To be able to receive pay-TV channels you will need a CA Mod- ule and a Smart Card from the Service Provider of your choice. The Service Provider is the distributor of the programmes. If you are subscribing to services from more than one Service Provider, you might have to change between different Smart Cards, or even between different CA Modules. Please note, that a smart card is connected to a single Service Provider and due to this, a spec
Résumé du contenu de la page N° 11
Basic Settings The Welcome Menu To install the Mediamaster properly you have to adjust a few set- tings. You will always be guided by the information at the bottom of the menus. When you have finished the final part of the setup procedure you can start watching TV channels and listen to Radio channels. By now you should have the “Welcome Menu” on the TV screen. Press the OK button to proceed. Language selection Select the desired language. This will define the language shown in the menus. It wil
Résumé du contenu de la page N° 12
Dish adjustment ASTRA, HOTBIRD, THOR and SIRIUS all have one (1) prepro- grammed channel each. If the dish is already correctly adjusted and your selection on line “LNB frequency” is also correctly set, you should now see a programme (from the satellite you just selected) in the background. If not, or if the picture/sound is not satisfactory, you will have to adjust the dish to improve the reception quality. Check the signal strength meter at the lower part of this menu. Adjust the dish mechanic
Résumé du contenu de la page N° 13
IMPORTANT! If you have a combination which consists of more than 1 LNB and/or more than one dish, you must connect the LNB:s to an external switch. Once installed and configured, the switch automatically performs the choice of correct LNB to the desired programme channel. TM This external switch is better known as a DiSEqC switch (Level 1 or 2 type). The DiSEqC switch can be located close to the LNBs, which then means you only need one cable down to the Mediamaster. The following description wil
Résumé du contenu de la page N° 14
Antenna Configuration Set-Up If you have another antenna (dish) combination you can configure it with this menu, which appears when you make a selection from the “Antenna Configuration” menu, line “Multiantenna / LNB:s for multiple Satellite positions”. (You can also recall this menu at a later occasion. From the Main Menu; select “Installation” and then “Antenna Configuration”). Antenna alternative: Select an Antenna alternative from 1 to 8. Please note, that the parameters in the menu are prep
Résumé du contenu de la page N° 15
Channel Search set-up The information to enter in this menu is available in various maga- zines covering satellite TV reception, or from your Service Pro- vider. You must also use it e. g. if you later want to add channels from a new transponder. Antenna Configuration: Select the option, 1 - 8, that corresponds to your antenna system. Transponder Frequency: Enter using the number buttons on the remote control. Polarization: Select polarization; “Horizontal” or “Vertical”. Symbol Rate: Select “Au
Résumé du contenu de la page N° 16
Viewing TV Important general information The following will describe the basic functions of your Media- master during the watching of TV or listening to Radio channels from the Mediamaster. Sometimes the information may not be displayed as illustrated. Many of the functions described here are dependent on the Service Provider and/or can only be used if they are included in the transmitted programme information. Please note, that during the Channel Search procedure, the Mediamaster has downloaded
Résumé du contenu de la page N° 17
From here you can also obtain information about other channels. Select with the up/down buttons. If you stop on another chan- nel number and press OK, you will exit the menu and return to TV mode, but now on the new channel. If you select “Next” on a programme line and press OK, you will set a “Reminder” . This means that, while watching TV, you will be reminded when the “Reminder marked” programme starts. If you press the “i” button once more, you will get extended in- formation (if transmit
Résumé du contenu de la page N° 18
Volume level Increase or decrease the sound level by pressing the “+” and “-” buttons. A control bar will be displayed on the screen during level adjust- ment. (The max. level for volume is the current volume setting on the TV set). Please note, that the volume adjustments also change the vol- ume level to your VCR during recording. It is possible to turn the sound on and off with the button. Sound off is indicated with the same symbol on the screen. If you turn the volume off with this button
Résumé du contenu de la page N° 19
Video recorder With a Video Cassette Recorder (VCR) connected you can watch/ record video tapes. If your VCR is connected with a SCART cable and you press the Start button on the VCR, the playback will start and interrupt the TV programme from the Mediamaster. To watch TV programmes again , press the TV button or stop the VCR. Please note, that during the recording of a programme, every- thing shown on the screen will be registered! For example: If you call up a Menu from the Mediamaster on the
Résumé du contenu de la page N° 20
Settings from the Main Menu How to show the Main Menu Press the MENU button and you will get the Main Menu on the TV screen. Press the TV or EXIT button to leave the menu. Submenus from the Main Menu If you select one of the highlighted titles and press the OK but- ton, a submenu will be shown on the TV screen. From a submenu you can adjust settings to your own require- ments. The TV Guide and Radio Guide These guides will give you an overview of programme informa- tion from the TV/Radio channel
