Instruction d'utilisation Windsor 94331

Résumé du contenu de la page N° 1

ROUTER TABLE INSERT ROUTER TABLE INSERT
ROUTER TABLE INSERT ROUTER TABLE INSERT ROUTER TABLE INSERT
94331
ASSEMBLY AND OPERATING INSTRUCTIONS
3491 Mission Oaks Blvd., Camarillo, CA 93011
Visit our Web site at http://www.harborfreight.com
© ®
Copyright 2006 by Harbor Freight Tools . All rights reserved. No portion of this
manual or any artwork contained herein may be reproduced in any shape or
form without the express written consent of Harbor Freight Tools.
For technical questions and replacem

Résumé du contenu de la page N° 2

Specifications Molded phenolic plastic, steel accessories. Material Dimensions 12” x 9” x 23/64 thick Main Opening 3-7/8” inside demension Guide Pin 1-3/8” L x 1/4” DIA. (pin) x 3/8” DIA. (shoulder) Large Pop Out Ring 4-1/16” OD x 2-9/16” ID Small Pop Out Ring 2-7/8” OD x 1-1/4” ID Mounting Screws 6MM x 1.00, 15/64” long Hex Key 3mm Save This Manual You will need the manual fo

Résumé du contenu de la page N° 3

7. Use eye, face and ear protection. Always wear ANSI approved impact safety goggles. Wear a full face shield if you are producing metal filings or wood chips. Wear an ANSI approved dust mask or respirator when working around metal, wood, and chemical dusts and mists. Wearing work gloves is recommended. 8. Do not overreach. Keep proper footing and balance at all times. Do not reach over or across running machines. 9. Maintain tools with care. Keep tools sharp and clean for better and safer p

Résumé du contenu de la page N° 4

Unpacking When unpacking, check to make sure the following parts are included. Refer to the photo below. If any parts are missing or broken, please call Harbor Freight Tools at the number on the cover of this manual as soon as possible. Parts List/Diagram 4 PC: Hold down magnets 1 PC: Phenolic plate 1 PC: Guide pin 2 PC: Snap out rings 1 PC: Hex key 4 PC: Mounting screws PLEASE READ THE FOLLOWING CAREFULLY THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS MANUAL AS A RE

Résumé du contenu de la page N° 5

Router Table Insert Installation Instructions Note: The table may need to be cut and routed to accept this insert. 1. Decide how you want your router to be oriented in relation to the table. We suggest that the handles be aligned with the long dimension of the Table Insert. You also should consider the location of the switch, height adjustment knob & locking lever. 2. Be sure your Router Table Insert is in the proper position, with the starting pin holes to the right of the bit loca

Résumé du contenu de la page N° 6

Directions 1. The Guide Pin is used to create a starting position to push the stock material past the router bit. (see photo below) 2. There are 4 magnets that are included with this package. These are use to level the Router Table Insert on the table top. Place the magnets in the corners. They will adhere to the metal screws under them or a steel router table . 3. The Pop Out Rings are used to accommodate different size router bits. (see photo below) Warranty LIMITED 1 YEAR WARRANTY Harbor F