Résumé du contenu de la page N° 1
2E43-51/2E43-51R
SmartSwitch 2100
User’s Guide
LINK 1 12 LINK 1 12
E3 E4
E1 E2
ENET 3 ENET 4
LINK 1 12 LINK 1 12
PWR
RESET CPU
2E43-51
ENET 1 ENET 2 5 6
COM
9032251-04
Résumé du contenu de la page N° 2
Résumé du contenu de la page N° 3
Only qualified personnel should perform installation procedures. NOTICE Cabletron Systems reserves the right to make changes in specifications and other information contained in this document without prior notice. The reader should in all cases consult Cabletron Systems to determine whether any such changes have been made. The hardware, firmware, or software described in this manual is subject to change without notice. IN NO EVENT SHALL CABLETRON SYSTEMS BE LIABLE FOR
Résumé du contenu de la page N° 4
Notice INDUSTRY CANADA NOTICE This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications. Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites applicables aux appareils numériques de la class A prescrites dans le Règlement sur le brouillage radioélectrique édicté par le ministère des Communications du Canada.
Résumé du contenu de la page N° 5
Notice CABLETRON SOFTWARE PROGRAM LICENSE 1. LICENSE. You have the right to use only the one (1) copy of the Program provided in this package subject to the terms and conditions of this License Agreement. You may not copy, reproduce or transmit any part of the Program except as permitted by the Copyright Act of the United States or as authorized in writing by Cabletron. 2. OTHER RESTRICTIONS. You may not reverse engineer, decompile, or disassemble the Program. 3. APPLICABLE LAW. This
Résumé du contenu de la page N° 6
Notice SAFETY INFORMATION CLASS 1 LASER TRANSCEIVERS THE FE-100F3 FAST ETHERNET INTERFACE MODULE, FPIM-05 AND FPIM-07 FDDI PORT INTERFACE MODULES, AND APIM-29 ATM PORT INTERFACE MODULE USE CLASS 1 LASER TRANSCEIVERS. READ THE FOLLOWING SAFETY INFORMATION BEFORE INSTALLING OR OPERATING THESE MODULES. The Class 1 laser transceivers use an optical feedback loop to maintain Class 1 operation limits. This control loop eliminates the need for maintenance checks or adjustments. The
Résumé du contenu de la page N° 7
Notice DECLARATION OF CONFORMITY Application of Council Directive(s): 89/336/EEC 73/23/EEC Manufacturer’s Name: Cabletron Systems, Inc. Manufacturer’s Address: 35 Industrial Way PO Box 5005 Rochester, NH 03867 European Representative Name: Mr. J. Solari European Representative Address: Cabletron Systems Limited Nexus House, Newbury Business Park London Road, Newbury Berkshire RG13 2PZ, England Conformance to Directive(s)/Product Standards: EC Directive 89/336/EEC EC Dir
Résumé du contenu de la page N° 8
Notice vi 2E43-51/2E43-51R User’s Guide
Résumé du contenu de la page N° 9
CONTENTS CHAPTER 1 INTRODUCTION 1.1 Using This Guide......................................................................... 1-1 1.2 Structure of This Guide................................................................ 1-1 1.3 2E43-51 Overview....................................................................... 1-3 1.3.1 Connectivity .................................................................... 1-4 1.3.2 Full Duplex Switched Ethernet........................................
Résumé du contenu de la page N° 10
Contents 3.5 Connecting to the Network...........................................................3-9 3.5.1 Connecting Cables to ENETs 1 Through 4 .....................3-9 3.5.2 Connecting a UTP Segment to the FE-100TX ..............3-11 3.5.3 Connecting a Fiber Optic Segment to the FE-100FX and FE-100F3..............................................3-14 3.6 Completing the Installation.........................................................3-16 CHAPTER 4 TROUBLESHOOTING 4.1 Using LANVIEW.
Résumé du contenu de la page N° 11
Contents 5.8 SNMP Community Names Screen ............................................ 5-31 5.8.1 Establishing Community Names................................... 5-32 5.9 SNMP Traps Screen.................................................................. 5-34 5.9.1 Configuring the Trap Table ........................................... 5-35 5.10 Switch Configuration Screen ..................................................... 5-36 5.10.1 Setting the STA..........................................
Résumé du contenu de la page N° 12
Contents 5.25 Repeater Statistics Screen ........................................................5-81 5.25.1 Displaying Repeater Statistics.......................................5-84 5.25.2 Using the Clear Counters Command ............................5-84 5.26 Network Tools ............................................................................5-85 5.26.1 Built-in Commands........................................................5-86 5.26.2 Special Commands ........................
Résumé du contenu de la page N° 13
CHAPTER 1 INTRODUCTION Welcome to the 2E43-51/2E43-51R SmartSwitch 2100 User’s Guide. This guide provides the necessary documentation to install and operate the 2E43-51 and the 2E43-51R SmartSwitch 2100 devices and provides information concerning network requirements, installation, troubleshooting, and the use of Local Management. 1.1 USING THIS GUIDE Read through this guide to completely understand the 2E43-51 and 2E43-51R capabilities and Local Management functions. A
Résumé du contenu de la page N° 14
Chapter 1: Introduction Chapter 5, Local Management, describes how to access and use Local Management to configure and manage the 2E43-51. Appendix A, Specifications, contains information on functionality and operating specifications, connector pinouts, environmental requirements, and physical properties. Appendix B, FE-100TX, FE-100FX, and FE-100F3 Specifications, contains information about FE-100TX pinouts and information concerning cable types used with the FE-100FX and FE-100F
Résumé du contenu de la page N° 15
2E43-51 Overview 1.3 2E43-51 OVERVIEW The 2E43-51 (Figure 1-1) is a repeater/switch device that provides four Ethernet networks (MicroLANs ENET 1 through 4), each consisting of 12 repeater ports that share a bandwidth of 10 Mbps. Each Ethernet network supports 802.1D switching (bridging), and Cabletron Systems SecureFast Switching Virtual Network technology. Interface Receive (RX) Transmit (TX) Port LINK LEDs LEDs Optional HSIM Slot (12 ports/MicroLAN) LINK 1 12 LINK 1 12 E3 E4 E1 E2 E
Résumé du contenu de la page N° 16
Chapter 1: Introduction The 2E43-51R has two power supplies. The power supplies load share 50% (+/-5%) of the power required by the device. If one power supply fails, the remaining power supply assumes the entire load of the device without interruption to network traffic. Each power supply module supports its own ac input connection, which allows the user to connect each power supply to a different ac power circuit. 1.3.1 Connectivity The 2E43-51 connects to Ethernet networks or w
Résumé du contenu de la page N° 17
2E43-51 Overview When Auto-Negotiation is supported at both ends of a link, the two devices dynamically adjust to full or half duplex operation based on the maximum capability that can be reached between the two devices. If the device connected to the FE-100TX cannot auto-negotiate, the FE-100TX Fast Ethernet Interface Module operates according to the capabilities of the other device. 1.3.4 SmartTrunk SmartTrunk, also referred to as SmartTrunking, is Cabletron Systems’ termi
Résumé du contenu de la page N° 18
Chapter 1: Introduction The RAD requests start out at an interval of 1 second. The interval then doubles after every transmission until an interval of 300 seconds is reached. At this point, the interval remains at 300 seconds. The RAD requests continue until an IP address is received from a BootP server, or an IP address is entered using Local Management. 1.3.6 Management Management of the 2E43-51 is accomplished using SNMP compliant management tools for in-band Local Management.
Résumé du contenu de la page N° 19
Optional Features 1.3.9 Year 2000 Compliant The 2E43-51 has an internal clock that can maintain the current time and date beyond the year 1999. 1.3.10 LANVIEW Diagnostic LEDs LANVIEW diagnostic LEDs serve as an important troubleshooting aid by providing an easy way to observe the status of individual ports and overall network operations. 1.4 OPTIONAL FEATURES Options for the 2E43-51 include the following: • Fast Ethernet Interface Modules • High Speed Interface Modules 1.4.
Résumé du contenu de la page N° 20
Chapter 1: Introduction 1.4.2 High Speed Interface Modules High Speed Interface Modules (HSIMs) are available from Cabletron Systems for additional connectivity to various networking technologies. The HSIMs available for the 2E43-51 are listed in the Release Notes shipped with the 2E43-51. 1.5 DOCUMENT CONVENTIONS The following conventions are used throughout this document: Note symbol. Calls the reader’s attention to any item of NOTE information that may be of special impo
