Résumé du contenu de la page N° 1
KDC-W7027
KDC-7027
CD-RECEIVER
INSTRUCTION MANUAL
© B64-2750-00/02 (EV/E2V)
Résumé du contenu de la page N° 2
Contents Safety precautions 3 GSM Hands Free Unit control features 28 Receiving a call Notes 5 Phone Book Search Direct Dial Notes on playing MP3/WMA 6 SMS (Short Message Service) Mode About CDs 8 Phone Book/ Message (SMS) data synchronize Menu system 31 Notes on Multi-function Key System 9 Menu System General features 10 Security Code Phone voice speaker setting Power Microphone sensitivity adjust Hiding the Control Panel Auto Response time Adjust Selecting the Source Touch Sensor Tone Volume A
Résumé du contenu de la page N° 3
Safety precautions 2WARNING 2CAUTION To prevent injury or fire, take the To prevent damage to the machine, take following precautions: the following precautions: • Insert the unit all the way in until it is fully locked • Make sure to ground the unit to a negative 12V in place. Otherwise it may fall out of place when DC power supply. jolted. • Do not open the top or bottom covers of the unit. • When extending the ignition, battery, or ground • Do not install the unit in a spot exposed to dire
Résumé du contenu de la page N° 4
Safety precautions About CD players/disc changers NOTE connected to this unit • If you experience problems during installation, KENWOOD disc changers/ CD players released in consult your Kenwood dealer. 1998 or later can be connected to this unit. • If the unit fails to operate properly, press the Reset Refer to the catalog or consult your Kenwood button. The unit returns to factory settings when dealer for connectable models of disc changers/ the Reset button is pressed. If the unit stil
Résumé du contenu de la page N° 5
Notes Cleaning the Unit The marking of products using lasers If the faceplate of this unit is stained, wipe it with a (Except for some areas) dry soft cloth such as a silicon cloth. If the faceplate is stained badly, wipe the stain off CLASS 1 with a cloth moistened with neutral cleaner, then wipe neutral detergent off. LASER PRODUCT The label is attached to the chassis/case and says • Applying spray cleaner directly to the unit may affect its that the component uses laser beams that have
Résumé du contenu de la page N° 6
Notes on playing MP3/WMA KDC-W7027 can play MP3 (MPEG1, 2 Audio Layer For recording on an empty disc up to the maximum 3)/WMA. Note, however, that the MP3/WMA capacity at once, check Disc at Once. recording media and formats acceptable are limited. When writing MP3/WMA, pay attention to • Play mode may not be possible when portions of the the following restrictions. functions of Windows Media Player 9 or higher are used. Acceptable media Entering ID3 tag The MP3/WMA recording media acceptabl
Résumé du contenu de la page N° 7
MP3/WMA playing order When selected for play, Folder Search, File Search, When a File Search is executed with file ¡$ or for Folder Select, files and folders are accessed being played ... in the order in which they were written by the CD Operation of writer. (Current file: ¡$) the button Because of this, the order in which they are expected to be played may not match the order in 4 Button Beginning of file ¡$ ➜ ¡# which they are actually played. You may be able to ¢ Button ¡% ➜ ¡& set t
Résumé du contenu de la page N° 8
About CDs Handling CDs Removing CDs • Don’t touch the recording surface of the CD. When removing CDs from this unit pull them out horizontally. CDs that can’t be used • CDs that aren’t round can’t be used. • CD-R and CD-RW are easier to damage than a normal music CD. Use a CD-R or a CD-RW after reading the caution items on the package etc. • Don’t stick tape etc. on the CD. • CDs with coloring on the recording surface or that Also, don’t use a CD with tape stuck on it. are dirty can’t be use
Résumé du contenu de la page N° 9
Notes on Multi-function Key System Multi-function Key System serves to control various Real operational example of the Multi- functions with the [2] — [5] buttons. function Key System The basic operation of the Multi-function Key Example: Turning ON/OFF the Random Play during System is described below. CD play. 1. Show the function display of the Random Play. If "RDM" is not shown in the display, press the What’s the Multi-function Key System? [NEXT] button to switch the sections until the
Résumé du contenu de la page N° 10
General features ATT 1–6 NEXT SRC TI VOL Q SCRL/ AM/ FM 4 ¢ NAME.S SW indicator ATT indicator Function display Power Hiding the Control Panel Prevents tampering with the unit while your car is Turning ON the Power being serviced etc. Turn the vehicle ignition ON. The panel appears. Hiding the control panel Press the [SRC] button for at least 1 second. When the time set in 'OFF Wait Time Setting' • When the power is ON, the 'Security Code' (page 32) (page 34) lapses, the panel is hidden and t
Résumé du contenu de la page N° 11
Selecting the Source Sound setting Display Flat "Flat" Press the [SRC] button. User memory "User" Rock "Rock" Source required Display Pops "Pops" Tuner "TUNER" Easy "Easy" CD "CD" Top 40 "Top40" External disc (Optional accessory) "CD CH"/"CD2" Jazz "Jazz" Auxiliary input "AUX" Standby (Illumination only mode) "STANDBY" • User memory: The values set on the 'Audio Control' (page 12). • This unit automatically turns full power OFF after 20 • Each setting value is changed with the 'Speaker minute
Résumé du contenu de la page N° 12
General features Audio Control • The Adjustment item can also be controlled by the 1 Select the source for adjustment rotary volume knob. Refer to 'Rotary Volume knob Press the [SRC] button. operation mode select'(page 13). 2 Select the key function section 7 Exit Audio Control mode Press the [NEXT] button. Press the [6] button. Repeatedly press the button until "AUD" is displayed above the [2] button. Refer to 'Notes on Multi-function Key System' • The loudness setting can also be adjuste
Résumé du contenu de la page N° 13
2nd section Rotary Volume knob operation mode select [2] button The rotary volume knob can be used for volume Adjustment Item Display Range adjustment and various function setups. Front/Rear High Pass Filter "HPF" THRU/100/125/170 Hz Available setup functions [3] button The rotary volume knob can be used for the Adjustment Item Display Range following setup: Subwoofer Low Pass Filter "LPF SW" 50/80/120/THRU Hz • Menu system : Item selection • Audio Control : Adjustment of setup value [4] bu
Résumé du contenu de la page N° 14
General features - CA-C1AX In External disc, or Auxiliary input source - External disc changer/ player Dual Zone System • While Dual Z one System is ON, the setting of Dual Zone System Front or Rear is disabled. Makes the sound different for the front channel Set Dual Zone System Front or Rear first, and then set and rear channel. the Dual Zone System to ON. Output the Internal source sound from either one • When the Dual Z one System is ON, there is no Dual of the front or rear channels, a
Résumé du contenu de la page N° 15
In Auxiliary input source Text Display Switching Information Display Switching the text display. Auxiliary input name "AUX Name" 1 Select the key function section Clock "Clock" Press the [NEXT] button. Repeatedly press the button until "DISP" is In Standby displayed above the [3] button. Information Display Refer to 'Notes on Multi-function Key System' "STANDBY" (page 9). Clock "Clock" 2 Enter display control mode 4 Exit Display Control mode Press the [3] ("DISP") button. Press the [6] button.
Résumé du contenu de la page N° 16
General features at that time is selected, and Auxiliary input display External Display Switching setting mode closes. Switching the display in the External Display • The Auxiliary Input Display can be set only when the connected. built-in auxiliary input or the auxiliary input of optional KCA-S210A is used. 1 Select the key function section Press the [NEXT] button. Repeatedly press the button until "DISP" is displayed above the [3] button. Panel Position Setting Refer to 'Notes on Multi-fu
Résumé du contenu de la page N° 17
Theft Deterrent Panel TEL Mute The Backpanel of the unit can be detached and The audio system automatically mutes when a taken with you, helping to deter theft. call comes in. Removing the Backpanel When a call comes in "CALL" is displayed. 1 Turn the ignition OFF or press the [SRC] The audio system pauses. button for at least 1 second. Turn OFF the power, and the control panel Listening to the audio during a call becomes horizontal. Press the [SRC] button. The "CALL" display disappears and t
Résumé du contenu de la page N° 18
Tuner features 1–6 NEXT SRC TI AM FM 4 ¢ ST indicator Preset station number Band display Frequency display Tuning Station Preset Memory Selecting the station. Putting the station in the memory. 1 Select tuner source 1 Select the band Press the [SRC] button. Press the [FM] or [AM] button. Select the "TUNER" display. 2 Select the frequency to put in the memory 2 Select the band Press the [4] or [¢] button. Press the [FM] or [AM] button. 3 Select the key function section Each time the [FM] button i
Résumé du contenu de la page N° 19
Auto Memory Entry Preset Tuning Putting a station with good reception in the Calling up the stations in the memory. memory automatically. 1 Select the band 1 Select the band for Auto Memory Entry Press the [FM] or [AM] button. Press the [FM] or [AM] button. 2 Select the key function section 2 Enter Menu mode Press the [NEXT] button. Press the [MENU] button for at least 1 second. Repeatedly press the button until the function "MENU" is displayed. item is not displayed above the [2] — [5] button.
Résumé du contenu de la page N° 20
RDS features 1–6 NEXT TI PTY TI SCRL AM FM 4 ¢ TI indicator PTY indicator RDS indicator Traffic Information Radio Text Scroll Switching to traffic information automatically Scrolling the displayed radio text. when a traffic bulletin starts even when you aren’t Press the [SCRL] button. listening to the radio. Press the [TI] button. Each time the button is pressed the Traffic PTY (Program Type) Information function turns ON or OFF. When it’s ON, "TI" indicator is ON. Selecting the Program Type a
