Résumé du contenu de la page N° 1
Operating and installation instructions
Ventilation System
DA 289-3
UV
To prevent accidents
and machine damage,
read these instructions
before installation or use. M.-Nr. 05 853 730
Résumé du contenu de la page N° 2
Table of contents IMPORTANT SAFETY INSTRUCTIONS Functional description Guide to the hood Operation Main power switch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 Turning on the fan . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 Selecting the power level. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 Delayed Shut Down . . . . . . . . . . . . . .
Résumé du contenu de la page N° 3
IMPORTANT SAFETY INSTRUCTIONS Read these Operating Instructions carefully before installing or using the Ventilation System. This appliance is designed to vent This appliance is intended for cooking smoke and odors only. residential use only. Use the Be certain your appliance is prop- appliance only for its intended erly installed and grounded by a purpose. The manufacturer cannot qualified technician. be held responsible for damages To guarantee the electrical safety of this caused by improper
Résumé du contenu de la page N° 4
IMPORTANT SAFETY INSTRUCTIONS This equipment is not designed for Use maritime use or for use in mobile Do not allow children to play with installations such as caravans or air- or operate the appliance or its craft. However, under certain conditions controls. Supervise its use by the it may be possible for an installation in elderly or infirm. these applications. Please contact the nearest Miele dealer or the Miele Tech- Be careful when preparing a nical Service Department with specific flambé b
Résumé du contenu de la page N° 5
IMPORTANT SAFETY INSTRUCTIONS , WARNING - TO REDUCE , WARNING TO REDUCE THE RISK OF INJURY THE RISK OF A RANGE TOP TO PERSONS IN THE EVENT OF A GREASE FIRE: RANGE TOP GREASE FIRE, Never leave surface units unat- OBSERVE THE FOLLOWING: tended at high settings. Boilovers SMOTHER FLAMES with a close cause smoking and greasy spillovers fitting lid, cookie sheet, or metal may ignite. Heat oils slowly on low or tray, then turn off the burner. medium settings. BE CAREFUL TO PREVENT BURNS. Always turn h
Résumé du contenu de la page N° 6
IMPORTANT SAFETY INSTRUCTIONS Installation Never connect an exhaust hood to an active chimney, dryer vent, vent , WARNING flue, or room ventilating ductwork. Seek To reduce the risk of fire, use professional advice before connecting only metal ductwork. an exhaust hood vent to an existing, When installing the hood, make inactive chimney or vent flue. sure that a minimum safety dis- Ducted fans must always be 3 tances of 14 / " is maintained between 8 vented outdoors. a Miele cooktop and the bott
Résumé du contenu de la page N° 7
Functional description The ventilation hood works by air ex- traction. The air is drawn in through the air intake panel, cleaned by the grease filter and directed outside. The hood comes equipped with a non-return flap. This flap automatically closes when the hood is turned off so that no exchange of outside air and room air can occur. When the hood is turned on, the air pressure of the ex- haust fan automatically opens the flap blowing the inside air and cooking odors outside. 7
Résumé du contenu de la page N° 8
Guide to the hood 8
Résumé du contenu de la page N° 9
Guide to the hood a Chimney extension i Light button This button turns the light on and off b Chimney and also dims the light. The lighting can be used independently c Canopy of the fan. d Control panel j On/Off button e Overhead lighting k Fan power selection Four fan speed selection f Main power switch l Delayed shut down g Grease filter This button activates the Delayed Shut h Air intake panel Down feature. The fan can be set to turn off automatically after either 5 or 15 minutes. m Grease fi
Résumé du contenu de la page N° 10
Operation Main power switch Selecting the power level ^ Use the_ controls to select the ^ Remove the air intake panel to ac- desired power level. cess the main power switch (see "Cleaning and Care"). & =increases the fan speed ^ Press the main power switch to "I". $ =decreases the fan speed The fan and lighting are ready to use. Level "1" to "3" (green indicators) are If the appliance is not going to be used usually sufficient for normal cooking. for a long period of time (e.g. while va- cationi
Résumé du contenu de la page N° 11
Operation Delayed Shut Down Turning the lighting on/off If odors or smoke remain in the kitchen The overhead lighting can be turned after cooking has been completed, the on and off independently of the fan. Delayed Shut Down feature can be se- lected to allow the hood to continue running for either 5 or 15 minutes. ^ Press the light button briefly to turn on the lighting. The light button indicator illuminates. ^ Press the Delayed Shut Down button while the fan is still running. ^ Press the lig
Résumé du contenu de la page N° 12
Operation Grease filter timer Checking the grease filter timer A timer monitors the hours of fan opera- To check the percentage of time al- tion. The indicator for the grease filter ready used: will light after 30 hours of operation. The grease filter and air intake panel must then be cleaned. After the grease filter has been cleaned and put in place, the grease filter timer ^ Press the On/Off button to turn the must be reset. fan on. ^ To do this, press the grease filter but- ^ Press the greas
Résumé du contenu de la page N° 13
Operation Reprogramming the grease filter timer The grease filter timer is preset to 30 hours. This time can be lengthened or ^ Press the On/Off button to turn off the shortened to 20, 30, 40 or 50 hours. fan. – A time of 20 hours should be pro- grammed in kitchens with frequent pan or deep frying. – A time of 20 hours should also be programmed if the kitchen is only ^ Press the Delayed Shut Down and used occasionally to prevent grease grease filter buttons at the same time. which has accumulate
Résumé du contenu de la page N° 14
Cleaning and care Grease filter and air intake Removing the air intake panel panel The reusable metal grease filter re- moves solid particles from the vented kitchen air (grease, dust, etc). The grease filter and the air intake panel should be cleaned every 3 - 4 weeks or whenever the grease filter in- dicator lights. Keep the grease filter clean to pre- ^ To remove the air intake panel gently vent a fire hazard. pull out and downward, shifting the lower part a bit to the right. Lift it out of t
Résumé du contenu de la page N° 15
Cleaning and care ^ Clean the filter - by hand: use a scrub brush in warm water with a mild detergent. - in a dishwasher: place the filters in the lower basket, making sure that the spray arm is not blocked. Depending on the detergent, clean- ing the grease filter in a dishwasher may cause permanent discoloration of the filter surface. Performance of the filter will not be affected by this discoloration. ^ After cleaning, the filter can be ^ Push the grease filter back in place. placed on a towe
Résumé du contenu de la page N° 16
Cleaning and care Stainless steel Before cleaning or servicing the hood, disconnect it from the power Stainless steel surfaces can be cleaned supply by either removing the fuse, using a non-abrasive stainless steel unplugging it from the outlet or man- cleaner. ually "tripping" the circuit breaker. To help prevent resoiling, a conditioner for stainless steel can also be used. Cleaning the casing Apply sparingly with even pressure. ,Never use abrasive cleaners, Stainless steel colored controls sc
Résumé du contenu de la page N° 17
Cleaning and care Changing the light bulbs Before changing the light bulbs, dis- connect the hood from the power supply by either removing the fuse, unplugging it, or manually "tripping" the circuit breaker. When in use halogen bulbs become extremely hot, and they can burn your hands. Do not attempt to change the bulbs until they have had sufficient time to cool down. ^ Pull the old bulb out of its socket us- ing the enclosed lever. Replace it Do not touch the bulb surface. Fin- with a new one.
Résumé du contenu de la page N° 18
After Sales Service In the event of a fault which you cannot correct yourself please contact: – Your Miele Dealer or – The Miele Technical Service Department USA 1-800-999-1360 techserv@mieleusa.com CDN 1-800-565-6435 service@miele.ca When contacting the Technical Service Department, please quote the model and serial number of your appliance. These are shown on the data plate which is visible when the grease filter is removed. 18
Résumé du contenu de la page N° 19
Installation instructions
Résumé du contenu de la page N° 20
Table of contents Caring for the environment Installation accessories Plywood backing Electrical data Appliance dimensions Installation Installation instruction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 28 Dismantling . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 28 Air extraction Condensate trap . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
