Résumé du contenu de la page N° 1
Canister Steam Cleaner
MODEL SF-275
User’s Guide
Please read all instructions before use.
KEEP YOUR RECEIPT FOR WARRANTY PURPOSES.
Résumé du contenu de la page N° 2
IMPORTANT SAFETY INSTRUCTIONS WARNING: To reduce risk of fire, electrical shock or injury, the following basic safety precautions should always be followed when using an electrical appliance. WARNING: To reduce the risk of electrical shock, this appliance uses a grounded (three-pronged) plug. This plug will fit in a grounded wall outlet only one way. If the plug does not correctly fit in the outlet, contact a licensed electrician to install a proper outlet. DO NOT attempt to modify the plug
Résumé du contenu de la page N° 3
10. Do not use unit where aerosol-based products are being used, or where oxygen is being administered. 11. Unit is only meant to be used with recommended Canister Steam Cleaner (model SF-275) accessories. Using other types of attachments may cause damage to unit or injury. 12. If Lighted On/Off Switch does not illuminate when set to “ON” position while power cord is plugged in, unit is not operating normally. Immediately disconnect cord from power supply, then refer
Résumé du contenu de la page N° 4
Product Information The following features and accessories are included with your Canister Steam Cleaner. Carefully inspect the packing material for all parts listed below. To obtain possible missing parts, refer to Product Support on Page 14 of this manual. UNIT FEATURES & ACCESSORIES 1 Lighted On/Off Switch 2 Steam Ready Light 3 Storage Compartment 4 Boiler (internal) 5 Handle 6 Steam Lock Switch 7 Steam Button 8 Carry Handle 9 Main Nozzle 10 Steam Hose 1 1 Steam Jet Nozzle 12 Extension Wa
Résumé du contenu de la page N° 5
The Lighted On/Off Switch (1) activates and deactivates the unit, and illuminates to provide a • clear visual indication of whether the unit is powered on. The Steam Ready Light (2) illuminates while the Boiler is heating, then turns off when the unit is • ready to begin steaming. The Storage Compartment (3) provides a convenient place to store small accessories; it also • houses the Boiler cap. The Boiler (4) is the internal reservoir in which water is stored and heated. It is
Résumé du contenu de la page N° 6
Assembling Your Canister Steam Cleaner STEAM MOPPING ACCESSORIES WARNING: Do not try to connect accessories while unit is emitting steam. EXTENSION WANDS 1. Select one of the Extension Wands, and align rear end of wand with Main Nozzle. Rectangular hole in wand should align with gray lock/release button on nozzle. 2. Press down on gray lock/release button. While continuing to hold button down, slide Extension Wand onto Main Nozzle (FIGURE 1-A). Push wand over button, and continue pushi
Résumé du contenu de la page N° 7
MICROFIBER PADS 1. Lay one Microfiber Pad on flat surface, with two fastener strips facing upward. 2. Align Mop Head above Microfiber Pad. Make sure Mop Head is oriented with pad as shown, and centered as best as possible (FIGURE 3-A). 3. Press Mop Head firmly down onto Microfiber Pad. Fastener strips will adhere to pad grips on underside of Mop Head. Microfiber Pad should now be attached and ready for use (FIGURE 3-B). CAUTION: Use care when handling a recently used Microfiber P
Résumé du contenu de la page N° 8
Assembling Your Canister Steam Cleaner STEAM CLEANING ACCESSORIES WARNING: Do not try to connect accessories while unit is emitting steam. STEAM JET NOZZLE / SQUEEGEE / TRIANGLE BRUSH 1. Select one of the three accessories (Steam Jet Nozzle, Squeegee or Triangle Brush – Steam Jet Nozzle shown as example), and align rear end of accessory with Main Nozzle. Rectangular hole in accessory should align with gray lock/release button on Main Nozzle. 2. Press down on gray lock/release button (F
Résumé du contenu de la page N° 9
SCRUB PAD NOTE: Scrub Pad connects to the Steam Jet Nozzle, not the Main Nozzle. 1. Place Scrub Pad over tip of Steam Jet Nozzle, and firmly press it on to Steam Jet Nozzle as far as possible (FIGURE 6). This will help to prevent steam leakage. 2. To remove Scrub Pad, simply grip it firmly and pull it off of Steam Jet Nozzle. FIGURE 6 CARRY HANDLE 1. Insert Carry Handle into hole on top of unit. Align handle so that grip bracket faces towards front of unit (FIGURE 7). 2. U
Résumé du contenu de la page N° 10
Using Your Canister Steam Cleaner FILLING BOILER 1. Place Canister Steam Cleaner on a flat, level surface. 2. Make sure Lighted On/Off Switch is set to “OFF” position and grounded power cord is unplugged from electrical outlet. 3. Flip Storage Compartment lid open, and cautiously unscrew and remove Boiler cap. 4. Drain any water remaining inside Boiler into a sink or tub. NOTE: Boiler should be emptied after each use – this will help minimize mineral build-up and prevent over-filli
Résumé du contenu de la page N° 11
GENERAL OPERATION NOTE: Be sure that Boiler has been filled and that all desired accessories are connected before following these steps. 1. For first time use, remove protective plastic cover from electrical plug. Plug power cord into a convenient electrical outlet. 2. Switch Lighted On/Off Switch to “ON” position. Steam Ready Light will immediately illuminate, indicating that unit is heating. 3. Steam Ready Light will turn off in 2-8 minutes (depending on how much water is in Boiler)
Résumé du contenu de la page N° 12
Storage & Care PROPER STORAGE Preparing your Canister Steam Cleaner for storage is quick and simple. When you have finished your steaming tasks, follow the steps listed below. 1. Set Lighted On/Off Switch to “OFF” position and unplug power cord from electrical outlet. 2. Allow unit to cool (at least 30 minutes for complete cooling). 3. Press and hold Steam Button to release all remaining steam pressure. 4. Remove all accessories from unit. 5. Flip Storage Compartment lid open and remove Boiler
Résumé du contenu de la page N° 13
Troubleshooting PROBLEM POSSIBLE CAUSE SOLUTION Unit fails to heat up. Lighted On/ Unit is not plugged in. Plug power cord into electrical outlet. Off Switch DOES NOT illuminate Household circuit breaker / ground Reset circuit breaker / ground when set to “ON” position. fault interrupter has tripped or fault interrupter, or replace fuse. blown a fuse. If you need assistance, contact a licensed electrician. Unit is damaged or otherwise in Immediately cease usage and need of repair. unplug.
Résumé du contenu de la page N° 14
Product Support CONSUMER SERVICES For problems with your Canister Steam Cleaner, please refer to the troubleshooting guide located on Page 13 of this manual. Additional inquiries should be directed to our consumer support services through our web site, www.steamfast.com. If you do not have Internet access, you may also contact our Consumer Service Department by telephone, at 1-800-711-6617. NOTE: In order for our Consumer Service representatives to help you as quickly and efficiently as poss
Résumé du contenu de la page N° 15
Warranty Information 1 YEAR LIMITED WARRANTY Steamfast, a division of Vornado Air LLC, (“Steamfast”) warrants to the original consumer or purchaser this Steamfast Canister Steam Cleaner model SF-275 (“Product”) is free from defects in material or workmanship for a period of one (1) year from the date of purchase. If any such defect is discovered within the warranty period, Vornado, at its discretion, will repair or replace the Product at no cost if the Product is returned to Steamfast posta
Résumé du contenu de la page N° 16
review this product online evalúe este producto en línea évaluer ce produit en ligne www.steamfast.com/reviews Steamfast 415 East 13th, Andover, KS 67002 1-800-711-6617 www.steamfast.com consumerservice@steamfast.com V110512
