Résumé du contenu de la page N° 1
EXCELLENCE
by
H-CMD4006
MULTIMEDIA DVD/CD/MP3 RECEIVER WITH BUILT-IN
4” DIGITAL TFT DISPLAY
Instruction manual
МУ ЛЬ ТИМЕДИЙНЫЙ DVD/CD/MP3- РЕСИВЕР СО ВСТР ОЕННЫМ
4” ЦИФР О ВЫМ TFT ДИСПЛЕЕМ
Рук ов о дств о по эк сплу а т ации
Résumé du contenu de la page N° 2
Dear customer! Thank you for purchasing our product. For safety, it is strongly recommended to read this manual carefully before connecting, operating and/or adjusting the product and keep the manual for reference in the future. Table of contents Table of contents.....................................................................................................................................................2 Important safeguards .........................................................
Résumé du contenu de la page N° 3
Important safeguards • Using the device at temperature below -10º С may cause the breakage of the device. BEFORE USING PLEASE HEAT UP THE PASSENGER COMPARTMENT TO THE RECOMMENDED TEMPERATURE! • Read carefully through this manual to familiarize yourself with this high-quality sound system. • Disconnect the vehicle's negative battery terminal while mounting and connecting the unit. • When replacing the fuse, be sure to use one with an identical amperage rating. Using a fuse with a higher a
Résumé du contenu de la page N° 4
Installation/ connection First complete the electrical connections, and then check them for correctness. Installation opening This unit can be installed in any dashboard having an opening as shown on the picture. The dashboard should be 4.75 – 5.56 mm thick in order to be able to support the unit. 1. Insert mounting collar into the dashboard, and bend the mounting tabs out with a screwdriver. Make sure that lock lever is flush with the mounting collar (not projecting outward). 2.
Résumé du contenu de la page N° 5
Detachable control panel Detaching the control panel • Turn the Power off. • Press OPEN button release the panel. • Pull the panel out. Attaching the control panel • Insert the left side of the control panel into the main unit. • Press the control panel right side until the “click” sound is heard. Caution: DO NOT insert the control panel from the right side. It can damage the control panel. The control panel can easily be damaged by shocks. After removing it, place it in a protect
Résumé du contenu de la page N° 6
Electrical connection 6
Résumé du contenu de la page N° 7
Caution: Do not interchange the connection of the wiring!!! For some car models you may need to modify wiring of the supplied power cord. Contact your authorized car dealer before installing this unit. Using the ISO Connector 1. If your car is equipped with the ISO connector, then connect the ISO connectors as illustrated. 2. For connections without the ISO connectors, check the wiring in the vehicle carefully before connecting, incorrect connection may cause serious damage to this
Résumé du contenu de la page N° 8
Panel controls Front panel 1. EJECT button ( ): press it to flip down the front panel and eject the CD. 2. OK button: press it in the menu to confirm settings. 3. VOL+/- buttons: press to increase/decrease volume step by step. TUN-/TUN+ buttons: use these buttons to enter the manual tuning mode/ seek tuning mode. ▲/ ▼/ ◄/ ► buttons: in the menu press these buttons to navigate. 4. TFT display 5. MODE button: Press it to select the RADIO, DISC (if there is a disc
Résumé du contenu de la page N° 9
7. POWER/MUTE button: press POWER button to turn the power on, press and hold for 2 seconds to turn the power off. When the power is on press it to cut down the volume output, press it again to resume volume. 8. OPEN button: press it when power is off to release the front panel. 9. AF/REG button: press it to select AF (alternative frequency) function ON or OFF. Press and hold for 2 seconds to turn the Regional mode ON or OFF. 10. TA/EON button: press it to select TA (traffic announceme
Résumé du contenu de la page N° 10
Remote control 1. DUAL button - press it to enter the Dual zone mode for playing DVD and Radio at the same time. 2. STANDBY button – press it to turn the power on/off. 3. OSD button - Press the OSD button to show the current mode information on the display. 4. EJECT button - press it to eject the disc. 5. SETUP button – in DVD mode press it to open the setup menu. 6. Cursor ▲/ ▼/ ◄/ ► buttons Use the ▲/ ▼/ ◄/ ► buttons to select the menu item. Use the ▲/ ▼ buttons to select the titl
Résumé du contenu de la page N° 11
13. PROG/PTY button – press this button to enter the title/chapter search function. In Radio mode press it to activate the PTY function. 14. RDM/BAND button – in DVD mode press it to start random playing. In Radio mode press it to select the desired band. 15. Digit area 16. TILT button - press it to adjust monitor tilt angle. 17. OPEN button - press it to open the monitor. 18. MODE button - press it to select the mode: RADIO, DISC (if there is a disc in unit), SD (if there is a SD car
Résumé du contenu de la page N° 12
Changing the battery 1. Press the catch and at the same time pull out the battery tray. 2. Insert the 1 x lithium battery, type CR 2025 3V battery with the stamped (+) mark facing upward. Insert the battery tray into the remote control. Warning: Store the battery where children cannot reach. If a child accidentally swallows the battery, consult a doctor immediately. Do not recharge, short, disassemble or heat the battery or dispose it in a fire. Do not expose or bring int
Résumé du contenu de la page N° 13
General operation Reset the unit Operating the unit for the first time or after replacing the car battery, you must reset the unit. Press the button and then press RESET button under the panel to restore the unit to the original factory settings. Power button Press any button to turn on the unit. Long press POWER button to turn off the unit. Monitor tilt angle Press the TILT button to enter the monitor tilt angle adjustment mode. Press the / buttons to select the position: 0 => 1 =
Résumé du contenu de la page N° 14
Setting the sound characteristics AUDIO Press shortly and repeatedly the SEL button to select the audio setting: BASS => 1. BASS TREBLE => BALANCE => FADER => DSP. 2. TREBLE Press ▲/ ▼ buttons on the panel or on the RC to select the setting. 3. BALANCE Press ◄/ ► buttons to adjust the setting. 4. FADER Press SEL again to confirm and return to current mode. 5. DSP Notes: If turning off the power all the settings of each mode will be saved. • If turning off the ACC power all the set
Résumé du contenu de la page N° 15
Mode setting Change playing mode in a sequence: RADIO, DISC (if there is a disc in unit), SD (if there is a SD card in unit), AUX IN mode. If you select RADIO mode, change radio band in sequence of: FM1, FM2, FM3, AM1, AM2. On-screen display (OSD) Press the OSD button to show the current mode information on the display. 15
Résumé du contenu de la page N° 16
Digital tuner Note: RDS (Radio Data System) service availability varies with areas. Please understand if RDS service is not available in you area, the following service is not available, either. Band selection Press MODE button to select the RADIO mode. Press the BAND button to select the desired band: FM1, FM2, FM3, AM1, AM2. Manual/ automatic tuning • Manual tuning: press the / buttons and hold for 2 seconds to enter the manual tuning mode. Press the / buttons on the panel o
Résumé du contenu de la page N° 17
Preset scan Press the RPT/P.SCN button on the RC to scan all preset stations in the memory of the current band and stay on each memory stations for about 5 seconds. To stop preset scan, press this button again. AF (Alternative Frequencies) function When the radio signal strength is poor, enable or disable AF function, press more than 2 seconds to enable or disable REG mode. (Default setting is On for AF and Off for REG) 1. Press ON to enable AF with current station. 2. AF icon is on LCD d
Résumé du contenu de la page N° 18
3. When PTY is selected, the radio starts to search corresponding PTY information, and stops if the corresponding PTY information is detected. If there are no keys entered for 2 seconds, previously selected PTY is searched. During 1 loop, if desired PTY is not found, NO PTY is flashed, then return to previous normal radio and PTY word disappears. rd 4. Press PTY button for the 3 time to switch the PTY function off. REG function Press for more than 2 seconds the AF/REG button to enable or d
Résumé du contenu de la page N° 19
SD cards operations Inserting the SD card 1. Turn the power on. 2. Press the OPEN button on the panel to detach it. 3. Insert the SD card into SD slot. Then the playing mode will be changed into SD Card mode automatically. The unit will read the files automatically. 4. To enter the SD mode automatically press the MODE button. SD notes 1. SD card support. 2. FAT 16/ FAT 32 is possible - FAT 16 (dir: 200 support, file:500 support), - FAT 32 (dir: 200 support, file:500 support). 4. Fil
Résumé du contenu de la page N° 20
Functions The Play/pause, Previous/next track/ FR/FF functions are same as for Discs (see the Discs operations chapter of this instruction manual). Discs operations Glossary PBC (PlayBack Control) PlayBack Control is a menu recorded on the disc with SVCD or VCD2.0 format. For the discs contained PBC, it can playback interactive software with the menu displayed on TV. And if the disc contains still images, it can playback high definition of still image. Title The title is the importan
