Résumé du contenu de la page N° 1
SANTO U
86000 i
Built-In Refrigerator
Operating and Installation Instructions
Résumé du contenu de la page N° 2
Dear customer, Before placing your new refrigerator/freezer into operation please read these operating instructions carefully. They contain important informa- tion for safe use, for installation and for care of the appliance. Please keep these operating instructions for future reference. Pass them on to possible new owners of the appliance. These operating instructions are for use with several technically com- parable models with varying accessories. Please observe the notes which apply to your
Résumé du contenu de la page N° 3
Contents Important Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Disposal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Appliance Packaging Information. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Disposal of old Appliances . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Remove transport packaging . . . . . . . . . . . . . . . . . . . . . . . . . .
Résumé du contenu de la page N° 4
Important Safety Instructions These warnings are provided in the interests of your safety. Ensure you fully understand them before installing or using the appliance. Your safety is of paramount importance. If you are unsure about the meaning of these warnings contact the Customer Care Department for assistance. Intended use • The refrigerator is intended for use in the home. It is suitable for the storing of food at low temperature. If the appliance is used for pur- poses other than those intend
Résumé du contenu de la page N° 5
Important Safety Instructions • Please make old appliances unusable prior to disposal. Pull out the mains plug, cut off the mains cable, break or remove spring or bolt catches, if fitted. By doing this you ensure that children cannot lock themselves in the appliance when playing (there is risk of suffoca- tion!) or get themselves into other dangerous situations. • Often children cannot recognise the hazards present in household appliances. It is therefore important that you ensure adequate super
Résumé du contenu de la page N° 6
Disposal Appliance Packaging Information All materials are environmentally sound! They can be disposed of or burned at an incinerating plant without danger. About the materials: The plastics can be recycled and are identified as follows: >PE< for polyethylene, e.g. the outer covering and the bags in the interior. >PS< for polystyrene foam, e.g. the pads, which are all free of chlo- rofluorocarbon. The carton parts are made from recycled paper and should be disposed of at a waste-paper recycling
Résumé du contenu de la page N° 7
Installation Installation Location The appliance should be set up in a well ventilated, dry room. Energy use is affected by the ambient temperature. The appliance should therefore – not be exposed to direct sunlight; – not be installed next to radiators, cookers or other sources of heat; – only be installed at a location whose ambient temperature corresponds to the climate classification, for which the appliance is designed. The climate classification can be found on the rating plate, which is l
Résumé du contenu de la page N° 8
Installation Grid preparation The side at which the door opens can be changed from the right side (as supplied) to the left side, if the installation site requires. Warning! When changing the side at which the door opens, remove plug from the mains. Left door opening: 1. Remove the left side (A) of the grid + cutting it from the rear (see figure). A 2. Remove the right side (B) of the grid cutting it from the rear (see figure). B DO002/2 3. Re-install the grid to the base of the appliance by p
Résumé du contenu de la page N° 9
Installation 6 7 8 2 Warning! After completion 10 of the door reversing opera- tion, check that the door gasket adheres to the cabi- 13 net. If the ambient temper- ature is cold (i.e. in Winter), the gasket may not fit per- fectly to the cabinet. In that case, wait for the natural 9 fitting of the gasket or accelerate this process by 12 heating up the part involved with a normal hairdryer on 11 a low setting. 3 9
Résumé du contenu de la page N° 10
600 550 min. Installation Building the appliance in under a worktop The dimensions of the recessed + installation area must correspond with those indicated in the figure. 1xB 2xC Installation kit + 1xA 12 2 1 2 2 1 1 1. Two cabinet securing brackets + are supplied with the installa- tion pack. They need to be assembled onto the cabinet prior to cabinet being pushed into the Kitchen aperture. Left hand Right hand bracket bracket 1/a 2. To fit these brackets remove the two screws at the top left a
Résumé du contenu de la page N° 11
596 Installation 4. Push the appliance into place. The plug socket nec- essary for connection of the appliance to the elec- tricity supply should be positioned, so that the plug is not placed in the recess. To adjust the height pro- ceed as follows: - + 5. Loosen or tighten the two Li89 2 front feet. 6. The rear feet are adjusted by turning the screw in the front kick plate to the left or right. 7. If necessary, pads are supplied for the rear feet to make sliding the appliance in and out of the
Résumé du contenu de la page N° 12
10 Installation 115° 4 8. Push the appliance into place and retain the cab- inet with screws through the securing brackets into the worktop or adjacent woodwork as necessary. 5 9. To mount the furniture door proceed as shown in the fig- 2 1 a ures: C 4 3 b 6 12
Résumé du contenu de la page N° 13
Installation 7 ab C clic C clic c 8 13
Résumé du contenu de la page N° 14
10 Installation Upper part of kitchen furniture panel 1 a Lower part of kitchen furniture panel 2 275 275 b 9 9/a 1 2 45 ° 3 10 = = 11 14 max 100 = =
Résumé du contenu de la page N° 15
Installation 12 10. Refit the covering strip. A 13 15
Résumé du contenu de la page N° 16
25 - 80 Installation Fitting the plinth Important! For the efficient operation of the appliance, it is important that the original ventilation grid is used. • For an opening height dimension A=820 mm and a plinth height dimension a=100 mm, the plinth may be fitted without adjustments. The same applies to an opening height dimension B=870 mm and a plinth height dimension b=150 mm. • For plinth heights greater than a=100 mm, b=150 mm, a cut should be made in the plinth, 580 mm wide, in the centre
Résumé du contenu de la page N° 17
Installation The mains cable may only be changed by a qualified electrician or competent person. If your appliance needs repairing, please contact your local AEG Service Force Centre. Electrical Connection Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. WARNING – THIS APPLIANCE MUST BE EARTHED The manufacturer declines any liability should these safety mea- sures not be observed. Before switching on, make sure the elect
Résumé du contenu de la page N° 18
Description of the appliance View of the appliance ¯ ˜ ` ˆ ´ Butter/cheese compartment Sliding shelf ` Bottle shelf ´ Vegetable drawers ˆ Storage shelves ˜ ¯ Thermostat Prior to Initial Start–Up Please clean the appliance interior and all accessories prior to initial + start-up (see section: “Cleaning and Care”). 18
Résumé du contenu de la page N° 19
Starting up and temperature regulation Important! Only use the appliance when built–in! 1. Connect the appliance to the mains electricity supply. + When the refrigerator compartment door is opened, the internal light- ing is switched on. The temperature control knob is located on the right hand side of the refrigerator compartment. Setting “0” means: Off. 2. Turn the control knob clockwise past “1”. The refrigerating unit is now on and operates automatically. AEG62 Setting “1” means: Hightest
Résumé du contenu de la page N° 20
Switching off the appliance To switch off the appliance, turn the temperature regulator to position + "0". If the appliance is not going to be used for an extended period: 1. Remove all refrigerated packages. + 2. Switch off the appliance by turning the thermostat knob to position "0". 3. Remove the mains plug or switch off or disconnect from the electricity supply. 4. Clean thoroughly (see section: “Cleaning and Care”). 5. Leave the door open to avoid the build up of odours. Interior Accessorie
