Résumé du contenu de la page N° 1
REFRIGERATOR
USER INSTRUCTIONS
THANK YOU for purchasing this high-quality product. If you should experience a problem not covered in TROUBLESHOOTING,
please visit our website at www.maytag.com for additional information. If you still need assistance, call us at 1-800-688-9900.
In Canada, visit our website at www.maytag.ca or call us at 1-800-807-6777.
You will need your model and serial number, located on the inside wall of the refrigerator compartment.
Table of Contents / Índice / Tab
Résumé du contenu de la page N° 2
IMPORTANT SAFETY INSTRUCTIONS WARNING: To reduce the risk of fire, electric shock, or injury when using your refrigerator, follow these basic precautions: ■ Plug into a grounded 3 prong outlet. ■ Use nonflammable cleaner. ■ Do not remove ground prong. ■ Keep flammable materials and vapors, such as gasoline, away from refrigerator. ■ Do not use an adapter. ■ Use two or more people to move and install refrigerator. ■ Do not use an extension cord. ■ Disconnect power before installing ice maker (
Résumé du contenu de la page N° 3
Location Requirements Electrical Requirements WARNING WARNING Explosion Hazard Electrical Shock Hazard Keep flammable materials and vapors, such as Plug into a grounded 3 prong outlet. gasoline, away from refrigerator. Do not remove ground prong. Failure to do so can result in death, explosion, or fire. Do not use an adapter. Do not use an extension cord. To ensure proper ventilation for your refrigerator, allow for ¹⁄₂" (1.25 cm) of space on each side and at the top. Allow for 1" Failure to f
Résumé du contenu de la page N° 4
6. Fasten the shutoff valve to the cold water pipe with the pipe Water Pressure clamp. Be sure the outlet end is solidly in the ¹⁄₄" (6.35 mm) drilled hole in the water pipe and that the washer is under the A cold water supply with water pressure of between 30 and pipe clamp. Tighten the packing nut. Tighten the pipe clamp screws slowly and evenly so the washer makes a watertight 120 psi (207 and 827 kPa) is required to operate the water dispenser and ice maker. If you have questions about
Résumé du contenu de la page N° 5
NOTE: Tighten the nut by hand. Then tighten it with a wrench two more turns. Do not overtighten. REFRIGERATOR USE Using the Controls The refrigerator and freezer controls are located on the dispenser panel. IMPORTANT: The display screen on the dispenser control panel A B C D E F G will turn off automatically and enter “sleep” mode when the A. Refrigerator water tubing E. Ferrule (purchased) control buttons and dispenser levers have not been used for B. Nut (provided) F. Nut (purchased) 2 m
Résumé du contenu de la page N° 6
■ Wait at least 24 hours between adjustments. Recheck the IMPORTANT: To avoid unintentionally locking the dispenser temperatures before other adjustments are made. or changing other settings, be sure to press both buttons at exactly the same time. To view and adjust the set points, press and hold the TEMP button for 3 seconds. When adjust mode is activated, adjusting When cooling is off, “COOLING OFF” will appear on the information will appear on the display screen. display screen. ■ Press
Résumé du contenu de la page N° 7
■ The display screen on the dispenser control panel will turn off automatically and enter “sleep” mode when the control Crisper Humidity Control buttons and dispenser levers have not been used for (on some models) 2 minutes or more. While in “sleep” mode, the first press of a control button will only reactivate the display screen, without You can control the amount of humidity in the moisture-sealed crisper. Adjust the control to any setting between LOW and changing any settings. After
Résumé du contenu de la page N° 8
■ The quality of your ice will be only as good as the quality of The Dispenser Light the water supplied to your ice maker. Avoid connecting the ice maker to a softened water supply. Water softener When you use the dispenser, the light will automatically turn on. chemicals (such as salt) can damage parts of the ice maker and lead to poor quality ice. If a softened water supply cannot If you want the light to be on continuously, you may choose either ON or DIM. The display screen indicates w
Résumé du contenu de la page N° 9
3. Wash stainless steel and painted metal exteriors with a clean Changing the Water Filter sponge or soft cloth and a mild detergent in warm water. 1. Press the eject button to release the filter from the base grille. WARNING 2. Pull the filter straight out. 3. Turn the cap counterclockwise to remove it from the filter. IMPORTANT: Do not discard the cap. It is part of your refrigerator. Keep the cap to use with the replacement filter. 4. Align the ridge on the cap with the arrow on the new f
Résumé du contenu de la page N° 10
TROUBLESHOOTING First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions) to possibly avoid the cost of a service call. In the U.S.A., www.maytag.com In Canada, www.maytag.ca Refrigerator Operation ■ Rattling - flow of refrigerant, water line, or from items placed The refrigerator will not operate on top of the refrigerator ■ Sizzling/Gurgling - water dripping on the heater during defrost cycle WARNING ■ Popping - contraction/expansion of i
Résumé du contenu de la page N° 11
The lights do not work The ice cubes are hollow or small ■ Is a light bulb loose in the socket or burned out? See NOTE: This is an indication of low water pressure. “Changing the Light Bulbs.” ■ Water shutoff valve not fully open? Turn the water shutoff valve fully open. ■ Is the dispenser light set to OFF? On some models, the dispenser light will operate only when a dispenser lever/pad ■ Kink in the water source line? A kink in the line can reduce is pressed. If you want the dispenser ligh
Résumé du contenu de la page N° 12
■ Kink in the home water source line? Straighten the water source line. WARNING ■ New installation? Flush and fill the water system. ■ Water filter installed on the refrigerator? The filter may be clogged or incorrectly installed. ■ Is a reverse osmosis water filtration system connected to your cold water supply? See “Water Supply Requirements.” Cut Hazard Water is leaking from the dispenser Use a sturdy glass when dispensing ice. Failure to do so can result in cuts. NOTE: One or two drops
Résumé du contenu de la page N° 13
WATER FILTER CERTIFICATIONS 13
Résumé du contenu de la page N° 14
PERFORMANCE DATA SHEETS Base Grille Water Filtration System Model T2WG2L/T2RFWG2 Capacity 200 Gallons (757 Liters) Model T2WG2/T2RFWG2 Capacity 200 Gallons (757 Liters) System tested and certified by NSF International against NSF/ANSI Standard 42 for the reduction of Chlorine Taste and Odor, Particulate Class II*; and against NSF/ANSI Standard 53 for the reduction of Mercury, Benzene, Toxaphene, O-dichlorobenzene, and Carbofuran. This system has been tested according to NSF/ANSI Standards 42
Résumé du contenu de la page N° 15
Base Grille Water Filtration System Model T1WG2L/T2RFWG2 Capacity 200 Gallons (757 Liters) Model T1WG2/T2RFWG2 Capacity 200 Gallons (757 Liters) System tested and certified by NSF International against NSF/ANSI Standard 42 for the reduction of Chlorine Taste and Odor, Particulate Class II*; and against NSF/ANSI Standard 53 for the reduction of Mercury, Benzene, Toxaphene, O-dichlorobenzene, and Carbofuran. This system has been tested according to NSF/ANSI Standards 42 and 53 for the reductio
Résumé du contenu de la page N° 16
Base Grille Water Filtration System Model P2WG2L/P2RFWG2 Capacity 200 Gallons (757 Liters) Model P2WG2/P2RFWG2 Capacity 200 Gallons (757 Liters) System tested and certified by NSF International against NSF/ANSI Standard 42 for the reduction of Chlorine Taste and Odor, Particulate Class I*; and against NSF/ANSI Standard 53 for the reduction of Lead, Mercury, Benzene, Toxaphene, and O-dichlorobenzene. This system has been tested according to NSF/ANSI Standards 42 and 53 for the reduction of th
Résumé du contenu de la page N° 17
Base Grille Water Filtration System Model P1WG2L/P2RFWG2 Capacity 200 Gallons (757 Liters) Model P1WG2/P2RFWG2 Capacity 200 Gallons (757 Liters) System tested and certified by NSF International against NSF/ANSI Standard 42 for the reduction of Chlorine Taste and Odor, Particulate Class I*; and against NSF/ANSI Standard 53 for the reduction of Lead, Mercury, Benzene, Toxaphene, and O-dichlorobenzene. This system has been tested according to NSF/ANSI Standards 42 and 53 for the reduction of th
Résumé du contenu de la page N° 18
® MAYTAG MAJOR APPLIANCE WARRANTY LIMITED WARRANTY For one year from the date of purchase, when this major appliance is operated and maintained according to instructions attached to or furnished with the product, Maytag brand of Whirlpool Corporation or Whirlpool Canada LP (hereafter “Maytag”) will pay for factory specified parts and repair labor to correct defects in materials or workmanship that existed when this major appliance was purchased. Service must be provided by a Maytag designated
Résumé du contenu de la page N° 19
INSTRUCCIONES PARA EL USUARIO DEL REFRIGERADOR LE AGRADECEMOS la compra de este producto de alta calidad. Si usted experimenta un problema que no se haya cubierto en SOLUCIÓN DE PROBLEMAS, visite nuestro sitio de internet en www.maytag.com para obtener información adicional. Si considera que aún necesita ayuda, llámenos al 1-800-688-9900. En Canadá, visite nuestro sitio de internet en www.maytag.ca o llámenos al 1-800-807-6777. Necesitará tener a mano su número de modelo y de serie ubicados
Résumé du contenu de la page N° 20
Antes de tirar su viejo refrigerador o congelador: Cómo deshacerse adecuadamente de su ■ Saque las puertas. refrigerador viejo ■ Deje los estantes en su lugar para que los niños no puedan meterse con facilidad. ADVERTENCIA Peligro de Asfixia Remueva las puertas de su refrigerador viejo. No seguir esta instrucción puede ocasionar la muerte o daño al cerebro. IMPORTANTE: El atrapamiento y asfixia de niños no es un problema del pasado. Los refrigeradores tirados y abandonados son un peligro, a
