Résumé du contenu de la page N° 1
MODEL
EX30D
ISSUE EMD-EU2062
2ZZ9990095
Résumé du contenu de la page N° 2
Résumé du contenu de la page N° 3
WARNING: The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. NOTICE FEDERAL EMISSION COMPONENT DEFECT WARRANTY and CALIFORNIA JP EMISSION CONTROL WARRANTY are applicable to only those engines US complied with EPA (Environmental Protection Agency) and CARB (California GB Air Resources Board) emission regulations in the U.S.A. DE FR NOTICE NL To the engines exported to and used in the countries
Résumé du contenu de la page N° 4
FEDERAL EMISSIONS COMPONENT DEFECT WARRANTY EMISSIONS COMPONENT DEFECT WARRANTY COVERAGE This emission warranty is applicable in all States, except the State of California. Fuji Heavy Industries Ltd. and Robin America Inc., Wood Dale Illinois, (herein “ROBIN AMERICA”) warrant(s) to the initial retail purchaser and each subsequent owner, that this Nonroad engine (herein “engine”) has been designed, built, and equipped to conform at the time of initial sale to all applicable regulations of the U.S
Résumé du contenu de la page N° 5
CALIFORNIA EMISSION CONTROL WARRANTY STATEMENT YOUR WARRANTY RIGHTS AND OBLIGATIONS The California Air Resources Board and Fuji Heavy Industries Ltd. (herein “FUJI”) are pleased to explain the emission control system warranty on your 2005 and later Small Off-Road engine (herein "engine"). In California, new engine must be designed, built and equipped to meet the State's stringent anti-smog standards. FUJI must warrant the emission control system on your engine for the periods of time described b
Résumé du contenu de la page N° 6
When warranty repair is needed, the engine must be brought to an H. PARTS COVERED UNDER THE CALIFORNIA EMISSIONS authorized service dealer or warranty station’s place of business during WARRANTY normal business hours. In all cases, a reasonable time, not to exceed (1) Fuel Metering System 30 days, must be allowed for the warranty repair to be completed after (i) Carburetor and internal parts (and/or pressure regulator or the engine is received by the authorized service dealer or warranty station
Résumé du contenu de la page N° 7
FOREWORD Thank you very much for purchasing a ROBIN ENGINE. Your ROBIN ENGINE can supply the power to operate various sorts of machines and equipment. Please take a moment to familiarize yourself with the proper operation and maintenance procedures in order to maximize the safe and efficient use of this product. Keep this owner’s manual at hand, so that you can refer to it at any time. Due to constant efforts to improve our products, certain procedures and specifications are subject to change wi
Résumé du contenu de la page N° 8
1. SAFETY PRECAUTIONS Please make sure you review each precaution carefully. Pay special attention to statement preceded by the following words. “WARNING” indicates a strong possibility of severe personal injury or loss of life if WARNING instructions are not followed. “CAUTION” indicates a possibility of personal injury or equipment damage if instructions CAUTION are not followed. WARNING : EXHAUST PRECAUTIONS Never inhale exhaust gasses. They contain carbon monoxide, a colorless, odorless and
Résumé du contenu de la page N° 9
Do not touch the spark plug and ignition cable when starting and operating the engine. Never make adjustments on the machinery while it is connected to the engine, without first removing the ignition cable from the spark plug. Turning the crankshaft by hand during adjusting or cleaning might start the engine, and cause serious injury to the operator. Operate the engine on a stable, level surface. If the engine is tilted, fuel spillage may result. NOTE Operating the engine at a steep incline may
Résumé du contenu de la page N° 10
SYMBOLS Read the owner's manual. Stay clear of the hot surface. Exhaust gas is poisonous. Do not operate in an unventilated area. JP Stop the engine before refueling. US GB DE Fire, open flame and smoking prohibited. FR NL Oy n (Run) Plus ; Positive polarit ES IT Oy ff (Stop) Batter PT GR E) ngine oil Engine start (Electric start NO SE Add oil FI DK RU 2. COMPONENTS CN (See Fig. 1 1 1) 1 1 AR NOTE Please refer to the illustrations on the back page of the front 1 1 6 6 cover or back cover for
Résumé du contenu de la page N° 11
3. PRE-OPERATION CHECKS 4. ELECTRIC STARTER MODELS For electric starter operation, proper electric wiring NOTE arrangements are needed before normal engine operation. Engine shipped from our factory is without oil. Before starting engine, fill with oil. Do not over-fill. 1. BATTERY Use a battery rated 12V 24AH or larger. CHECK ENGINE OIL (See Fig. 2 2 2 2 2) WARNING Before checking or refilling engine oil, be sure the engine is Charge the battery in a fully ventilated location. located on stabl
Résumé du contenu de la page N° 12
4. WIRING 5. OPERATING YOUR ENGINE MAGNETIC SWITCH (See Fig. 3 3 3 3 3) CABLE 1. STARTING To KEY SWITCH (TERMINAL "ST") (1) Open the fuel cock. (2) Turn the STOP SWITCH to the position “ ” (ON). I EARTH WIRE (See Fig.3 q) (3) Close the choke lever. (See Fig.3 w) If the engine is cold or the ambient temperature is low, BATTERY close the choke lever fully. If the engine is warm or the ambient temperature is high, (1) Connect positive (+) terminal of the magnetic switch and open the choke lever
Résumé du contenu de la page N° 13
2. PERIODIC INSPECTION STOPPING ENGINE WITH THE FUEL COCK Periodic maintenance is vital to the safe and efficient operation of your engine. Close the fuel cock and wait for a while until the engine stops. Check the table below for periodic maintenance intervals. Avoid to let the fuel remain in the carburator over long periods, or the passages of the carburator may become clogged with IT IS ALSO NECESSARY FOR THE USER OF THIS ENGINE impurities, and malfunctions may result. TO CONDUCT THE MAINTEN
Résumé du contenu de la page N° 14
3. INSPECTING THE SPARK PLUG (See Fig.5 5 5 5 5-w w w w w) (1) Clean off carbon deposits on the spark plug electrode NOTE using a plug cleaner or wire brush. Clean and replace air cleaner elements more often when operating in dusty environments. Replace the element in (2) Check electrode gap. The gap should be 0.6 mm to 0.7 case that dirt or dust can not be removed and/or that the mm (0.02 inch.-0.03 inch.). Adjust the gap, if necessary, element is deformed or deteriorated. by carefully bending
Résumé du contenu de la page N° 15
7. PREPATIONS FOR STORAGE 9. EASY TROUBLESHOOTING 1. DISCHARGE FUEL (See Fig.6 6 6 6 6) WHEN ENGINE WILL NOT START : Perform the following checks before you take the engine to WARNING Flame Prohibited your Robin dealer. If you still have trouble after completing If you do not use the engine more than 1 month, discharge the checks, take the engine to your nearest Robin dealer. fuel to prevent gum in the fuel system and carburetor parts. Remove the fuel cup, place it over a container and open 1.
Résumé du contenu de la page N° 16
10. SPECIFICATIONS MODEL EX30D Type Air-cooled, 4-cycle single cylinder, overhead camshaft, gasoline engine Displacement mL (cc) 287 kW/rpm 5.5/3600 Continuous Output (HP/rpm) (7.5/3600) kW/rpm 6.6/4000 Maximum Output (HP/rpm) (9.0/4000) Direction of Rotation Counterclockwise, as Viewed from P.T.O. Shaft side Lubricant Automotive detergent oil (API/ SE or higher grade, SAE/ 10W-30 etc.) Oil Capacity Liter 1.0 JP Fuel Automotive Gasoline (Unleaded) US Spark Plug NGK BR-6HS (CHAMPION RL86C) GB Sta
Résumé du contenu de la page N° 17
