Résumé du contenu de la page N° 1
TrueDRY™ DR65
PROFESSIONAL INSTALLATION GUIDE
GUIDE D’INSTALLATION PROFESSIONNELLE
GUÍA DE INSTALACIÓN PROFESIONAL
Included In thIs Box
A B C D
OPTIONAL CONTROLS SOLD SEPARATELY
E
F
F1 F2 F3 F4
69-2089EFS-10
Tools required to install TrueDRY DR65
TrueDRY™ DR65 (1)
A
3/8-in. hex drive
8-in. duct collar (2)
B
Drill or duct cutting tool
MERV 11 Filter (1)
c
Wire stripper/cutter
Standard screwdriver
Filter Door (2)
d
Duct tape
Installation Guide
e
8-in. round duct and starter collar
Prestige
Résumé du contenu de la page N° 2
Installation Checklist Liste de vérification Lista de verificación pour l’installation para la instalación Included in This Box A TrueDRY™ DR65 (1) Esta caja incluye Inclus dans cette boîte B 8-in. duct collar (2) A TrueDRY™ DR65 (1) A TrueDRY™ DR65 (1) C MERV 11 Filter (1) B Anillo para conductos de 8 B Collet de conduite de 8 po (2) D Filter Door (2) pulgadas (20,3 cm) (2) C Filtre MERV 11 (1) E Installation Guide C Filtro MERV 11 (1) D T rappe du filtr e (2) D Puerta del filtr o (2) E
Résumé du contenu de la page N° 3
™ TrueDRY DR65 ABOUT YOUR NEW DEHUMIDIFIER MAINTENANCE Benefits .................................. 2 Cleaning ................................. 11 Maintaining Ideal Humidity . . . . . . . . . . . . . . . . . . . 2 Horizontal to V ertical Conversion . . . . . . . . . . . . . 12 Setting the Controls ......................... 3 Technical Description ....................... 13 Control Options . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Troubleshooting . . . . . . . . . . . . . . .
Résumé du contenu de la page N° 4
About the T rueDR Y™ DR65 Dehumidifier The Honeywell TrueDRY DR65 ensures the home is maintained at proper humidity levels through its high performance and efficiency. Benefits • Removes up to 65 pints (30.8 l) of water per day fr om the indoor air. • Built-in humidity contr ol r equir es no additional wiring to an external control. Just plug in and go! Choice of external control options also available for centrally ducted control. • Feedback on operation and main
Résumé du contenu de la page N° 5
Setting the Controls BUILT-IN HUMIDITY CONTROL: An intuitive ‘set and forget’ humidistat is built into the TrueDRY DR65 to set the humidity level right on the device. Optional external control wiring is also available. If an external dehumidistat is used, the on-board dehumidification control must be set to the Off position. CHECK DRAIN PAN: Lights to indicate the internal float has tripped by a water backup. Control Options The TrueDRY™ DR65 may be used with one of the following external c
Résumé du contenu de la page N° 6
Specifications Install TrueDRY DR65 according to National Electric Codes. dry-Bulb temp Intake humidity capacity (Pints/day) 80°F (26.7°C) 60% RH 65 70°F (21.1°C) 60% RH 42 60°F (15.6°C) 60% RH 21 home size dehumidifier capacity Required to Maintain desired Indoor Rh* (square ft) 60% Rh Indoor 50% Rh Indoor 40% Rh Indoor (pints/day) (pints/day) (pints/day) 2080 49–54 55–58 71–78 2600 61–68 65–72 90–97 3120 75–82 79–86 95–110 * Based on extreme climates where outdoor humidity is 70-90% RH. Fo
Résumé du contenu de la page N° 7
Install to Fit Your Application Flex duct is recommended in connecting to the TrueDRY DR65 collars to reduce vibration noise. duct sizing: Use minimum 8-in. diameter round for duct lengths up to 25 ft. Minimum 10-in. required for lengths longer than 25 ft. Duct branches from the main inlet/exhaust should be minimum 8-in. round for 2-3 branches, and 8-in. round or larger for 4 branches or more. Isolated Areas: Effective dehumidification may require ducting to isolated or stagnant air flow a
Résumé du contenu de la page N° 8
Install to Fit Your Application (continued) Dedicated Return to Main Supply AIR HANDLER Ideal when… c RETURN SUPPLY • Drying a specific ar ea of the house. • Running with A/C operation r equir es backdraft damper on the exhaust port to minimize backdraft when T rueDR Y SEPARATE DR65 is not on but A/C is. RETURN BACKDRAFT DAMPER TrueDRY M27326 Dedicated Return to Main Return AIR HANDLER Ideal when… d RETURN SUPPLY • Drying a specific conditioned or unconditioned area, suc
Résumé du contenu de la page N° 9
+ + Terminal Description CAUTION: Low voltage hazard. Can cause equipment damage. Disconnect HVAC equipment before beginning installation. Two wiring terminal blocks are located on the exhaust end of the TrueDRY unit. * note: The outer screws on each terminal block secure the block to the chassis. They are not used for wiring. The four terminals for the left hand terminal block The right hand terminal block in the above figure is are: used only for interlocking a TrueDry DR65 with an equip
Résumé du contenu de la page N° 10
+ + + + Wiring (continued) HVAC R C W Y G W W2 C Follow this diagram if using the Rc Y Prestige™ thermostat. Y2 R H G TrueDRY H DH K THERMOSTAT DH DHUM R FAN C Gt Rf Gf NOTE: THERMOSTAT MUST BE CONFIGURED TO DRIVE FURNACE FAN DURING DEHUMIDIFICATION CALL. M29765 HVAC MECHANICAL DEHUMIDISTAT DRY CONTACTS R C W Y G Follow this diagram if using an external manual dehumidistat. RRc W Y G DHUM R FAN C Gt Rf Gf TrueDRY M29766 THERMOSTAT TrueDry DR65 Dehumidification System 69-2089EFS—11 8 + + + +
Résumé du contenu de la page N° 11
+ + + + Wiring (continued) HVAC EARD-6 R C W Y G R C W8150A G R DAMPER C Follow this diagram for ducted C AUX operation with external ventilation W control. G REMOTE Rc W R Y G DHUM R FAN C Gt Rf Gf TrueDRY THERMOSTAT M29767 THERMOSTAT 1 RRc C W Y G HVAC R R C C TrueIAQ OUTDOOR SENSOR W SENSOR SENSOR (PROVIDED) Y Follow this diagram if using In % 6840 SWITCH G Out % 7655 TrueDRY DR65 with a powered W 2 PM : 1215 dehumidistat such as TrueIAQ G VENT (DG115EZIAQ). EARD-6 VENT DEHUM DEHUM HUM HU
Résumé du contenu de la page N° 12
+ + Wiring (continued) EQUIPMENT INTERFACE MODULE (EIM) D-1 FAN R-2 FURNACE BOARD 1 C CONV.HP C-3 HEAT 1 RELAY 2 W1 O/B VISIONPRO IAQ HEAT 2 RELAY 3 W2 AUX HEAT 3 RELAY C W3 AUX2 COOL 1 RELAY R Y Y COOL 2 RELAY RC Y2 Y2 G FAN RELAY RH G G H1 U M2 Follow this diagram if using TrueDRY D1 DR65 with a VisionPro IAQ. H OR M2 V1 N T2 EARD-6 DHUM R FAN C Gt Rf Gf TrueDRY M29769 Checkout Apply power to TrueDRY DR65. Turn the humidity control to a low RH% level to initiate a dehumidification c
Résumé du contenu de la page N° 13
Cleaning On an annual basis, maintenance is required to ensure TrueDRY runs at peak efficiency. Unplug TrueDRY DR65 before beginning Remove filter (50049537-005) and service. Press down on the quick- replace with new filter. 1 2 release button and remove the duct collar. Using a 1/2-in. hex drive or standard Check the drain connection and drain screwdriver, remove the three screws line to ensure it is clear of debris and 3 4 on each side of the TrueDRY DR65. The sludge. Ensure all hose conne
Résumé du contenu de la page N° 14
Horizontal to V ertical Conversion Remove the six screws attached to Remove the duct collar. 1 the wiring side of the duct collar. 2 REMOVE THESE THREE SCREWS (THREE ON EACH SIDE) Rotate the collar to the position Reattach the duct collar using the shown in the figure and place it back 3 4 six screws. on the cabinet. TrueDry DR65 Dehumidification System 69-2089EFS—11 12
Résumé du contenu de la page N° 15
Technical Description STRAINER/FILTER TrueDRY DR65 uses a refrigeration system similar to COMPRESSOR DRIER an air conditioner to remove heat and moisture from incoming air and add heat to the air that is discharged. Hot, high-pressure refrigerant gas is routed from the CONDENSER compressor to the condenser coil. The refrigerant is cooled and condensed by giving up its heat to the air that is about to be discharged from the unit. The CAPILLARY TUBES refrigerant liquid then passes through a
Résumé du contenu de la page N° 16
Troubleshooting (continued) Problem Recommended t roubleshooting steps Fan does not run with 1. Loose connection in fan circuit. ventilation activated. 2. Obstruction prevents fan rotation. Compressor runs briefly 3. Defective fan. but cycles on & off with 4. Defective fan relay. humidity control turned to 5. Defective fan capacitor. ON. Evaporator coil frosted 1. Defrost thermostat loose or defective. continuously, low de- 2. Low refrigerant charge. humidifying capacity. 3. Dirty air filter
Résumé du contenu de la page N° 17
Parts List Figure description Part number Reference 1 TrueDRY with no controls DR65A1000 2 TrueDRY with VisionPRO IAQ Control DR65VPIAQ 3 Prestige Comfort System YTHX9321R5003 4 VisionPRO IAQ Total Comfort Control YTH9421C1010 5 TrueIAQ digital IAQ control DG115EZIAQ 6 H8908D Manual Dehumidistat H8908DSPST 7 Automatic ventilation control W8150A1001 8 Motorized ventilation damper EARD 6 Compressor overload 50049537-001 Compressor relay, DPDT 24 VAC, 30A 50049537-002 Run capacitor, 35 MFD 500495
Résumé du contenu de la page N° 18
5-Year Limited Warranty Honeywell warrants this product to be free from defects in the workmanship or materials, under normal use and service, for a period of five (5) years from the date of purchase by the consumer. If at any time during the warranty period the product is determined to be defective or malfunctions, Honeywell shall repair or replace it (at Honeywell’s option). If the product is defective, (i) return it, with a bill of sale or other dated proof of purchase, to the place from w
Résumé du contenu de la page N° 19
™ ™ T TrueDR rueDRY Y DR65 DR65 À PROPOS DU NOUVEAU DÉSHUMIDIFICATEUR ENTRETIEN Avantages . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18 Nettoyage ................................ 27 Maintien d’une humidité idéale . . . . . . . . . . . . . . . 18 Conversion de la position horizontale à la position Réglage des commandes . . . . . . . . . . . . . . . . . . . 19 verticale . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 28 Options de régulateurs ...........
Résumé du contenu de la page N° 20
À pr opos du déshumidificateur T rueDR Y™ DR65 Le TrueDRY DR65 de Honeywell permet de maintenir les niveaux d’humidité adéquats dans toute la maison grâce à sa haute performance et son efficacité. Avantages • Retir e jusqu’à 30,8 litr es (65 chopines) d’eau par jour de l’air intérieur. • La commande d’humidité intégrée ne nécessite aucun câblage supplémentaire à un régulateur externe. Il suffit de brancher et c’est parti! Choix d’options de régulateurs externes également d
