Résumé du contenu de la page N° 1
Model HDP66
Headlight Design Alarm Clock
Speaker System For iPhone
Questions? Visit www.ihomeaudio.com
Résumé du contenu de la page N° 2
Table of Contents 1 A Consumer Guide to Product Safety 1 Maintenance 2 Controls and Indicators 3 Getting Started 3 Install Clock Backup Batteries 4 Connecting the AC adaptor 4 Using The Optional Remote Control 5 Install/Replace the Remote Control Battery 6 Setting Up the HDP-66 6 Using the Alarm 7 Docking and Charging your iPhone/Pod 7 Listening to iPhone/iPod 8 Listening to non-docking iPod or other portable audio devices 8 Sleep Operation 8 Dimmer Operation 9 A Consumer Guide to Product Saf
Résumé du contenu de la page N° 3
A Consumer Guide to Product Safety This device complies with Part 15 of the FCC Rules, operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment complies with the limits for a Class B digital device as specified in Part 15 of FCC Rules. These limits provide reasonable protection against radio and TV interference in
Résumé du contenu de la page N° 4
Controls and Indicators Forward Button OFF/Alarm Reset Button Front view Increase Volume Button Play/Pause Button Mute Button Reverse Button Snooze/Dimmer Button Snooze/Dimmer Button Sleep Button Decrease Volume Button Top view Power Off/ Alarm Dock Support Reset Button Play/Pause Button Decrease Volume Button Increase Volume Button Alarm Set/Alarm on/off Button Time Set Button Sleep/Min. Button Hour Button Back panel DC 12V dst line in wake to DST Switch Wake To Switch AC Adaptor Jack Line-in
Résumé du contenu de la page N° 5
Getting Started Thank you for purchasing the iHome HDP-66 2.1 Speaker System for your iPhone/iPod. Designed specifically to work with your iPhone and iPod, this system provides high quality audio that invites your music to come out and play. Please read this instruction carefully before operating the HDP66 and keep it for future reference. Install Clock Backup Batteries The HPD66 uses 2 x AA batteries for backup to provide continuous alarm operation and clock settings in the event of a power
Résumé du contenu de la page N° 6
Connecting AC Adaptor Plug the AC adaptor cable into the AC Adaptor Jack on the back of the unit and the other end into a standard 120V wall outlet. Using the Optional Remote Control Power Button turns unit OFF or Resets Alarm. Volume Buttons raise and lower volume on the unit. Pressing FWD/REW while iPod is docked will FWD/REV to next/previous track Pressing and holding FWD/REW while iPod is docked will scan forward/reverse within currently playing track. Pressing Play/Pause from power off
Résumé du contenu de la page N° 7
Install/Replace the Remote Control Battery The remote control battery is already installed at the factory. When the remote control stops operating or its range seems reduced, it is time to replace the battery with a new one. 1. The battery door is located on the back end of the remote control. 2. Pull the battery door to release the battery door latch and take out the battery. 3. Insert a CR2032 battery, checking that the + and – sides of the battery matches the drawing inside th
Résumé du contenu de la page N° 8
Setting Up the HDP-66 Setting the Time 1. Depending on your location and whether or not Daylight Saving Time (DST) is in effect, set the DST Switch located on the back of the unit to +1 (adds an hour) or to -1 (subtracts an hour). 2. Press and hold the Time Set Button until the time flashes on the display. Press the min. and/or hour Button as needed to adjust to the correct time. Hold the hour or min button to advance the hour or minutes faster. 3. Remember to set the correct AM or PM time. T
Résumé du contenu de la page N° 9
Docking and Charging your iPhone/iPod To dock your iPhone or iPod, gently place it over the 30 pin dock connector located on top of the unit. Place the Dock Support behind the iPhone/iPod and attach to unit with thumbscrew. Adjust support so it is snug against the iPhone/iPod and tighten the thumb- screw. While your iPhone/iPod is docked in the unit and the unit is connected to AC power, it recharges (until fully charged). Listening to iPhone/iPod 1. Dock the already playing iPhone/Pod, the H
Résumé du contenu de la page N° 10
Listening to non-docking iPod or other portable audio devices You can play an MP3 player or other portable audio device through the HDP-66 via the Line-in Jack. 1. Plug one end of an audio patch cord (available at www.ihomeaudio.com) into the headphone or line-out jack on your device and the other end of the patch cord into the HDP-66 Line-in Jack, located on the back of the unit. 2. Press the Button to turn the HDP-66 on. 3. Turn on and play your device. 4. Press the and to a
Résumé du contenu de la page N° 11
A Consumer Guide to Product Safety When used in the directed manner, this unit has been designed and manufactured to ensure your personal safety. However, improper use can result in potential electrical shock or fire hazards. Please read all safety and operating instructions carefully before installation and use, and keep these instructions handy for future reference. Take special note of all warnings listed in these instructions and on the unit. 1. Water and Moisture – The unit should n
Résumé du contenu de la page N° 12
Trouble Shooting Symptom Possible Problem Solution Unit doesn’t respond AC adaptor isn’t plugged to a wall outlet or Plug the AC adaptor into a wall outlet and plug the connector into (no power) the connector is not plugged into the power the power supply jack on the unit supply jack on the back of the unit Wall outlet is not functioning Plug another device into the same outlet to confirm the outlet is working iPod cannot dock Using no or wrong iPod insert Make sure the dock insert is the prop
Résumé du contenu de la page N° 13
Solución De Problemas Síntoma Posible Problema Solución La unidad no El adaptador de AC no está conectado al Conecte el adaptador de AC al tomacorriente y también funciona (no circula tomacorriente o el conector no está conectado conecte el conector a la ficha en la parte posterior de la unidad corriente eléctrica) a la ficha en la parte posterior de la unidad El tomacorriente no funciona Coloque otro aparato en ese mismo tomacorriente para confirmar si el que no funciona es el tomacorriente
Résumé du contenu de la page N° 14
Limited 1 Year Warranty Information iHome Products, a division of SDI Technologies Inc. (hereafter referred to as SDI Technologies), warrants this product to be free from defects in workmanship and materials, under normal use and conditions, for a period of 1 year from the date of original purchase. Should this product fail to function in a satisfactory manner, it is best to first return it to the store where it was originally purchased. Should this fail to resolve the matter and service still
