Instruction d'utilisation Harbor Freight Tools 40129

Résumé du contenu de la page N° 1

4-WHEEL CART
ASSEMBLY INSTRUCTIONS
3491 Mission Oaks Blvd., Camarillo, CA 93011
Visit our Web site at http://www.harborfreight.com
®
. All rights reserved. No portion of this manual
Copyright © 2003 by Harbor Freight Tools
or any artwork contained herein may be reproduced in any shape or form without the
express written consent of Harbor Freight Tools.
For technical questions please call 1-800-444-3353
02/03

Résumé du contenu de la page N° 2

SPECIFICATIONS ITEM DESCRIPTION Open Dimensions 38-3/8” Tall X 20-5/8” Deep X 21” Wide Closed Dimensions 43” Tall X10-1/8” Deep X 21” Wide Wire Gauge 8 Gauge Wire Stoage Dimensions 11-1/2” X 15-1/8”W X 18-5/8” Tall Large (Front) Wheel Diameter 13/16” Wide X 6” Diameter Small (Rear) Wheel Diameter 1-1/16” X 9-7/8” Dia. 5-3/4” Dia. X 7/8” Wide Handle Length 7/8” Diameter X 12” Wide Net Weight 14 Lbs. Finish Red Enamel Coated Alloy Steel Note: Maximum weight capacity = 75 Lbs. Do not exceed this m

Résumé du contenu de la page N° 3

ASSEMBLY INSTRUCTIONS FOR BACK WHEELS 1. Remove the plastic bag from the Four Wheel Cart. See Figure A. Cut all the tie straps holding component parts. Open Cart (#1) and organize parts for assembly. See Figure B & C. #4 #1 #2 #3 #5 { } #6 Figure A Figure B Figure C 2. Turn Cart around and on the handle side, slip the Longer Axle (#2), Figure C, through the right and left axle-support on lower back frame, matching up the small holes in the Longer Axle (#2) and axle-support. Place Cotter Pin thro

Résumé du contenu de la page N° 4

ASSEMBLY INSTRUCTIONS FOR FRONT WHEELS 5. To assemble the Front Axle: Flip Cart around so handle is in back. Using the Short Axle (#3) and using the “Assembly Order”, put Cotter Pin in hole, Washer, Small Spring, Washer, Small Wheel (#5) and last Washer. Do the same on the opposite end of the Small Axle (#3). See Figure G. With both wheels in place, put axle into front frame holes of Cart. See Figure H. #3 #5 Figure G Figure H 6. With pliers, bend the ends of the Cotter Pins. Recheck to see all

Résumé du contenu de la page N° 5

PARTS LIST PART # DESCRIPTION QTY 1 Cart 1 2 Long Axle 1 3 Short Axle 1 4 Large Wheel 2 5 2 Small Wheel 6 1 Hardware Packet (contents include) Cotter Pins, Large Springs, Small Springs, Washers, Wheel Hubs #1 #2 #4 #3 #5 } #6 MAINTENANCE 1. For better and safer performance, keep all parts of this product clean and dry. 2. Periodically check to see that all hardware is in place. PLEASE READ THE FOLLOWING CAREFULLY THE MANUFACTURER AND/OR DISTRIBUTOR HAS P