ページ1に含まれる内容の要旨
KREISEN
Colour Television
Colour Television
Owner’s Manual
KR-370T
KREISEN
Please read this manual carefully before operating your set.
Retain it for future reference.
See the label attached on the back cover and quote this infor-
mation to your dealer when you require service.
P/NO : MAN04HY0034
ページ2に含まれる内容の要旨
CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER (OR BACK). NO USER SERVICE- ABLE PARTS INSIDE. REFER TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point wi
ページ3に含まれる内容の要旨
Safety Instructions Important safeguards for you and your new product Your product has been manufactured and tested with your safety in mind. However, improper use can result in potential electrical shock or fire haz- ards. To avoid defeating the safeguards that have been built into your new product, please read and observe the following safety points when installing EN and using your new product, and save them for future reference. Observing the simple precautions discussed in this booklet can
ページ4に含まれる内容の要旨
14. Outdoor Antenna Grounding a fire or electric shock. Never spill liquid of any kind on the product. If an outside antenna or cable system is connected to the product, be sure the antenna or cable system is grounded so as to provide some pro- 19. Servicing tection against voltage surges and built-up static charges. Article 810 of Do not attempt to service this product yourself as opening or removing the National Electrical Code (U.S.A.), ANSI/ NFPA 70 provides informa- covers may expose you to
ページ5に含まれる内容の要旨
Contents Warnings 2 Setting up TV stations 22-23 Memorizing the Channels with Auto Safety Instructions 3-4 Add/Delete Channels with Manual EN Fine Tuning Adjustment Contents 5 Favorite Channels Setup Location and function of controls 6-9 Time Menu 24-25 Remote control handset Clock Battery installation On/Off Time Front panel Auto sleep / Sleep timer Back panel Special Menu 26 Installation 10 CSM (Colour Status Memory) Caption Connection to External equipment 11-14 Caption/Text Connecting to an
ページ6に含まれる内容の要旨
- All the functions can be controlled with the remote control handset. - Some functions can also be adjusted with the buttons on the front panel of the set. - Before you use the remote control handset, please install the batteries. POWER MUTE switches the set on from standby or off to switches the sound on or off. standby. POWER ARC NUMBER BUTTONS select your desired picture format. PSM (Picture Status Memory) SSM (Sound Status Memory) 2 3 1 recalls your preferred picture setting. recalls your
ページ7に含まれる内容の要旨
Location and function of controls Battery installation - Your remote control handset is powered by two AAA type batteries. EN 1 2 3 1 2 3 To insert batteries, turn the remote Put the two batteries into the compart- Replace the cover. control handset over and remove the ment observing battery polarity. battery cover. To avoid damage from possible bat- tery leakage, remove the batteries if you do not plan to use the remote con- trol handset for an extended period time. Do not use batteries of diff
ページ8に含まれる内容の要旨
1. MAIN POWER (I / y y) switches the set on or off. 2. (Programme Up/Down) D D / E E selects a programme or a menu item. switches the set on from standby. 3.F F / G G (Volume Down/Up) adjusts the volume. adjusts menu settings. 4. MENU selects a menu. 5. INPUT SELECT selects TV, AV1, AV2, S-VIDEO, COMPO- NENT RGB-DTV, RGB-PC, RGB-DVI mode. switches the set on from standby. 6. POWER (r r) switches the set on from standby or off to standby. 1 2 3 4 5 6 7 8 7.POWER/STANDBY INDICATOR (r r) (Front
ページ9に含まれる内容の要旨
Location and function of controls Back panel EN R R A AU UD DIIO O L L Y Y P Pb b P Pr r R RS S- -2 23 32 2C C IIN NP PU UT T R RG GB B IIN NP PU UT T A AU UD DIIO O IIN NP PU UT T D DV VII IIN NP PU UT T V VIID DE EO O L L A AU UD DIIO O R R L L R R S S- -V VIID DE EO O A AN NT T.. IIN N A AC C IIN NP PU UT T C CO OM MP PO ON NE EN NT T IIN NP PU UT T V VIID DE EO O A AU UD DIIO O A AU UD DIIO O IIN NP PU UT T ( (C CO ON NT TR RO OL L//S SE ER RV VIIC CE E) ) ( (4 48 80 0ii//4 48 80 0
ページ10に含まれる内容の要旨
Power Location This set operates on an AC mains supply, the voltage is as Position your set so that no bright light or sunlight falls indicated on the label on the back cover. Never apply DC directly onto the screen. Care should be taken not to power to the set. In the event of thunderstorms or power- expose the set to any unnecessary vibration, moisture, cuts, please pull out the aerial and mains plugs. dust or heat. Also ensure that the set is placed in a posi- tion to allow a free flow of air
ページ11に含まれる内容の要旨
Connection to External equipment Connecting to an Inside Antenna Setup EN - - T Typical wall antenna jack used in apartment buildings, connect the antenna cable as shown below ypical wall antenna jack used in apartment buildings, connect the antenna cable as shown below.. (Use the correct type of antenna cable for the type of wall antenna jack.) Turn clockwise to tighten. A AN NT T.. IIN N A AC C IIN NP PU UT T Bronze Wire 75Ω Round Cable Antenna Antenna Jack Converter 300Ω Flat Wire Apartment
ページ12に含まれる内容の要旨
VCR Setup - In Video mode, TV automatically reverts to TV mode if the CH F F / G G button or number buttons are pressed. VIDEO L AUDIO R VIDEO L R S-VIDEO ANT. IN AC INPUT AUDIO AV1 AV2 Connection 1 Set VCR switch to 3 or 4 and then tune TV to the same channel num- ber. Connection 2 1. Connect the audio/video output jacks on VCR to the corresponding Typical input jacks on the TV. When connecting the TV to a VCR, match the Antennas jack colors (Video = yellow, Audio Left = white, and Audio Right
ページ13に含まれる内容の要旨
Connection to External equipment External A/V Source Setup EN Connections Connect the audio/video output jacks on the external A/V equipment to V VIID DE EO O L L A AU UD DIIO O R R V VIID DE EO O L L R R S S- -V VIID DE EO O A AN NT T.. IIN N A AC C IIN NP PU UT T A AU UD DIIO O the corresponding input jacks on the TV. When connecting the TV to A AV V1 1 A AV V2 2 external A/V equipment, match the jack colors (Video = yellow, Audio Left = white, and Audio Right = red). Viewing Setup 1. Turn o
ページ14に含まれる内容の要旨
DTV Setup - To watch digitally broadcast programs, purchase and connect a dig- ital set-top box. R R A AU UD DIIO O L L Y Y P Pb b P Pr r R RS S- -2 23 32 2C C IIN NP PU UT T V VIID DE EO O L L R R C CO OM MP PO ON NE EN NT T IIN NP PU UT T A AU UD DIIO O A AU UD DIIO O IIN NP PU UT T ( (C CO ON NT TR RO OL L//S SE ER RV VIIC CE E) ) ( (4 48 80 0ii//4 48 80 0p p//7 72 20 0p p//1 10 08 80 0ii) ) A AV V1 1 Connections Connect the digital set-top box video outputs to the COMPONENT (Y, PB, PR)
ページ15に含まれる内容の要旨
Basic operation EN 1 2 4 1 2 4 On and Off Programme selection On screen language selection (option) Press the main power button to switch You can select a programme Press the MENU button and then use the set on. button to select the SPECIAL number with the or NUM- D D / E E D D / E E menu. BER buttons. If the set is in standby mode, press the Press the G G button and then use POWER, , INPUT SELECT, D D / E E D D / E E button to select Language. PC/DVI or NUMBER buttons on the 3 3 remot
ページ16に含まれる内容の要旨
- The dialogue between you and your set takes place on screen with an operator menu. The buttons required for the operating steps are also displayed. 1 2 3 4 1 2 3 4 Press the MENU but- Change the setting of an item in the Press the G G button and Press the G G button to dis- ton and then use play the sub menu or the sub or pull-down menu with F F / G G D D / E E then use button to D D / E E button to display each pull-down menu. select a menu item. or . D D / E E menu. You can move to the
ページ17に含まれる内容の要旨
Picture adjustment EN PSM (Picture Status Memory) Manual Picture Control Press the MENU button and Repeatedly press the MENU but- Press the MENU Press the G G button and ton to return to normal TV viewing. button and then use then use button to D D / E E then use F F / G G button select the PICTURE menu. D D E E button to / to make appropriate You can also recall a desired pic- select the PICTURE adjustments. ture (Dynamic, Standard, Mild menu. Press the G G button and then or User) with
ページ18に含まれる内容の要旨
Picture format You can watch TV in various picture formats; 16:9, 4:3, Zoom, Panorama. Repeatedly press the ARC button to select your desired picture format. 1. Press the ARC button to select a desired picture format. • Each press of ARC button changes the screen display as shown below. • You can also select 16:9, 4:3, Zoom, Panorama in the SCREEN menu. 16 : 9 4 : 3 Panorama Zoom 18 Picture adjustment Picture Format
ページ19に含まれる内容の要旨
Sound adjustment EN SSM (Sound Status Memory) Press the MENU button and then Sound Frequency Adjustment You can also recall a desired sound (Flat, Speech, Movie, Music or use button to select the D D / E E a. Press the G G button in User. User) with SSM button on the remote SOUND menu. control. The sound Flat, Speech, b. Select a sound band by pressing the Movie and Music are programmed for Press the G G button and then use F F / G G button. good sound reproduction at the factory button to
ページ20に含まれる内容の要旨
Balance AVL (Auto Volume Leveler) Press the MENU button and then use button to Press the MENU button and then use button to D D / E E D D / E E select the SOUND menu. select the SOUND menu. Press the G G button and then use button to select the Press the G G button and then use button to select D D / E E D D / E E desired sound item. AVL. Press the G G button and then use F F / G G button to make appro- Press the G G button and then use button to select D D / E E priate adjustments. On
