ページ1に含まれる内容の要旨
4-105-996-21(1)
Getting started
Shooting/viewing images
Digital Still Camera
Uploading images
Instruction Manual
DSC-G3
Using shooting functions
Before operating the unit, please read
this manual thoroughly and retain it for
future reference.
Using viewing functions
Connecting to other devices
Changing camera settings
GB
© 2008 Sony Corporation
ページ2に含まれる内容の要旨
Owner’s Record IMPORTANT The model and serial numbers are located on the bottom. Record the serial number in SAFEGUARDS the space provided below. Refer to these numbers whenever you call upon your Sony dealer regarding this product. For your protection, please read these safety instructions completely before operating Model No. DSC-G3 the appliance, and keep this manual for Serial No. ___________________________ future reference. Carefully observe all warnings, precautions WARNING and
ページ3に含まれる内容の要旨
[ Attachments [ Lightning Do not use attachments not recommended by the For added protection for this set during a lightning manufacturer, as they may cause hazards. storm, or when it is left unattended and unused for long periods of time, unplug it from the wall [ Cleaning outlet and disconnect the antenna or cable system. This will prevent damage to the set due to Unplug the set from the wall outlet before lightning and power-line surges. cleaning or polishing it. Do not use liquid clean
ページ4に含まれる内容の要旨
Read this first [ IMPORTANT NOTE CAUTION To comply with FCC RF exposure requirements, the following antenna installation and device Replace the battery with the specified type only. operating configurations must be satisfied: the Otherwise, fire or injury may result. antenna has been installed by the manufacturer and no change can be made. Do not expose the batteries to excessive heat such This device and its antenna(s) must not be co- as sunshine, fire or the like. located or operating in
ページ5に含まれる内容の要旨
[ Regulatory Information For Customers in Europe Declaration of Conformity Hereby, Sony Corporation, declares that this Trade Name: SONY DSC-G3 Digital Still Camera is in compliance Model No.: DSC-G3 with the essential requirements and other relevant Responsible Party: Sony Electronics Inc. provisions of the Directive 1999/5/EC. For Address:16530 Via Esprillo, details, please access the following URL: San Diego, CA 92127U.S.A. http://www.compliance.sony.de/ Telephone No.: 858-942-2230 This d
ページ6に含まれる内容の要旨
Disposal of waste batteries Notice for customers in the (applicable in the European Union United Kingdom and other European countries with separate collection systems) A moulded plug complying with BS 1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced, a fuse of the same rating as the supplied one and approved by ASTA or BSI to BS 1362, This symbol on the battery or on the packaging (i.e., marked with an or mark)
ページ7に含まれる内容の要旨
Table of contents IMPORTANT SAFEGUARDS .................................................................... 2 Read this first ............................................................................................ 4 Notes on using the camera ...................................................................... 9 Getting started ................................................................... 11 Checking the accessories supplied........................................................ 11
ページ8に含まれる内容の要旨
Using viewing functions .......................................................... 33 Viewing an enlarged image (Playback zoom)......................................... 33 Displaying images full-screen (Wide Zoom)............................................33 Rotating a vertical orientation image (Temporarily rotated display)........ 34 Viewing still images with music (Slideshow)............................................34 Viewing images with the Scrapbook display..............................
ページ9に含まれる内容の要旨
xNotes on using the camera Internal memory and “Memory Notes on the LCD screen Stick Duo” back up � The LCD screen is manufactured using extremely high-precision technology so over Do not turn off the camera, remove the battery 99.99% of the pixels are operational for pack, or remove the “Memory Stick Duo” effective use. However, some tiny black and/ while the access lamp is lit. Otherwise, the or bright dots (white, red, blue or green) may internal memory data or “Memory Stick Duo” appe
ページ10に含まれる内容の要旨
� The web browser does not necessary work with all wireless access points or with all home pages. Depending on the region, access to a wireless LAN may not be available, may require a separate service charge, or communications may be blocked or suffer from intermittent outages. For details, check with your wireless LAN administrator and/or service provider. � Sony makes no guarantees whatsoever in the provision of the web browser. Sony bears absolutely no responsibility for damages tha
ページ11に含まれる内容の要旨
Getting started Getting started Checking the accessories supplied � Battery charger BC-CSD (1) � CD-ROM (1) – Cyber-shot application software – “Cyber-shot Handbook” – “Cyber-shot Step-up Guide” � Instruction Manual (this manual) (1) xUsing the wrist strap � Power cord (mains lead) (1) (not supplied in the USA and Canada) Attach the strap and place your hand through the loop to prevent the camera from damage by being dropped. Hook � Rechargeable battery pack NP-BD1 (1)/ Battery case (1) xUsing
ページ12に含まれる内容の要旨
Getting started Identifying parts A Shutter button B (Playback) button C Lens cover D Microphone E Flash F Self-timer lamp/Smile Shutter lamp/ AF illuminator lamp G Lens H WLAN (Wireless network) lamp I Speaker J LCD screen/Touch panel K Zoom (W/T) button L POWER button/POWER lamp M WLAN (Wireless network) button N Hook for wrist strap O Tripod receptacle � Use a tripod with a screw less than 5.5 mm (7/32 inch) long. Otherwise, you cannot Bottom firmly secure the camera, and damage to the c
ページ13に含まれる内容の要旨
Getting started Charging the battery pack Insert the battery pack into 1 the battery charger. � You can charge the battery even when it is partially charged. Battery pack Connect the battery For customers in the USA and Canada 2 charger to the wall Plug outlet (wall socket). If you continue charging the battery pack for about one more hour after the CHARGE lamp turns off, the charge will last slightly longer (full charge). CHARGE lamp Lit: Charging Off: Charging finished (normal CHARGE
ページ14に含まれる内容の要旨
Getting started xCharging time Full charge time Normal charge time Approx. 220 min. Approx. 160 min. Notes � The table above shows the time required to charge a fully depleted battery pack at a temperature of 25°C (77°F). Charging may take longer depending on conditions of use and circumstances. � Connect the battery charger to the nearest wall outlet (wall socket). � Even if the CHARGE lamp is not lit, the battery charger is not disconnected from the AC power source (mains) as long as it is c
ページ15に含まれる内容の要旨
Getting started Inserting the battery pack Open the cover. 1 Insert the battery pack. 2 Align the v mark on the battery with the battery eject lever, then insert the battery while pressing the lever in the direction of the arrow. Close the cover. 3 xChecking the remaining battery charge A remaining charge indicator appears on the upper left of the LCD screen. High Low Notes � It takes about one minute until the correct remaining charge indicator appears. � The remaining charge indicator may n
ページ16に含まれる内容の要旨
Getting started “Memory Stick Duo” xTo remove the battery pack Battery eject lever You can also use a “Memory Stick PRO Duo” or “Memory Stick PRO-HG Duo” with the Access lamp camera. For details on the number of images/time that Slide the battery eject can be recorded, see page 32. Other types of lever. Be sure not to drop “Memory Stick” or memory card are not the battery pack. compatible with the camera. “Memory Stick” Note You cannot use a “Memory Stick” with the � Never remove the ba
ページ17に含まれる内容の要旨
Getting started Setting the clock Slide the lens cover as 1 illustrated. POWER button Press the frame on the LCD screen with your thumb until it opens fully. The camera is turned on. � You can also turn on the camera by pressing the POWER button. Touch the desired date 2 display format, then touch . Touch each item, then 3 touch v/V to set its numeric value. � Midnight is indicated as 12:00 AM, and noon as 12:00 PM. Touch [OK]. 4 Notes � The camera does not have a feature for superimpos
ページ18に含まれる内容の要旨
Getting started Setting the wireless network A wireless LAN function is equipped with this camera. Connect the camera to a network via an access point. Press the POWER button 1 to turn on the camera. POWER button Touch t 2 (Communication) t [Network] t t [ Network Settings] t . Touch [Time Zone] t t region in which you live. 3 Touch [Access Point] t t [Create New] t [Auto 4 Scan] t t access point you want to use t . The SSID information confirmation screen is displayed. Confirm the SS
ページ19に含まれる内容の要旨
Getting started Touch [Encryption Key] t Input the encryption key using the 7 keyboard t . Touch [Easy] t t check your connection name t 8 t check your settings on the confirmation screen t t [Save] t t [OK]. Notes � Network device connections and setting methods differ according to the device. � The following are needed to connect the camera to a network: – An internet service provider (ISP) contract – ADSL modem or other network device – Access point or wireless router – Access point se
ページ20に含まれる内容の要旨
Shooting/viewing images Shooting/viewing images Shooting images Slide the lens cover as POWER button 1 illustrated. Press the frame on the LCD screen with your thumb until it opens fully. The camera is turned on. Zoom (W/T) button Hold the camera 2 steady as illustrated. � Press the T side of the zoom (W/T) button to zoom in. Press the W side to zoom out. Press the shutter Shutter button SteadyShot 3 mark button halfway down to focus. is displayed to indicate that SteadyShot is worki
