ページ1に含まれる内容の要旨
ページ2に含まれる内容の要旨
Contents For the user For the installer Safety information 3 Technical specifications 15 Description of the appliance 4-5 Unpacking 16 - Spray arm - Damages - Coarse strainer/microfilter - Use - Fine filter Installation 17-22 - Detergent dispenser - Position - Rinse aid dispenser - Measurements for fitting a wooden door - Water softener - Preparing the outer door The control panel 6 - Mount plate - Switching the buzzer off - Fitting the outer door - Setting the delay start - Fitting protective and i
ページ3に含まれる内容の要旨
Safety information Before installing and first using the dishwasher, read this instruction booklet carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the dishwasher are thoroughly familiar with its operation and safety features. Save these instructions and make sure they remain with the dishwasher if it is moved or sold, so that everyone using it through its life can be properly informed on appliance use and sa
ページ4に含まれる内容の要旨
Description of the appliance 4 5 - 4 -
ページ5に含まれる内容の要旨
Description of the appliance Do not fill the rinse aid dispenser with liquid Spray arm (1) detergent. It is important to keep all the holes in the spray arm clear. A clogged hole can seriously affect washing efficiency. Electrolux recommends the use of Finish dish- If the spray arm needs cleaning, unscrew the nut anti- washer detergent and Rinse Aid. clockwise, remove the washer and lift off the spray arm. Clear the holes and shake out any food remnants. Water softener (6) This dishwasher is equi
ページ6に含まれる内容の要旨
The control panel Control- Indicator lamps lamps delayed start A Buzzer Water softener Delay start On/Off button button button button Programme Combination buttons ”A” buttons In addition to selecting a programme, you can by pressing these two buttons adjust the setting of the water softener, switch off the buzzer and cancel a programme in progress. Control lamps: Shows that • Refilling of salt is necessary • Refilling of the rinse aid is necessary • Programme cycle completed Switching the buzzer
ページ7に含まれる内容の要旨
Adjusting the water softener To prevent limescaling on the dishes and to the interior of the Contact your local Water Authority to find the dishwasher, the dishes must be washed with soft water. exact water hardness level for your area. This dishwasher is equipped with a water softener, where tap- The water softener has 5 settings: water which is harder than 4 °d (german degree) is softened. Adjust the water softener according to the table below for the water hardness level for your area. Water
ページ8に含まれる内容の要旨
Programme chart All types of Coffee cups, Type of Plates and dishes cooking pots dishes delicate items • heavily Type of soil: • normally • normally • lightly • lightly soiled soiled soiled soiled soiled • dried-on food • dried-on food remnants remnants especially egg- white and starch Suitable programme: INTENSIVE NORMAL ENERGY SAVE QUICK GLASS 3) 70° C 65° C 55° C 50° C 40° C Programme- Pre-wash Pre-rinse Pre-rinse - - 1) Washing Washing Washing Washing Washing cycle: 2 x rinses Rinse Rinse
ページ9に含まれる内容の要旨
Loading and unloading the dishwasher How to load the dishes Baskets The illustration shows the dishwasher loaded with six Main basket place settings. Your own dishes are not likely to be Cutlery basket identical to this load, but if you follow the advice below The cup shelves can be placed in two different we are sure you will be pleased with the results. levels. l Always place glasses, cups and bowls upside down. l Incline deep dishes (soup plates etc.) so that the water can run off when dryi
ページ10に含まれる内容の要旨
Using the appliance Starting the programme Pause function 1. Scrape or rinse off solid food remnants. With the pause function the programme can be temporarily interrupted for a short period of time. 2. Load the dishwasher. (See the basket and loading). 1. Open the door and press the On/Off button. The programme stops. 3. Put the correct amount of detergent into the detergent dispenser and close the lid. 2. All lamps go out. 4. Press in the On/Off button. All programme 3. When you want the
ページ11に含まれる内容の要旨
Maintenance and cleaning Cleaning the filters Moving the dishwasher There are two filters, a coarse one and a fine one which If you have to move the dishwasher (you are moving should be cleaned after every wash. Lift out these filters house, etc): which are in the base of the dishwasher and wash under 1. Unplug it. running water. 2. Turn off the water tap. The dishwasher must not be used without the 3. Remove the water inlet and discharge hoses. filters. Incorrect repositioning of the filters will pr
ページ12に含まれる内容の要旨
Something Not Working Before calling out an engineer, please check through the details below because some faults can be rectified easily without the need to call out an engineer. If an engineer is called to resolve a problem listed below or to repair a fault caused by incorrect installation or mis-use a charge will be made, even if the appliance is under guarantee. Fault Check • Is the door closed properly? The programme will not start. • Have you pressed the On/Off button? • Is the water tap tu
ページ13に含まれる内容の要旨
Service Service and Spare Parts Customer Care Department In the event of your appliance requiring service, or if you For general enquiries concerning your Electrolux appliance wish to purchase spare parts, please contact your local or for further information on Electrolux products, please Service Force Centre by telephoning: contact our Customer Care Department by letter or telephone at the address below or visit our website at 08705 929929 www.electrolux.co.uk Customer Care Department Your tel
ページ14に含まれる内容の要旨
Guarantee Conditions Standard guarantee conditions We, Electrolux, undertake that if within 12 months from the date of the purchase this ELECTROLUX appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour, materials or carriage on condition that: • The appliance has been correctly installed and used only on the electricity supply stated on the rating plate • The applianc
ページ15に含まれる内容の要旨
Installation instructions Any electrical work required to install this appliance, should be carried out by a qualified electrician or competent person. Any plumbing work required to install this appliance, should be carried out by a qualified plumber or competent person. Technical specifications Capacity: 6 place settings accordance EN 50242 Dimensions: Height 447 mm Width 546 mm Depth 493,5 mm Weight: Net 22 kg Water pressures: Minimum 80 kPa (0,8 bar) Maximum 1000 kPa (10 bar) Water temperature:
ページ16に含まれる内容の要旨
Unpacking Damages If the dishwasher has been damaged during transport, you should immediately notify the company responsible for delivering it. If you discover any damage, faults or that anything is missing, you should notify your retailer immediately. 1 2 Never leave packaging material in a place where children may play with it. Risk of suffocation! Check that the following accessories are supplied with the dishwasher when you unpack it: 4 3 – A funnel for filling salt (1) – Elbow for discharge
ページ17に含まれる内容の要旨
Installation Position The machine is basically designed to be built into a cup- board. It is vital to ensure that the machine is positioned on a horizontal level in order for it to function properly and so that the door can be properly closed. Make sure that the shelf for the dishwasher is properly secured inside the cupboard. The cupboard must be secured properly onto the wall and the front edge of the shelf must be level with the sides of the cupboard. Measurements for fitting a wooden door Opt
ページ18に含まれる内容の要旨
Installation Preparing the outer door Screw the guide rods and hinges on the door into place using the predrilled holes. Mount plate 2x Before installing the dishwasher and adjusting the door onto the cupboard, put the mount plate into its correct position on the shelf. 1. Place the mount plate in the middle of the cup- board. Mark the holes for screws and the holes for dismounting the outer door. There is a middle mark on the plate to help you. 2. Drill 4 holes with a diameter of 7 mm. The doo
ページ19に含まれる内容の要旨
Installation Fitting the outer door 1. Unscrew the screws on the mounting plate. Lift the plate off together with the door. 2. Lay the machine down on its back. Check that none of the hoses are trapped. Insert the guide rods into the plastic door guides. 3. Slot the tabs on the mounting plate into the holes on the front plinth of the machine and screw the mounting plate into place using the 2 screws provided. Fitting protective and infill strips In order to fill the gap between the cupboard
ページ20に含まれる内容の要旨
Installation Installing the dishwasher 1. Put the dishwasher into the cupboard and screw the mounting plate into position from underneath with 2 screws, with the washers between. 2. Put the spacers provided at the sides of the machine and screw the machine into place in the cupboard. Check that there is a space between the cupboard frame and the wooden door when it is shut. - 20 -
