ページ1に含まれる内容の要旨
ページ2に含まれる内容の要旨
Installation Preparation PARTS SUPPLIED: Two #8 Phillips flat head wood screws, 5/8" long to secure dishwasher to underside of countertop or sides of cabinetry. (Taped to top or side of dishwasher.) 2 Wood Screws Side and top trim pieces Trim Pieces Trim Panel Accessory Kit (not shown). (some models) Model PDW9700 only Hose Clamp Drain Hose and Hose Clamp Drain Hose MATERIALS YOU WILL NEED : Ferrule, compression nut and 90° Elbow (3/8"NPT external thread on one end, opposite end sized
ページ3に含まれる内容の要旨
Installation Preparation PREPARE DISHWASHER ENCLOSURE • The dishwasher must be installed so that drain hose is no more than 10 feet in length for proper drainage. This Wall Area must be Free of WARNING Pipes or wires To reduce the risk of electric shock, fire, or injury to 34-1/2"±1/4" 24" Underside of 5" 5" Min. persons, the installer must ensure that the dishwasher 4" 4" Countertop is completely enclosed at the time of installation. to Floor Cabinets Countertop CLEARANCES: When Square insta
ページ4に含まれる内容の要旨
Installation Preparation PREPARE ELECTRICAL WIRING Alternate WARNING Receptacle Location FOR PERSONAL SAFETY: Remove house fuse or open circuit breaker 18" 1-1/2" Dia. before beginning installation. Do not Hole (Max.) use an extension cord or adapter plug 18" with this appliance. 3" 6" 6" Electrical Requirements from Cabinet • This appliance must be supplied with 120V, 60 Hz., and connected to an individual properly grounded branch 24" from Wall circuit, protected by a 15 or 20 ampere circuit br
ページ5に含まれる内容の要旨
ページ6に含まれる内容の要旨
ページ7に含まれる内容の要旨
ページ8に含まれる内容の要旨
ページ9に含まれる内容の要旨
ページ10に含まれる内容の要旨
ページ11に含まれる内容の要旨
ページ12に含まれる内容の要旨
ページ13に含まれる内容の要旨
TM ™ PDW9700JII – GE Profile Fully Integrated Built-In Dishwasher Built-In Dishwasher Dimensions (in inches) Installation Information (in inches) Custom Panel for Model PDW9700JII Dishwasher comes panel-ready. ††† 24 24 Countertop Custom This wall area Countertop Panel Size must be free of 90° 90° pipes or wires 24" 22-1/2 Cabinets Electrical 4 4 MIN. wiring is Side A 4 3" from View cabinet 55 Hot water Electrical 34" to 34-3/4" line on wiring on 6 Underside 6 Floor left right of countertop B
ページ14に含まれる内容の要旨
Top of Panel Top of Panel Trim Around Dotted Line Trim Around Dotted Line 2-9/32" 2-9/32" 11-5/16" 11-5/16" Drill 3/32" Drill 3/32" Pilot Hole Pilot Hole 3/32" Deep 3/32" Deep STEP 5 INSTALL CUSTOM HANDLE Screws Must 3/4" Thick Custom Panel A custom handle must be installed onto the Be Countersunk Into Panel panel before the panel is secured to the dish- 4-1/2" Max. From Top washer door. Template Instructions of Panel The handle should be installed so that it aligns with adjacent drawer
ページ15に含まれる内容の要旨
