ページ1に含まれる内容の要旨
DV 62
Dishwasher
Installation and use
ページ2に含まれる内容の要旨
ページ3に含まれる内容の要旨
Safety Is a Good Habit to Get Into NOTICE - If the appliance is not operating properly or maintenance Carefully read the instructions contained in this manual, as must be performed, disconnect the appliance from the power they provide important information which is essential to safe supply. and proper installation, use and maintenance of the 5.Keep detergents out of the reach of children, who must appliance. also be kept away from the dishwasher when it is open. 6.This appliance cannot be instal
ページ4に含まれる内容の要旨
Close-up View (Interior) E G F H J I K L Upper Rack Bottom Sprayer Arm Top Sprayer Arm Salt Container Cap Rack Height Adjustor Washing Filter Lower Rack Detergent and Rinse Aid Dispenser Technical characteristics Width cm. 59,5 Depth cm. 57 Height cm. 82 Capacity 12 standard place settings Mains water pressure 20 KPa÷ 1MPa (0,2 ÷10 bar) Power voltage See data plate Total absorber power See data plate Fuse See data plate GB 2
ページ5に含まれる内容の要旨
Salt, Detergent and Rinse Aid After pouring in the detergent, replace the lid, pressing down Salt until it clicks. The hardness of the water varies from place to place. If hard water is used in the dishwasher, deposits will form on Dishwasher detergent in tablets is now available on the the dishes and utensils. market, in which case you should place one tablet into The appliance is equipped with a special softener that uses container "D" and close the lid. a salt specifically designed to elimina
ページ6に含まれる内容の要旨
Loading the Dishwasher Upper Rack Before placing the dishes in the dishwasher, remove the Lower Rack larger food particles to prevent the filter from becoming clogged, which results in reduced performance. If the pots and pans have baked-on food that is extremely hard to remove, we recommend that they be allowed to soak before they are washed. This will eliminate the need for extra wash cycles. Pull out the racks to facilitate loading the dishwasher. How to Use the Lower Rack We recommend that y
ページ7に含まれる内容の要旨
Turning on the Appliance Starting a wash cycle.... If you forget to load some of the dishes... 1. Make sure that the plug for the appliance is inserted The wash cycle can be interrupted by pressing the ON-OFF into the wall socket. button. You can then load additional dishes and turn the 2. Make sure that the water supply is turned on to full appliance back on. The cycle will start where it left off. pressure. 3. Load the dishwasher (see the section entitled, "Loading At the end of the wash cycle
ページ8に含まれる内容の要旨
Wash Cycle Table Detergent Cycle Selection for Rinse Aid Cycle Description of Cycle Pre-wash + Information Wash Pre-wash with hot water (45°C) Very dirty dishes, pots Pre-wash with cold water and pans (not to be used Extended wash at 65°C. JU
Rinse with hot water at 65°C. with delicate items). Drying. Heavy Duty 2 Pre-washes with cold water. Normally dirty dishes, Extended wash at 65°C. pots and pans. Standard JU
Rinse with hot water at 65°C. daily cycle. Drying. Normal Wash For
ページ9に含まれる内容の要旨
Energy Saving Tips - Use the right amount of detergent: if you use too much - It is important to try and run the dishwasher when it is fully detergent, the result will not be cleaner dishes, but, rather, loaded in order to save on energy. In order to prevent odors a greater negative impact on the environment. from forming and food from caking onto the dishes, you can run the hold cycle. - There is no utility in rinsing dishes, cookware and utensils before placing them in the dishwasher. - Choose
ページ10に含まれる内容の要旨
Cleaning and Special Maintenance The dishwasher must Filter Assembly never be used without For best performance and the filters. Improper results, the filter assembly C replacement of the must be cleaned frequently. filters may reduce the The filter efficiently removes performance level of food particles from the wash A the appliance and water, allowing it to be damage dishes and recirculated during the utensils. cycle. For this reason, it is a good idea to remove the Cleaning the Sprayer Arms
ページ11に含まれる内容の要旨
Installation Positioning the Appliance Drain Hose Connection Position the appliance in the desired location. The back Insert the drain hose into a should rest against the wall behind it, and the sides, along drain pipe with a minimum the adjacent cabinets or wall. The dishwasher is equipped diameter of 4 cm., or let it run A with water supply and drain hoses that can be positioned to into the sink, making sure to the right or the left to facilitate proper installation. avoid bending or crimping
ページ12に含まれる内容の要旨
Electrical Connection As the colours of the wires in the mains lead may not Electrical Connection correspond with the coloured markings identifying the If your appliance is supplied with a 13 amp. fused plug it terminal in your plug, proceed as follows: can be plugged into a 13 amp socket for immediate use. connect Green & Yellow wire to terminal marked “E” or Before using the appliance please read the instruction below. coloured Green or Green & Yellow. Connect Brown wire to terminal marked “L”
ページ13に含まれる内容の要旨
ページ14に含まれる内容の要旨
ページ15に含まれる内容の要旨
ページ16に含まれる内容の要旨
Merloni Elettrodomestici Viale Aristide Merloni 47 60044 Fabriano Italy Tel +39 0732 6611 Fax +39 0732 662501 www.merloni.com 01/01 - 195029005.00 - Xerox Business Services - DocuTech
