ページ1に含まれる内容の要旨
Instruction Manual
Warranty card
HDD installation card
ページ2に含まれる内容の要旨
Linux OS Set-top box with PCMCIA interface for CA modules, for receiving clear and encoded ASTRA and EUTELSAT DVB programmes. • Connector for internal hard disk • Compact Flash reader • Graphical display
ページ3に含まれる内容の要旨
1. Remote control Shift/Set-up function On / standby TV control mode Dreambox control mode Numeric keypad Page back Page forwards Mute mode Volume +/- Bouquet selection Channel information LAME! Main menu Direction keys OK (selection) Audio menu VCR menu (video recorder) Option keys red, green, yellow, blue VCR control Help menu TV mode Videotext Radio mode 3 1. Remote control
ページ4に含まれる内容の要旨
2. Views 4 2. Views Send/receive diodes Display 2.1 Front view CI-module Compact Flash Smartcard reader Channel up/down Power on/of AC3 audio Out 2.2 Rear view TV connector Ethernet USB Port LNB In Mains power supply Video recorder Audio Out Mini DIN RS 232 LNB Out 230 V / 50 HZ analog
ページ5に含まれる内容の要旨
3. Table of contents Chapter Page 1. Remote control . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 2. Dreambox views . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 3. Table of contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 4. Safety instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 - 9 4.1 Periods of non-use . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 4.2 Additiona
ページ6に含まれる内容の要旨
3. Table of contents 16.3 DreamUp – backup function . . . . . . . . . . . . . . . . . . . . . . . . . 40-41 16.4 DreamUp – delete operating software . . . . . . . . . . . . . . . . . 42-43 16.5 DreamUp – flash operating software . . . . . . . . . . . . . . . . . . . 43-46 16.6 Reset Dreambox to factory settings . . . . . . . . . . . . . . . . . . . 46 17. Set-up TV control . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 47 17.1 Programming sequence . . . . . . . . . . . . . . .
ページ7に含まれる内容の要旨
4. Safety instructions 4. Safety instructions For your protection, please read the safety instructions thoroughly before starting to use your DM 7000. The manufacturer accepts no responsibility for damage which occurs as a result of incorrect handling or from failure to observe the safety instructions. • The unit must be positioned such that it is sufficiently ventilated. • The cover of the unit must not be covered, and there must be sufficient distance from other equipment. The ventilation po
ページ8に含まれる内容の要旨
4. Safety instructions WARNING! Conversion or modification of the unit leads to loss of warranty if not carried out by a specialist dealer and certified in writing. WARNING! We recommend that disk drives should be installed by the dealer. The guarantee lapses if a hard disk is incorrectly installed. 4.1 Periods of non-use • If the unit is not operated for longer periods of time, it should be completely disconnected from the mains power supply. • The unit should also be disconnected from the m
ページ9に含まれる内容の要旨
4. Safety instructions Do not expose your Dreambox to direct sunlight, lightning or rain. Earthing: The LNB cable must be earthed. The earthing system must conform to SABS 061. Cleaning: Remove the power cable of the Dreambox from the mains socket before you clean the Dreambox. Use a slightly damp cloth without cleaning agents. Connect your Dreambox only to sockets which are suitable for the purpose. Do not allow overloads to occur. General: Environmental temperature +15°C ... +35°C Atmospheri
ページ10に含まれる内容の要旨
5. Getting started 5. General notes Check that everything has been delivered. You should have received the following: 1receiver 1 power cable 1remote control 1 Instruction Manual (latest version available from http://www.dream-multiedia-tv.de ) 1guarantee card 2 batteries (1.5V microcell) 2 hard disk installation frames (supplied within the unit from the factory) 1IDE connection cable 1 power cable for the hard disk Optionally available: 1 infrared keyboard - Check the battery polarity carefully
ページ11に含まれる内容の要旨
5. Getting started, 6. Disposal notes, 7. Important notes on operation 5.2 RS 232 serial interface The RS 232 interface is used to update the operating software and for pre-programming with a PC. 5.3 Ethernet The Ethernet interface can be used to update the operating software and for pre-programming with a PC. 6. Disposal notes The packaging of the DM 7000 consists exclusively of recyclable materials. Please dispose of these appropriately. Take care that dead batteries from the remote control an
ページ12に含まれる内容の要旨
8. Main menu 8. Main menu This OSD (On Screen Display) is used to navigate to the individual submenus. Here you can enter the File menu. Here you can enter the Info menu. Here you can switch your Dreambox into deep standby mode. Here you can enter the Setup menu. Here you can enter the Games menu. 12 8. Main menu
ページ13に含まれる内容の要旨
8. Main menu Here you can switch the Scart connection between video input and output. Here you can enter the Timer menu. Switches to TV mode. Switches to radio mode. 13 8. Main menu
ページ14に含まれる内容の要旨
8. Main menu 8.1 Info menu With the direction keys on your remote control you can enter the following sub-menus: 14 8. Main menu
ページ15に含まれる内容の要旨
8. Main menu 8.2 Games menu In this menu, you can choose between the Snake and Tetris games, or call up the videotext decoder. 8.3 File menu You can use this to manage the files on the hard disk. 8.4 Set-up menu With the direction keys on your remote control you can enter the following sub-menus. 15 8. Main menu
ページ16に含まれる内容の要旨
8. Main menu 8.4.1 Channels – channel search Automatic search: Manual search: 8.4.2 Channels - satellites 16 8. Main menu
ページ17に含まれる内容の要旨
8. Main menu With this menu you can edit the satellites, or add one or more. Satellites are added with „New“. Editing is done in the respective selection. Leave this menu with „Close“. Under the „LNB“ item you can edit and add LNBs. If you activate „increase voltage“, the voltage to the LNBs is increased by 0.5 volts. This is necessary for longer antenna connections, or for antenna cables with excessive attenuation. After entering your set-up, store your settings with „Save“, or cancel. 8.4.3 Ch
ページ18に含まれる内容の要旨
8. Main menu After entering your set-up, store your settings with „Save“, or cancel. 8.4.4 Network Here you set up the configuration for your network. IP: Enter the IP address of your Box here (e.g. 192.168.0.5). Network mask: (e.g. 255.255.255.0) Name server: Enter a name server here 18 8. Main menu
ページ19に含まれる内容の要旨
8. Main menu (e.g. 194.25.0.60, 194.25.0.68, 194.25.0.52 of Deutsche Telekom (http://www.telekom.de/dtag/ipl1/cda/level4s_a/0,3682,17684,00.html)). Gateway: Enter the standard gateway here (e.g. 192.168.0.1) (e.g. 192.168.0.1, the IP address of your router). After entering your set-up, store your settings with „Save“, or cancel. 8.4.5 OSD This allows you to configure the OSD (On Screen Display). Transparency: Select the transparency of the OSD. Brightness: Select the brightness of the OSD. Cont
ページ20に含まれる内容の要旨
8. Main menu This allows you to adjust brightness, contrast and stand-by brightness. After entering your set-up, store your settings with „Save“, or cancel. 8.4.7 Remote control This allows you to configure your remote control. You can adjust the repeat rate and the delay rate. After entering your set-up, store your settings with „Save“, or cancel. 8.4.8 Video This allows you to configure your video set-up. Colour format: Choose between RGB, SVideo and FBAS. Aspect ratio: Choose between 4:3 le
