ページ1に含まれる内容の要旨
INSTALLATION &
OPERATION MANUAL
Digital Video Recorder
DVR-3024M / DVR-3024MD
Before trying to connect or operate this product, please read this manual completely
ページ2に含まれる内容の要旨
ページ3に含まれる内容の要旨
SAFETY PRECAUTIONS All the following safety and operated instructions which will prevent harm or damage to the operator and other persons should be read before the unit is operated. INFORMATION This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environme
ページ4に含まれる内容の要旨
CONTENTS 1. INTRODUCTION ................................. 3 3.5.2 Mobile Rack HD Backup Operations................................................. 25 1.1 Product Introduction..................................3 3.5.3 SD Card Backup Operations ........ 26 1.2 Product Features ......................................3 3.6 Key Lock Operation ............................... 27 1.3. FRONT / REAR VIEW .............................4 4. MENU SETUP....................................28 1.3.1 Fron
ページ5に含まれる内容の要旨
1. INTRODUCTION 1. INTRODUCTION 1.1 Product Introduction ‧Audio function included (16 bits, 11 / 22 kHz, The four channel Digital Video Recorder μ-law). (DVR) of MPEG4 format provides high quality ‧Built-in SD memory card slot to save storage of up to four video sources. The JPEG/AVI image(s) to an SD memory card. MPEG4 is a very small size file, so it can save ‧Daylight saving setting. more images over a longer time and can be ‧Controls multiple brand Pan/Tilt/Zoom sent extreme
ページ6に含まれる内容の要旨
INTRODUCTION ( continued ) 1.3. FRONT / REAR VIEW 1.3.1 Front View DVR-3024MD DVR-3024M (FOR CD-ROM MODEL) (FOR REMOVABLE HDD MODEL) 1 23 2 24 3 4 5 6 PLAY STOP REC PAUSE REV FWD ZOOM Power Display Setup Search Enter Seq./Save A-rec T-rec DISK Power 7 8 9 10 11 14 13 12 15 16 17 18 19 20 21 22 1 1 CD-RW device compartment: Hard-disk drive compartment: The compartment allows you to burn the data The compartment allows you to install a mostly for backup purpo
ページ7に含まれる内容の要旨
3 PAUSE button: In a playback display, press this to freeze the display. During the freeze, press it to display one frame/field of a picture at a time in the forward direction. (Illuminate green in PAUSE mode.) 4 PLAY button: Press to play back a recorded video from the hard disk. (Illuminate green in PLAY mode.) 5 STOP button: Press to stop playing back a recorded video. (Illuminate green in STOP mode.) 6 REC button: Push to start recording video into a hard disk while in the liv
ページ8に含まれる内容の要旨
the hard-disk drive is storing or retrieving data. The red light signals the hard-disk drive is filling up. The orange light indicates the hard-disk is retrieving at disk-full status. 20 Shuttle Ring: The shuttle can be moved forward and backward for playback in either direction. Turn this left to play a recorded video in the reverse direction at faster or slower speeds than the recorded speed. Turn this right to play a recorded video in the forward direction at faster or slower speeds th
ページ9に含まれる内容の要旨
1.3.2 Rear View 25 26 27 28 IN hi-z OUT 75 SD Card RS-485 IN RS-232 ETHERNET OUT MONITOR AUDIO ALARM I/O DC12V 30 34 35 36 37 29 31 32 33 25 VIDEO IN Connector: These 4 BNC connector including SWITCH OUT, GROUND, connectors are used to connect the video ALARM OUT, DISK FULL, RECORD IN, output from a camera ALARM RESET, and ALARM IN for 26 Hi-Z/75 Ω Individual termination: These 4 connecting with external devices. Please refer switches are used to set the imped
ページ10に含まれる内容の要旨
1.4 ALARM In / Out DISK FULL ALARM RESET ALARM OUT RECORD IN GROUND 5 4 3 2 1 9 8 7 6 ALARM1 IN ALARM4 IN ALARM2 IN ALARM3 IN The above figure is the rear view. 7. ALARM3 IN (INPUT): same as the above, 1. GND: Ground Contact. for CH 3 2. ALARM OUT (OUTPUT): This is an 8. ALARM2 IN (INPUT): same as the above, alarm output trigger. Connect this to for CH 2 external devices such as buzzers or 9. ALARM1 IN (INPUT): same as the above, lights. for CH 1 5V 0V(Active)
ページ11に含まれる内容の要旨
2. INSTALLATION 2. INSTALLATION Please follow the instruction and the diagram below to set up the system. 2.1 Basic Connection A. CONNECTING WITH 1 to 4 CAMERAS Camera Camera Camera Camera IN hi-z OUT 75 SD Card RS-485 IN RS-232 ETHERNET OUT MONITOR AUDIO ALARM I/O DC12V Monitor B. ATTACHING AN EXTERNAL DEVICE TO DVR Connect an alarm out, alarm input, and a peripheral device as shown in the diagram below. Trigger Out IN hi-z OUT 75 SD Card RS-485 Alarm
ページ12に含まれる内容の要旨
INSTALLATION ( continued ) proceeding with the recording function. The jumper-setting arrangement of installed 2.2 Hard-disk Drive Installation hard-disk drives for the system (Table 3.2 A.) The DVR is equipped with two compartments is shown in the tables below. of hard disk drive (for removable model only). The unit usually comes with one Note: The CD-RW model is equipped with a hard-disk drive installed in the compartment fixed hard- disk and a CD-RW drive. The unit of HD1, whi
ページ13に含まれる内容の要旨
Table 3.2 B. Compatible hard-disk drives Manufacturer Model Capacity Rotation Seagate ST340810A 40G 5400 RPM ST380020A 80G 5400 RPM ST320014A 20G 5400 RPM ST340015A 40G 5400 RPM ST380012ACE 80G 5400 RPM ST3120025ACE 120G 5400 RPM ST340014A 40G 7200 RPM ST380011A 80G 7200 RPM ST380013A 80G 7200 RPM ST3120026A 120G 7200 RPM ST3160023A 160G 7200 RPM ST3200822A 200G 7200 RPM ST3250823A 250G 7200 RPM ST3400832A 400G 7200 RPM Maxtor 4A160J0-1A 160G 5400 RPM 4R080L0-1 80G 540
ページ14に含まれる内容の要旨
2.3 System Information and Channel Selection FIGURE 3.3 A 2.3.1 System information 1+2 :59G 12.4 HR You can display system settings information as QUALITY : BEST NTSC shown in FIGURE 3.3 A below at any time by RATE : 6HR 30 F/S 8 pressing the Display button . In the 200 K playback mode, the recorded video information HD SIZE REC PLAY 1 20G 10.0% 0.1 % is displayed. In the live or recording mode, the 2 39G 0.0% 0.0 %
ページ15に含まれる内容の要旨
5. Restart the unit when the device sounds a tone twice and displays the message “PLEASE Mode Key Result Display RESTART”. The process is complete. Live / Quad (If you have already followed the procedures 1~5, Record ( ) and the unit is still unable to switch on, please first CH1/ ( Single channel ) check if the SD card you are using is functioning CH2/ and the file is intact. And then start procedures 1 CH3/ ~ 5 all over again.) CH4 6. Verify the version of the system
ページ16に含まれる内容の要旨
3. OPERATIONS 3. OPERATIONS 80GB hard-disk drive will be filled in 41 hours This section shows you how to operate and (see the gray area in the table). If the total manage the DVR when it gets in the way. capacity of 240GB hard-disk drives is in use under the same refresh rate and picture quality, it will be filled in 123 hours (3 times the rate of a 3.1 Configuring Recording 80GB hard-disk drive). Settings Recording time will vary depending on the image size, recording ra
ページ17に含まれる内容の要旨
(2) Select the CLOCK / TIMER and press the 3.2 Recording Operations 15 This section details the way to record video Enter button to enter the CLOCK / into hard-disk drives. Before commencing with TIMER page. the recording function, please configure the (3) Select the TIMER－SET. 15 recording setting properly according to your (4) Press the Enter button to enter the REC needs. SCHEDULE table. 11 3.2.1 Manual Recording (5) You can set up by using the “<” button 14 Take the following s
ページ18に含まれる内容の要旨
6 MAIN MENU (8) Press the REC button for 3 seconds RECORD during the scheduled recording to stop it any ALARM / MOTION TIMER/ SEQ/ TITLE COMMUNICATION time. If you wish to continue the scheduled DISK 6 SYSTEM recording, press the REC button to proceed. GOTO ALARM/ MOTION PAGE ALARM / MOTION Note: You can proceed to start the scheduled recording from the current time if it is in the ALM OPERATION : OFF AUDIO : OFF scheduled
ページ19に含まれる内容の要旨
3.2.4 Externally Triggered Recording By connecting the RECORD IN of ALARM I/O on the rear panel of the DVR, you can activate/deactivate the recording function of a DVR. The file will be kept with a prefixed “R”. NOTE: The status of recording operations when an alarm takes place is shown in the diagrams below. 1 Manual or Externally Triggered Recording Alarm Takes Place Actual Recording Speed Normal Alarm Normal 2 Timer Recording Alarm Takes Place Actual Recordin
ページ20に含まれる内容の要旨
3.3 Playback Operations This section shows you how to operate the fast, message ( use SEARCH functions or rewind to slow, and single-picture playback functions, replay the file if required ) and details how the unit is to playback a file in a different operation status. Please refer to the 3.3.2 Fast Forward/Backward following paragraphs specifying the relevant details. When playing a file, the monitor should There are 7 speeds available for playback: 1x, display a flashing PLAY mess
