ページ1に含まれる内容の要旨
This product contains electrical or electronic materials. The presence of these materials may, if
not disposed of properly, have potential adverse effects on the environment and human health.
Presence of this label on the product means it should not be disposed of as unsorted waste
and must be collected separately. As a consumer, you are responsible for ensuring that this
product is disposed of properly.
Manufactured under license from Dolby Laboratories.
“Dolby” and the double-D symbol ar
ページ2に含まれる内容の要旨
ENGLISH ENGLISH FCC Federal Communications Commission Statement This equipment has been tested and found to comply with the limits of a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
ページ3に含まれる内容の要旨
Warnings and Precautions Warnings and Precautions To prevent any injuries, the following safety precautions should be observed in the installation, use, servicing and maintenance of this equipment. Before operating this equipment, please read this manual completely, and keep it nearby for future reference. This symbol is intended to alert the user to avoid the risk of electric shock. This equipment must not be disassembled by anyone except qualified service personnel. WARNING This symbol is in
ページ4に含まれる内容の要旨
ENGLISH ENGLISH Warnings and Precautions ▪ Use and handle the power cord with care. Do not place any heavy objects on the AC power cord. ▪ Do not pull the AC power cord. Do not handle the AC power cord with a wet hand. ▪ Do not touch the power cord and antenna cable during lightning. ▪ Remove the plug from the wall outlet, if the equipment will not be used for a long period of time. ▪ Do not place, use or handle this equipment near water. ▪ Never expose the equipment to liquid, rain, or mois
ページ5に含まれる内容の要旨
Warnings and Precautions Outdoor Antenna Safety Instructions If an outdoor antenna is connected, follow the precautions below: ▪ An outdoor antenna should not be located in any area where it could come in contact with overhead power lines, or any other electric light or power circuits. ▪ When installing an outdoor antenna system, extreme caution should be taken to prevent contact with power lines. Direct contact with power lines may be fatal and should be avoided at all costs. Section 810 o
ページ6に含まれる内容の要旨
ENGLISH ENGLISH TABLE OF CONTENTS Federal Communications Commission Statement .......................... 1 Warnings and Precautions Important Safety Instructions ....................................................................................... 2 Antenna Safety Instructions ......................................................................................... 4 Chapter 1 Introducing the LCD TV Key Features .............................................................................
ページ7に含まれる内容の要旨
Chapter 1 Introducing the LCD TV Chapter 1 Introducing the LCD TV Key Features Various Audio/Video terminals for external equipment connection ▪ 2 sets of composite A/V input terminals ▪ 1 set of S-VIDEO terminals ▪ 2 sets of component Video input terminals ▪ 1 VGA/ Audio input terminals ▪ 2 HDMI/Audio input terminals ▪ 1 set of Audio(L/R) output terminals ▪ 2 SPDIF output terminals (Optical x 1 /Coaxial x 1) ▪ 1 Headphone terminal The built-in TV tuner to receive HD ATSC ▪ This function allo
ページ8に含まれる内容の要旨
ENGLISH Chapter 1 Introducing the LCD TV Package Contents Make sure all of the following contents are included. LCD TV Bottom Stand / Screw Driver and Screws 4 Remote Control/ Power Cord AAA Batteries x 2 S.MODE MTS P. MODE CAPTION SLEEP P.SIZE MUTE VOL. INPUT CH. GUIDE EXIT INFO MENU User’s Manual Quick Start Guide Warranty Card These items are all you need to set up and operate the LCD TV in its basic configuration. Note: the photos of the accessories are for reference only,
ページ9に含まれる内容の要旨
Chapter 1 Introducing the LCD TV Setting Up Your LCD TV How to install the TV Stand Read all instructions before continuing with the stand installation. Attach the Stand the TV with the bottom foam packaging material still attached. a. Lift foam packaging material from the top of the LCD out of the box. b. Lift LCD out of the box, with the bottom foam packaging material still attached, and place onto a stable surface. a b Protective bag Stand Shipping box Table c. Remove protective bag from L
ページ10に含まれる内容の要旨
ENGLISH Chapter 1 Introducing the LCD TV How to remove the TV Stand If you prefer to mount your new Element Electronics TV on a wall instead of attaching it to the stand, please reference the instructions included in the wall mounting kit (sold separately). Verify your TV’s model and be sure to use the wall mounting kit specified for your TV model only. Contract your technician for assistance when installing the wall mounting kit. To prevent damaging the surface of the LCD TV, place the TV
ページ11に含まれる内容の要旨
Chapter 1 Introducing the LCD TV How to setup the TV Use a supplied antenna cable to connect the VHF/UHF signal to the LCD TV’s ANT. terminal (refer to page15-17). Connect the AC power cord at the back of the TV and connect the power cord to wall outlet. Insert the 2 batteries supplied in remote control. Step1 Slide the back cover up to open the battery compartment of the remote control. Step2 Insert two AAA size batteries. Make sure to match the (+) and ( - ) ends of the batterie
ページ12に含まれる内容の要旨
ENGLISH Chapter 1 Introducing the LCD TV Your LCD TV Front/Right Side View and Controls IR Infrared Receiver LED The LED light is red when the LCD TV is in standby and the LED light is blue when powered up. VIDEO/AUDIO(L/R) IN Connects to the Composite VIDEO and AUDIO(L/R) output jacks on external video equipment. HEADPHONE Connects to the external headphone for private listening. Right Side View and Controls VOL+/VOL- Adjusts the volume up and down. Selects the main-menu item and chang
ページ13に含まれる内容の要旨
Chapter 1 Introducing the LCD TV Rear View and Jacks For ELCTW401 1 1 2 2 3 3 4 4 5 5 6 6 HDMI 1 IN HDMI 2 IN VGA IN AUDIO OUT YPbPr1 IN DIGITAL STEREO AUDIO AUDIO Y Pb Pr AUDIO OPTICAL HDTV/TV Air/Cable L R L R L R L COAXIAL Y Pb Pr AUDIO 7 7 VHF/UHF IN L R L R L R R VIDEO AUDIO S-VIDEO AUDIO YPbPr2 IN VIDEO2 IN S-VIDEO IN YPbPr1 IN AUDIO VIDEO 1 IN Y Pb Pr L R L VIDEO TV 9 9 8 8 CABLE/AIR HDMI1 IN HDMI2 IN PC AUDIO IN VGA IN Y Pb YPbPr2 IN Pr L AUDIO R RS-VIDEO IN S-VIDEO COAXIAL For ELCTQ261
ページ14に含まれる内容の要旨
ENGLISH Chapter 1 Introducing the LCD TV Your Remote Control Turns the LCD TV on and off. 1 2 MTS Cycles through the multi-channels TV 2 sound(MTS) options: SAP/MONO/ STEREO 1 1 3 S.MODE Selects sound effect options: Surround/ 2 2 Live/Dance/Techno/Classic/Soft/Rock/ Pop/Off. S.MODE MTS P. MODE 3 3 4 4 4 P.MODE Selects picture mode: Vivid/Hi-Bright/ CAPTION SLEEP P.SIZE 6 6 Cinema/Sport/User 5 5 7 7 5 P.SIZE Cycles through Wide mode settings : NORMAL /FULL/WIDE/ZOOM 8 8 6 CAPTION Cycles throu
ページ15に含まれる内容の要旨
Chapter 2 Installing the LCD TV 13 INPUT Pressing INPUT display the source list, use ▲▼ to select the video equipment connected to the video inputs of your LCD TV : TV/HDTV/VIDEO1/VIDEO2/ VIDEO3/VIDEO4/VIDEO5/VIDEO6/ COMPUTER Input Source TV(CABLE/AIR) VIDEO1 (SIDE) VIDEO2 (REAR) VIDEO3 (S-VIDEO) VIDEO4 (YPbPr1) VIDEO5 (YPbPr2) VIDEO6 (HDMI1) VIDEO7 (HDMI2) COMPUTER(VGA) GUIDE Displays the Program Guide on the 14 screen. Pressing again to turn GUIDE off. 15 EXIT Exits th
ページ16に含まれる内容の要旨
ENGLISH Chapter 2 Installing the LCD TV Chapter 2 Installing the LCD TV Refer to the owner’s manual of any external equipment to be connected. When connecting any external equipment, do not connect any AC power cords to wall outlets until all other connections are completed. Connecting a TV Cable or an Antenna Antenna Connection The antenna requirements for good color TV reception are more important than those for a black & white TV reception. For this reason, a good quality outdoor antenna
ページ17に含まれる内容の要旨
Chapter 2 Installing the LCD TV Use one of the following two diagrams when connecting an outdoor antenna. A: Shows how to use a VHF/UHF combination outdoor antenna. B: Shows how to use a separate VHF and/or UHF outdoor antenna. A. Combination VHF/UHF antenna VHF/UHF Antenna 300/75-ohm adapter (not included) VHF/UHF Antenna 300-ohm twin- lead cable 75-ohm coaxial cable YPbPr1 IN AUDIO VIDEO 1 IN Y Pb Pr L R L VIDEO TV CABLE/AIR HDMI1 IN HDMI2 IN PC AUDIO IN VGA IN Y Pb YPbPr2 IN Pr L AUDIO R R
ページ18に含まれる内容の要旨
ENGLISH Chapter 2 Installing the LCD TV Cable TV (CATV) Connection This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the National Electrical Code (NEC) that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building accurately, or as close to the point of cable entry as possible. Use of this TV for other than private viewing of programs broadcasted on UHF, V
ページ19に含まれる内容の要旨
Chapter 2 Installing the LCD TV Use a supplied antenna cable to connect the TV signal to the LCD TV’s TV CABLE terminal. HDTV/TV Air/Cable VHF/UHF IN YPbPr1 IN VIDEO 1 IN Y Pb Pr L AUDIO R L VIDEO TV CABLE/AIR HDMI1 IN HDMI2 IN PC AUDIO IN VGA IN Y Pb Pr L R R S-VIDEO COAXIAL YPbPr2 IN AUDIO S-VIDEO IN Connect the AC power cord at the back of the TV and connect the power cord to wall outlet. HDTV/TV Air/Cable VHF/UHF IN YPbPr1 IN VIDEO 1 IN Y Pb Pr L AUDIO R VIDEO L TV CABLE/AIR HDMI1 IN HDM
ページ20に含まれる内容の要旨
ENGLISH Chapter 2 Installing the LCD TV Press the button on the remote to turn on the LCD TV. Input Source TV(CABLE/AIR) VIDEO1 (SIDE) VIDEO2 (REAR) VIDEO3 (S-VIDEO) VIDEO4 (YPbPr1) VIDEO5 (YPbPr2) VIDEO6 (HDMI1) VIDEO7 (HDMI2) COMPUTER(VGA) Press the INPUT button on the remote to display the Input List. Use the ▲▼ buttons to select TV and press the OK button. TV Channel Scan Tuner Mode Cable Channel Skip Time Zone Eastern Time ok Enter Select
