ページ1に含まれる内容の要旨
LT-17E31 BJG
LT-17E31 SJG
LCD FLAT TELEVISION INSTRUCTIONS
1
Cover 1
ページ2に含まれる内容の要旨
P PD D- -4 42 2V V3 31 1B BU UE E/ /B BJ JE E/ /B BS SE E / / L LC CT T1 14 44 40 0- -0 00 01 1A A- -U U / / E En ng glliis sh h ( (E EK K) ) PD-42V31BUE(EK)_Eng.book Page 0 Friday, August 1, 2003 9:36 AM Warning DO NOT cut off the mains plug from this equipment. If As these colours may not correspond with the coloured the plug fitted is not suitable for the power points in your marking identifying the terminals in your plug proceed as home or the cable is too short to reach a power po
ページ3に含まれる内容の要旨
Thank you for buying this JVC LCD flat television. To make sure you understand how to use your new TV, please read this manual thoroughly before you begin. (“LCD” stands for Liquid Crystal Display.) WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. WARNING Always use the provided AC adapter and power cord. WARNING • Fingers may be trapped under the TV causing injuries. Hold the TV at the bottom in the middle, and do not allow it to tilt up or down. • T
ページ4に含まれる内容の要旨
Point defects LCDs use collections of fine pixels to display images. While there is no problem with more than 99.99% of these pixels, please understand that a very small number of pixels may not light or may light all the time. Distance recommendations Avoid improper installation and never position the unit where good ventilation is impossible. 200 mm 200 mm 150 mm 150 mm When installing this TV, distance recommendations must be maintained between the set and the wall, as well as inside a tig
ページ5に含まれる内容の要旨
LT-26C31BUE/SUE/BJE/SJE / LCT1484-001A-U / English (EK) LT-26C31BUE(EK)_Eng.book Page 3 Tuesday, August 5, 2003 2:18 PM CONTENTS Setting up your TV..................................4 Sound setting........................................ 18 Installation..........................................................4 Sound Adjustment........................................... 189 Using the stand ..................................................4 HYPER SOUND .......................................
ページ6に含まれる内容の要旨
Setting up your TV Installation Cautions for installation • Install the TV in a corner on a wall or on the floor so as to keep cords out of the way. • The TV will generate a slight amount of heat during operation. Ensure that sufficient space is available around the TV to allow satisfactory cooling. See “Distance recommendations” on page 2. Using the stand This TV comes with a Table Top Stand already Cable holder attached. A cable holder which is used to keep the connection cables This stand
ページ7に含まれる内容の要旨
LT-26C31BUE/SUE/BJE/SJE / LCT1484-001A-U / English (EK) LT-26C31BUE(EK)_Eng.book Page 5 Tuesday, August 5, 2003 2:18 PM Setting up your TV Putting the batteries into the Remote control Use two AA/R6 dry cell batteries. Insert the batteries from the - end, making sure the + and - polarities are correct. • Follow the warnings printed on the batteries. • Battery life is about six months to one year, depending on your frequency of use. • The batteries we supply are only for setting up and testin
ページ8に含まれる内容の要旨
Setting up your TV Connecting the aerial and video Connecting the power cord to the AC cassette recorder (VCR) outlet • The connecting cables are not provided. If you are connecting a AC adapter, follow • For further details, refer to the manuals provided with in the diagram below. the devices to be connected. • Connect to the TV and to the AC outlet. If you are connecting a VCR, follow in the diagram below. Caution If you are not connecting a VCR, follow . • Operate only from th
ページ9に含まれる内容の要旨
Initial settings When the TV is first turned on, it enters the initial setting 3 AUTO PROGRAM menu appears. mode. Follow the instructions on the on-screen display to make the initial settings. AUTO PROGRAM LANGUAGE ENGLISH COUNTRY UK A .P .S VCR/TV/DVD : :MOVE SELECT Switch 4 P / ress the buttons to choose the Yellow button LANGUAGE. Blue button 5 P / ress the buttons to choose the ENGLISH. OK The on-screen display will then be in English. BACK 6 Pre
ページ10に含まれる内容の要旨
Initial settings Now, the initial settings are complete, and you can watch the TV • If your TV can detect the TV channel name from the TV channel broadcast signal, the TV channel name is assigned to the programme number to which the TV channel has been set. However, which TV channels are set to which programme numbers will depend on the area in which you live. • If a TV channel you want to view is not set to a programme number, you can set it using the MANUAL function. For details, see “
ページ11に含まれる内容の要旨
LT-26C31BUE/SUE/BJE/SJE / LCT1484-001A-U / English (EK) LT-26C31BUE(EK)_Eng.book Page 9 Tuesday, August 5, 2003 2:18 PM TV buttons and functions Turn the TV on from standby mode 1 Press the button or P buttons to turn the TV / on from standby mode • Check that the AC plug on the power cord from the TV is connected to correctly AC outlet. Choose a TV channel Press the P / buttons to choose a programme number or an EXT terminal Watch images from external devices 2 Press the TV/AV button t
ページ12に含まれる内容の要旨
Remote control buttons and functions 1 Muting button 2 Number buttons 3 Information button 4 ZOOM button 5 button 6 button 7 / buttons 8 (Text) button 9 P buttons / 10 VCR/DVD/Teletext control buttons / 11 buttons 12 Standby button 13 VCR/TV/DVD switch 14 button AV 15 button 16 Picture button 17 Color buttons 18 MENU button 19 OK button 20 / buttons 21 BACK button 22 buttons Choose a TV channel Use the number buttons: Enter the programme number of the channel using the number buttons
ページ13に含まれる内容の要旨
Remote control buttons and functions Displaying the source information Adjust the volume You can display the source information and current time on Press the buttons to adjust the volume. The volume indicator appears and the volume changes as the screen. you press the buttons. Press the i (information) button to display the Muting the sound source information. Press the (muting) button to turn off the i (information) button changes the display as Pressing the sound. follows: Pressing t
ページ14に含まれる内容の要旨
Remote control buttons and functions Choose the ZOOM mode ZOOM function 1Press the ZOOM button to display the ZOOM You can change the screen size according to the picture menu aspect ratio. Choose the optimum one from the following • The button does not work in the twin ZOOM ZOOM modes. pictures mode. AUTO: When a WSS (Wide Screen Signalling) signal, which shows Adjusting the visible area of the picture the aspect ratio of the picture, is included in the broadcast If subtitles or the top
ページ15に含まれる内容の要旨
Remote control buttons and functions Sleep timer function The Sleep Timer can turn the TV off for you after you fall asleep. Program it to work in intervals of 10 minutes, for a total time of up to 120 minutes. Press the button. Picture mode You can choose one of four PICTURE MODEs to adjust the picture settings automatically. Press the PICTURE button. BRIGHT: Heightens contrast and sharpness. STANDARD: Standardizes picture adjustment. SOFT: Softens contrast and sharpness. MANUAL:
ページ16に含まれる内容の要旨
Teletext function Hold Basic operation You can hold a teletext page on the screen for as long as you want, even while several other teletext pages are being 1 Choose a TV channel with a teletext broadcast received. Press the (Hold) button 2 Make sure to set the VCR/TV/DVD switch to the TV position. Hold indication To cancel the Hold function: Press (Hold) button again. 3 Press (Text) button to display the teletext Pressing (Text) button changes the mode as follows: TV mode TEXT--- TEXT--
ページ17に含まれる内容の要旨
Teletext function Sub-page Cancel Some teletext pages include sub-pages that are You can search for a teletext page while watching TV. automatically displayed. 1 Press the number button to enter a page 1 Choose a teletext page that includes sub-pages number, or press a colour button Press the button, Sub-page numbers can be viewed The TV searches for a teletext page. and displayed at the screen. 2 Press the (Cancel) button 2 Press the number buttons to choose a sub-page The TV programme
ページ18に含まれる内容の要旨
LT-26C31BUE/SUE/BJE/SJE / LCT1484-001A-U / English (EK) LT-26C31BUE(EK)_Eng.book Page 17 Tuesday, August 5, 2003 2:18 PM Using the TV’s menu This TV has a number of functions you can operate using / 3 Press the buttons to choose a function menus. To use all your TV’s functions, you need to • For details of the functions in the menus, see the understand the basic menu operating techniques fully. following pages. 4 Pres s the / buttons to choose the setting of that function • If yo
ページ19に含まれる内容の要旨
PICTURE SETTING Refer to “Using the TV’s menu” (see page 17) for details of COLOUR TEMP. displaying the menu. PICTURE You can select one of three COLOUR TEMP. modes (three PICTURE MODE MANUAL tones of white) to adjust the white balance of the picture. CONTRAST Since white is the colour which is used as a reference for all BRIGHT-1 the other colours, changing the COLOUR TEMP. mode SHARP COLOUR
ページ20に含まれる内容の要旨
LT-26C31BUE/SUE/BJE/SJE / LCT1484-001A-U / English (EK) LT-26C31BUE(EK)_Eng.book Page 21 Tuesday, August 5, 2003 2:18 PM SOUND SETTING Refer to “Using the TV’s menu” (see page 16) for details of HYPER SOUND displaying the menu. You can enjoy Surround sound with a “live” effect by using SOUND the HYPER SOUND function. BASS ON: TREBLE function is turned on. HYPER SOUND BALANCE OFF: HYPER SOUND
