ページ1に含まれる内容の要旨
SOLAR CHARGER
65063
SEt up And OpERA tinG inStRuCtiOnS
®
distributed exclusively by Harbor Freight t ools .
3491 Mission Oaks Blvd., Camarillo, CA 93011
Visit our website at: http://www.harborfreight.com
Read this material before using this product.
Failure to do so can result in serious injury.
SAVE tHiS mAnuAL.
© ®
Copyright 2008 by Harbor Freight Tools . All rights reserved. No portion of this manual or any artwork
contained herein may be reproduced in any shape or form without the expr
ページ2に含まれる内容の要旨
nOtiCE is used to SAVE tHiS mAnuAL address practices Keep this manual for the safety warn- not related to personal injury. ings and precautions, assembly, operating, CAutiOn, without inspection, maintenance and cleaning pro- the safety alert cedures. Write the product’s serial number symbol, is used to address in the back of the manual (or month and practices not related to year of purchase if product has no num- personal injury. ber). Keep this manual and the receipt in a safe and
ページ3に含まれる内容の要旨
this product will increase the risk of 4. product use and care electric shock. a. do not force this product. use the d. do not abuse the AC/dC Adapter correct product for your applica- Cord. never use the Cord for car- tion. The correct product will do the rying, pulling or unplugging this job better and safer at the rate for product. Keep Cord away from which it was designed. heat, oil, sharp edges or moving b. disconnect the AC/dC Adapter parts. Damaged or entangled cords plug from
ページ4に含まれる内容の要旨
b. Use this product only with specifi- 5. Do not reverse the polarity of the cally designated batteries. Use of load, the Solar Charger, or the Bat- any other Battery may create a risk of tery. injury and fire. 6. Clean the surface of the Solar Char- c. under abusive conditions, liquid ger periodically with a clean, soft may be ejected from the Battery. cloth for best performance. Do not Avoid contact. if contact acciden- use solvents, acid, or alkali products. tally occurs, flush with wat
ページ5に含まれる内容の要旨
handling. (California Health & Safety double insulated t ools: t ools Code § 25249.5, et seq.) with t wo prong plugs 12. The warnings, precautions, and in- structions discussed in this instruction manual cannot cover all possible con- ditions and situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator. SAVE tHESE 1. Tools marked “Double Insulated” do not r
ページ6に含まれる内容の要旨
3. The smaller the gauge number of the SYmBOLOGY wire, the greater the capacity of the cord. For example, a 14 gauge cord Double Insulated can carry a higher current than a 16 gauge cord. (See t able A.) Canadian Standards Association 4. When using more than one exten- sion cord to make up the total length, Underwriters Laboratories, Inc. make sure each cord contains at least the minimum wire size required. Volts Alternating Current V~ (See t able A.) Amperes 5. If you are using one ex
ページ7に含まれる内容の要旨
unp ACKinG FiGuRE A When unpacking, check to make sure that the item is intact and undamaged. If 8 any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon 4 as possible. 2 7 OpERAtinG inStRuCtiOnS 5 3 6 Read the EntiRE impORt Ant 1 SAFEtY inFORmAtiOn section at the beginning of this 9 manual including all text under subheadings therein before set up or use of this product. 11 10 product Features 9 1. Electric current i
ページ8に含まれる内容の要旨
2. To charge the Battery (12) of the angle of the Solar Panel in relation Solar Charger, insert the Plug of the to the arc of the sun, and available AC/DC Adapter (11) into the Electric sunlight. Current Input Receptacle (6). 5. The Electric Current Input Lamp (1) (See Figure A.) will illuminate REd. In approximately 3. Plug the Power Cord of the AC/DC 4 to 6 hours, the Lamp will illuminate Adapter (11) into the nearest 110 volt, GREEn indicating the Solar Charger grounded, electrical ou
ページ9に含まれる内容の要旨
5. The Solar Charger will immediately tO pREVEnt SERiOuS begin charging the mobil unit, as indi- injuRY FROm pROduCt cated by the Electric Current Output FAiLuRE: Lamp (2) illumnating. do not use damaged (See Figure A.) equipment. if abnormal noise or vibration occurs, have the 6. IMPORTANT: Refer to the mobile problem corrected before unit manufacturer’s recommended further use. charge time for the unit. do not overcharge. Overcharging may inspection, maintenance, and damage the
ページ10に含まれる内容の要旨
pLEASE REAd tHE FOLLOWinG CAREFuLLY THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/ OR DISTRIBUTOR ExPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEM
ページ11に含まれる内容の要旨
pARtS LiSt & ASSEmBLY diAGRAm part # description Qty. 1 Input Indicator LED 1 2 Output Indicator LED 1 3 Flashlight Lamp 1 4 Circuit Reset 1 5 Flashlight Switch Button 1 6 AC/DC Adapter Input 1 7 DC Current Output 1 8 Solar Panel 2 9 Plug Adapter 5 10 Connection Cord 1 11 AC/DC Adapter 1 12 Lithium Battery (not shown) 1 8 4 2 7 5 3 6 1 9 11 10 9 Record product’s Serial number Here: note: If product has no serial number, record month and year of purchase instead. note: Some parts are listed and
