ページ1に含まれる内容の要旨
Register your product and get support at
www.philips.com/welcome
19PFL3505D
22PFL3505D
EN: For further assistance, call the customer support service in your country.
• To obtain assistance in the U.S.A., Canada, Puerto Rico, or the U.S. Virgin Islands, contact Philips
EN User manual Customer Care Center at 1-866-309-0841
• To obtain assistance in Mexico, contact Philips Customer Care Center at 01 800 504 62 00
Enter below the model and serial numbers located on the back and right side of the TV
ページ2に含まれる内容の要旨
Contents 9 Connect devices 25 1 Notice 4 Connection overview 25 Selecting your connection quality 26 2 Important 5 Connecting your devices 27 Product information 5 Screen care 5 10 Troubleshooting 29 Environmental care 5 Downloading an electronic copy 29 Regulatory notices 5 Contact us 29 3 Your TV 6 11 Product information 30 Side controls and indicators 6 Remote control 6 12 Warranty 31 4 Get started 8 Supplied accessories 8 13 Index 32 Standing mount the TV 8 Tilt stand (Available for 19PFL350
ページ3に含まれる内容の要旨
Return your Product Registration Card or register online at www.philips.com/welcome today to get the very most from your purchase. Registering your model with PHILIPS makes you eligible for all of the valuable benefits listed below, so don't miss out. Complete and return your Product Registration Card at once, or register online at www.philips.com/welcome to ensure: *Proof of Purchase *Product Safety *Additional Benefits Notification Returning the enclosed card guarantees By registering your
ページ4に含まれる内容の要旨
IMPORTANT SAFETY INSTRUCTIONS Read before operating equipment 1. Read these instructions. C. The appliance has been exposed to rain; or 2. Keep these instructions. D. The appliance does not appear to operate normally or exhibits a 3. Heed all warnings. marked change in performance; or 4. Follow all instructions. E. The appliance has been dropped, or the enclosure damaged. 5. Do not use this apparatus near water. 17. Tilt/Stability - All televisions must comply with recommended 6.
ページ5に含まれる内容の要旨
1 Notice Modifi cations The FCC requires the user to be notifi ed that any changes or modifi cations made to this device that are not expressly approved by 2009 © Koninklijke Philips Electronics N.V. All rights reserved. Philips Consumer Electronics may void the user’s authority to operate Specifi cations are subject to change without notice. Trademarks are the equipment. the property of Koninklijke Philips Electronics N.V. or their respective owners. Philips reserves the right to change produ
ページ6に含まれる内容の要旨
Environmental care 2 Impor tant Registering your model with Philips makes you eligible for all of the valuable benefi ts listed below, so don’t miss out. Complete and return your Product Registration Card at once, or register online at www.philips.com/welcome to ensure : • Proof of Purchase Returning the enclosed card guarantees that your date of purchase is on fi le, so no additional paperwork is required from you to The packaging of this product is intended to be recycled. Contact your
ページ7に含まれる内容の要旨
Remote control 3 Your TV Congratulations on your purchase, and welcome to Philips! To fully benefi t from the support that Philips offers, register your product at a www.philips.com/welcome b Side contr ols and indicators s c * r d q VOLUME e p e d f MENU g CHANNEL c o h b . POWER a n i a Standby indicator / remote control sensor j b . POWER Switches the TV on or off. The TV is not powered off completely unless it is physically unplugged. c CHANNEL +/- k Switches to the next or previous cha
ページ8に含まれる内容の要旨
c FORMAT Selects a picture format (see ‘Changing picture format’ on page 16). d SAP Digital Mode (DTV) • Press to select the audio language. Analog Mode (TV) • Press to select the audio mode. e FREEZE Press to pause screen image. f OK Activates a selection or accesses the menu. g (Navigation buttons) Navigates through the menus. h INFO Displays information about the TV channel or accessory device. The quality and accuracy of the information depends on the broadcaster. You might see a differ
ページ9に含まれる内容の要旨
Tilt stand 4 Get started (Available for 19PFL3505D only) You can adjust the stand to change the angle of the unit (-2° to 10°). Supplied accessories -2° 10° • Remote control • 2 x AAA, 1.5V batteries • M4 x 12 double sems screw x 4 • User manual • Quick Start Standing mount the TV Applicable to TVs without mounted stands. 1 P osition the TV W arning • Do not inser t the AC power cord into the power socket outlet before all the connections are made. • Lar ge screen TVs are heavy. Two pe
ページ10に含まれる内容の要旨
If you connect to a DBS (Direct Broadcast Satellite) Installing the r emote control batteries There are two main DBS systems : DirecTV and DishNetwork. These systems require a separate, proprietary set-top box to decode signals and send them to the TV. The set-top box contains a digital TV tuner for receiving off-air digital broadcasts. Contact your local DBS provider for more information about the connections and the TV channels. If you connect to a set-top box A cable box or satellite set
ページ11に含まれる内容の要旨
Managing cables Plugging in the AC power cord Route your antenna cable and all other cables through the cable holder Warning at the back of the TV. The holder helps keep your cables tidy and easily manageable. • V erify that your power voltage corresponds with the voltage printed at the back of the TV. Do not insert the AC power cord if the voltage is different. 1 Attach the cable holder as illustrated below. Connect the AC power cord plug to the power outlet. Ensure that the cord is tigh
ページ12に含まれる内容の要旨
Press Í or Æ 5 times to select the side of the pictures that is the most Switching on and set up the TV pleasing to you. then press OK. Before you switch on the TV, check that the AC power cord is properly . connected. Press POWER at the right side of the TV, or press . on Left side Right side the remote control. The TV normally takes 25-30 seconds to start up and the following screen appears the fi rst time you turn on the TV. Initial Setup Initial Setup English Select your menu languag
ページ13に含まれる内容の要旨
Switching channels 5 Use your TV This section helps you perform basic TV operations. Switching y our TV on/off or to standby CHANNEL . POWER Press CHANNEL +/- on the side of the TV. For digital channels, press a number (1 to 135) followed by a dot “.” and then the corresponding sub channel number (1 to 135). e.g. 108.30. • Press CH +/- or enter a number on the remote control. • Press PREV CH to return to the previously viewed channel. To switch on • Press . POWER at the side of the TV. • P
ページ14に含まれる内容の要旨
Adjusting v olume Still mode You can pause the image shown on the TV screen. Press FREEZE to pause the image shown on the TV screen. FREEZE VOLUME • The sound output will not be paused. • If no signal is detected or protected signal is received during still mode, the image remains paused and the sound output will be muted. • The still function will be released after 5 minutes. To cancel still mode, press any button except . (Standby-On). Watching channels from a set-top box To watch channel
ページ15に含まれる内容の要旨
TV Watching a Blu-ray Disc Press SAP to display the currently selected audio mode. While To watch a Blu-ray Disc receiving an MTS broadcast, press repeatedly to cycle through the 1 Insert a Blu-ray Disc into your player. available audio channel. 2 Press ► on the remote control of the Blu-ray Disc player to select 11 channels. SAP / STEREO » The Blu-ray Disc might automatically play on the TV. If the picture does not appear When all audio are available SAP / STEREO SAP / MONO SAP / STERE
ページ16に含まれる内容の要旨
PC settings 6 Use more of your TV This function lets you adjust the PC screen position, clock and phase during PC input. 1 Press MENU on the remote control and select [Features] > Changing pictur e and sound settings [PC Settings]. Y ou must set [Home] in [Location] (refer to page 21). 2 Adjust the setting. Otherwise, the settings you adjusted will not be memorized after you [Auto Adjustment] turn off the unit. Press or to select [Adjust], then press OK. • The horizontal/vertical posit
ページ17に含まれる内容の要旨
For 4:3 video signal Changing picture format 1 Press FORMAT on the remote control. [Normal] [16:9] 2 Press or to select a picture format and press OK to confi rm your choice. [Movie Expand] Summar y of picture formats 5 types of display modes can be selected when the broadcasting station is sending 16:9 or 4:3 video signal. And 3 types of display modes can be selected for PC input signal. For 16:9 video signal [Wide] [Zoom] Normal Display a 4:3 picture at its original size. Sidebars appear
ページ18に含まれる内容の要旨
[TV Speakers] Using your TV as a PC monitor This option will allow you to select the audio output from the Use a VGA connector to connect a PC to your TV. For sound, add an unit’s speakers. If you have an amplifi er which is compatible with audio cable with a stereo mini jack. the CEC function connected to this unit using an HDMI cable, some sound operations such as volume up can be used with this Caution unit’s remote control. • Before you connect your PC, set the PC monitor refresh rat
ページ19に含まれる内容の要旨
Locking a channel Sleeptimer This section describes how to lock specifi ed channels. The channels can Sleeptimer switches the TV to standby after a pre-defi ned period of time. be selected but the screen is blanked out and the audio is muted. You can always switch off your TV earlier or reset the sleeptimer during 1 Press MENU on the remote control and select [Features] > the countdown. [Child Lock] > [Channel Lock]. 2 Enter your PIN (see ‘Setting your PIN’ on page 18). Press SLEEP to set the
ページ20に含まれる内容の要旨
Summar y of TV ratings Summary of US movie ratings Rating Description Age rating Content rating TV -Y : Appropriate for children of all ages None NR Not rated. with themes and elements suitable for G Movies with a mild content, suitable for all ages. children aged 2-6. PG Mo vies for which parental guidance is recommended. TV -Y7 : Programs designed for children age 7 [FV ] (Fantasy Violence) They may contain a few racy or violent scenes or and older. maybe some bad language.
