ページ1に含まれる内容の要旨
Register your product and get support at
www.philips.com/welcome
55PFL7 705DV
46PFL7 705DV
40PFL7 705DV
EN: For further assistance, call the customer support service in your country.
• To obtain assistance in the U.S.A., Canada, Puerto Rico, or the U.S. Virgin Islands, contact Philips
EN User Manual Customer Care Center at 1-866-309-0841
• To obtain assistance in Mexico, contact Philips Customer Care Center at 01 800 504 62 00
Enter below the model and serial numbers located on the back and rig
ページ2に含まれる内容の要旨
Contents 7 Install channels 35 1 Notice 4 Selecting your menu language 35 Autoprogram 35 2 Important 5 Weak channel installation 35 Product information 5 Installation mode 35 Screen care 5 Uninstall channels 35 Environmental care 5 Return your settings to default values 35 Regulatory notices 5 8 Update your TV software 36 3 Your TV 6 Checking your current software version 36 Side controls and indicators 6 Preparing for the software update by USB 36 Remote control 6 Updating software 36 4 Get sta
ページ3に含まれる内容の要旨
Return your Product Registration Card or register online at www.philips.com/welcome today to get the very most from your purchase. Registering your model with PHILIPS makes you eligible for all of the valuable benefits listed below, so don't miss out. Complete and return your Product Registration Card at once, or register online at www.philips.com/welcome to ensure: *Proof of Purchase *Product Safety *Additional Benefits Notification Returning the enclosed card guarantees By registering your
ページ4に含まれる内容の要旨
IMPORTANT SAFETY INSTRUCTIONS Read before operating equipment 1. Read these instructions. C. The appliance has been exposed to rain; or 2. Keep these instructions. D. The appliance does not appear to operate normally or exhibits a 3. Heed all warnings. marked change in performance; or 4. Follow all instructions. E. The appliance has been dropped, or the enclosure damaged. 5. Do not use this apparatus near water. 17. Tilt/Stability - All televisions must comply with recommended 6
ページ5に含まれる内容の要旨
FCC Caution: Any changes or modifi cations not expressly 1 Notice approved by the party responsible for compliance could void the user’s authority to operate this equipment. This transmitter must not be co-located or operating in conjunction 2010 © Koninklijke Philips Electronics N.V. All rights reserved. with any other antenna or transmitter. Specifi cations are subject to change without notice. Trademarks are Country Code Statement the property of Koninklijke Philips Electronics N.V. or th
ページ6に含まれる内容の要旨
Environmental care VESA, FDMI and the VESA Mounting Compliant logo are trademarks of the Video Electronics Standards Association. ® Kensington and Micro Saver are registered US trademarks of ACCO World corporation with issued registrations and pending applications in other countries throughout the world. The packaging of this product is intended to be recycled. Contact your local authorities for information about how to recycle the packaging. End of life directives Portions of this sof
ページ7に含まれる内容の要旨
Remote control 3 Y our TV Congratulations on your purchase, and welcome to Philips! To fully benefi t from the support that Philips offers, register your product at a www.philips.com/welcome s b r c Side contr ols and indicators d q e e p f d g h c a o i b j a Standby indicator / Remote control sensor n . b POWER Switches the TV on or puts it in standby mode. The TV is not powered off completely unless it is physically unplugged. m c CHANNEL + / − Switches to the next or previous channel. l
ページ8に含まれる内容の要旨
.( ) r AUTO MODE a standby-On Cycles through preset picture and sound settings. Switches the TV on or puts it in standby mode. The TV is not (See ‘Using auto mode’ on page 24.) powered off completely unless it is physically unplugged. b FAV s OPTIONS Displays a list of all channels marked as favorite. Displa ys a list of menu items applicable to the highlighted object or (Includes subchannels) screen. c SLEEP Sets a delay after which the TV switches to standby. ( ) d Color buttons red / g
ページ9に含まれる内容の要旨
Positioning the TV 4 Get started Warning Supplied accessories • Do not insert the AC power cord into the power socket outlet before all the connections are made. • Large screen TVs are heavy. 2 people are required to carry and handle a large screen TV. • Remote Control • Before you move the TV, disconnect attached cables to prevent damage to connectors. • 2 x AAA, 1.5V Batteries In addition to reading and understanding safety instructions, consider • M4 x 10 double sems screw x 4 (
ページ10に含まれる内容の要旨
If you connect a set-top box through RF IN / OUT 1 Slide the battery cover off the back of the remote control. If the TV is connected to a cable box or satellite set-top box via a 2 Insert the 2 supplied batteries (AAA, 1.5V). Be sure the + and − coaxial connection, set the TV to channel 3 or 4, or to the channel ends of the batteries line up with the markings inside the case. specifi ed by the service provider. 3 Slide the cover back into position. Note • Remove the batteries if not using t
ページ11に含まれる内容の要旨
Managing cables Connecting the AC power cord Route your antenna cable and all other cables through the cable W arning management tie at the back of the TV. The holder helps keep your cables tidy and easily manageable. • Verify that your power voltage corresponds with the voltage printed at the back of the TV. Do not insert the AC power cord if the voltage is different. 1 Attach the cable management tie as illustrated below. 1 Locate the power connector at the back of the TV. The location o
ページ12に含まれる内容の要旨
Select [ Picture A] or [ Picture B] by pressing Í / Æ that is the most Switching on and initial setup pleasing to you, then press OK. You see 5 different pictures to be completed. Before you switch on the TV, check that the AC power cord is properly . connected. Press POWER at the right side of the TV, or press Which side of the picture do you prefer? .( ) standby-On on the remote control. The TV normally takes 25-30 Cancel P Picture A icture A Picture B seconds to start up and the foll
ページ13に含まれる内容の要旨
Switching channels 5 Use your TV This section helps you perform basic TV operations. S witching on your TV and putting it in standby mode Press CHANNEL + / − on the side of the TV. • Press CH + / − or enter a number on the remote control. For digital channels, press a number (1 to 999) followed by a dot “•” and then the corresponding sub channel number (1 to 999). e.g. 108.30. To switch on • Press PREV. CH to return to the previously viewed channel. • Press . POWER at the side of the T
ページ14に含まれる内容の要旨
Adjusting v olume Watching channels from a set-top box To watch channels from a set-top box 1 Switch on the set-top box. » The picture from your set-top box might appear automatically on the TV screen. 2 Use the remote control of your set-top box to select channels. If the picture does not appear 1 Press SOURCE repeatedly to select the set-top box and wait a few seconds for the picture to appear. 2 Use the remote control of your set-top box to select channels. W atching connected devices
ページ15に含まれる内容の要旨
• If device lock is unlocked, [ Device lock] will be displayed. 6 Use more of your TV If device lock is locked, [ Device unlock] will be displayed. • When device lock is locked, will be displayed at the top right of the device icons. 5 Enter your PIN. (See ‘Setting your PIN’ on page 26.) • Once you have set PIN, PIN input menu does not appear after Access TV menus the unit is turned on. Menus help you to install channels, change picture and sound settings Enable or disable RC k ey forward
ページ16に含まれる内容の要旨
Philips Wireless MediaConnect Help To read the Philips Wireless MediaConnect Help, right click the program icon in the notifi cation tray of the PC and select Help. Specifi cs You can project high defi nition (HD) or standard defi nition (SD) video, depending on the processing power of your PC. The content protection on most DVD or Blu-ray Disc movies might restrict watching the movie on TV when the disc is playing on a PC. The TV shows PC media fi les with a small delay. Philips Wireless MediaCon
ページ17に含まれる内容の要旨
Enjoying internet radio with vTuner 3 In the station / folder list, use Î / ï to select the desired station, then press OK. With this unit, you can enjoy internet radio with vTuner via the internet. • After loading, playback of the selected station will start. In order to listen to internet radio, you must connect this unit to the • If you select a folder, use Î / ï to select the desired station in internet. the next hierarchy, then press OK. • To stop playback, press C. For the network conn
ページ18に含まれる内容の要旨
Guide to the playback screen Remove from favorite list e.g.) Location 1 Follow steps 1 to 2 in ‘Internet radio playback’ on page 16. 11 1 2 Use Î / ï to select [Favorites], then press OK. 3 Use Î / ï to select the station you want to remove from vTuner |...| Sunhall [Favorites], then press Color buttons (green). All Stations 45 • Confi rmation message will appear. .. Tset1 4 Use Í / Æ to select [Yes], then press OK. 2 Tset2 10 • The selected station is removed from [Favorites] folder. Japan Weat
ページ19に含まれる内容の要旨
Guide to VUDU menu screen VUDU operations App Home Screen With this unit, you can enjoy VUDU HD on-demand movies / TV shows App Home Screen is the entry point to VUDU applications including and internet applications. VUDU movies. To call up the screen, press NET TV on the remote - For complete instructions on using VUDU service, please visit control and then use Î / ï / Í / Æ to select [vudu]. www.vudu.com/docs to view an updated in-depth online manual. 2 MY FAVORITES Before activating VUDU
ページ20に含まれる内容の要旨
Renting or pur chasing VUDU movies / TV episodes Using internet applications After activating this unit, you are ready to purchase or rent movies / TV In addition to VUDU movies, you can use various kinds of internet shows and watch directly on your TV. applications. 1 Press NET TV on the remote control and then use Î / ï / Í / Æ to 1 In App Home Screen, use Î / ï / Í / Æ to select a desired select [vudu]. application and press OK. 2 Use Î / ï / Í / Æ to select [VUDU movies], then press OK.
