ページ1に含まれる内容の要旨
Instruction Manual
L LC CD D-3 -32 2L L16H 16H
32" LCD TV/MONITOR
ページ2に含まれる内容の要旨
WARNING AND PRECAUTION Read all of the instructions before operating the set. Keep these instructions well for later use. PRODUCT The ventilation should not be impede by covering the ventilation openings with items, such as newspaper, table-cloths, curtains, etc. Do not push any objects of any kind into this unit through the cabinet slots as they could touch the current carrying parts or short-circuit parts, resulting in fire, electric shock, or damage to the unit. Unplug the set when it is
ページ3に含まれる内容の要旨
WARNING AND PRECAUTION USE ENVIRONMENT Do not install this equipment in a confined space such as a book case or similar unit. To prevent injury, this apparatus must be securely attached to the wall mount fastened on the wall. Place the set on a place that allows good ventilation. Do not use the set near damp, and cold areas, protect the set from overheating. Keep away from direct sunlight. The apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids, su
ページ4に含まれる内容の要旨
SETUP SETUP Insert The Batteries 1 Remove the battery cover by pressing it and sliding it down. 2 Insert the two 1.5V (AAA size) batteries making sure the polarity (+ or -)of the batteries matches the polarity marks Inside the unit. 3 Replace the battery cover by sliding it in until you hear a click sound. Precautions when using batteries Do not use old and new batteries together. Do not use different types of batteries (for example, Manganese and Alkaline batteries) together. Note that t
ページ5に含まれる内容の要旨
SETUP SETUP Locate the receiver in the room where direct light does not strike the screen. Total darkness or a reflection on the picture screen can cause eyestrain. Soft and indirect lighting is recommended for comfortable viewing. Allow enough space between the receiver and the wall to permit ventilation. Avoid excessively warm locations to prevent possible damage to the cabinet or premature component failure. This TV operates on AC supply directly, connect the AC plug to the socket at the ba
ページ6に含まれる内容の要旨
FUNCTIONAL PARTS FRONT PANEL Note: The graphics are for representation only. PROG.+ 3 PROG.- VOL.+ 4 VOL.- MENU 5 TV/AV 6 7 1 2 7 1.Power button 2. Power Indicator/Remote Sensor 3.Program Up/Down button 4.Volume Up/Down button 5. Menu button 6. TV/AV button 7. Speakers -3-
ページ7に含まれる内容の要旨
FUNCTIONAL PARTS BACK PANEL L - AUDIO - R VIDEO R - AUDIO - L VIDEO HDMI2 HDMI1 VGA VGA AUDIO IN S/PDIF 75 ANT Y Pb Pr R - AUDIO - L VIDEO 1 1 2 3 4 5 6 7 8 9 1. HDMI1\HDMI2: Connect HDMI input signal from signal source such as DVD. 2. VGA: Connect a PC via a VGA cable. 3. VGA AUDIO IN: Connect audio signal from PC. 4. Y Pb Pr(HDTV): Connect RCA cable to connect DVD player or other video device's YPbPr output. 5. AV2: Connect AUDIO and VIDEO input signal from signal source such
ページ8に含まれる内容の要旨
OPERATION INSTRUCTIONS Remote Control Unit POWER (STAND BY) BUTTON ( ) 1 Press this button to turn the TV on/off. POWER MUTE 2 MUTE BUTTON ( ) Press once to mute the sound, press again to return to preset sound level. 3 PROGRAM SELECTION BUTTONS (0-9) You could select program you want with 0-9 button. For program up to 100-199, you need press three digit number quickly, then TV will go AV/TV RECALL to the program directly. For program between 10-99, you need press two digit numb
ページ9に含まれる内容の要旨
OPERATION INSTRUCTIONS Remote Control Unit 10 Left Right arrow/Zoom-/+ (Z- / Z+) Press to change the screen format: 4:3 format, 16:9 format, 14:9 ZOOM, 16:9 ZOOM1, 16:9 ZOOM2. POWER MUTE 11 OK BUTTON (OK) Press to enter selected item. 12 CURSOR button( / ) Left/Right/Up/Down direction keys for selecting menu itemsor signal sources. 13 MENU BUTTON (MENU) AV/TV RECALL Press this button to enter the menu screens for various Optional adjustable settings. SLEEP 14 EXIT BUTTON INFO VOL
ページ10に含まれる内容の要旨
OPERATION INSTRUCTIONS 21 PIP SOUND Press this button to select current sound output from main or PIP source when PIP is active . POWER 22 PIP SIZE MUTE Press this button to change PIP picture size , Normal or Zoom when PIP is active . 23 TEXT BUTTON This button is used for entering the teletext MENU. MIX BUTTON(OPTION) 24 the button is used as closing /opening the AV/TV RECALL teletext Background. 25 SLEEP HOLD BUTTON INFO Press this button to hold the Teletext page VOL PROG without update
ページ11に含まれる内容の要旨
SIZE SIZE REVEAL REVEAL Text You could stop it by press "HOLD" button . SUB.PAGE Up arrow key Down arrow key SUB.PAGE INDEX MIX MIX 1000 So TV will display text page you required MIX quickly . SIZE -8-
ページ12に含まれる内容の要旨
Up arrow key Down arrow key To Cancel TEXT Press "CANCEL" button to clear the TEXT. But the page number is still displayed on the left top of the screen. NOTICE: However, Teletextis playing all the same on the background at the time. Press " CANCEL" button again to resume the TEXT. To Freeze TEXT Press "HOLD" button to hold a Text Page. This means the page will not change and refresh. Press the button again to release the hold state. To exit Teletext Press the " TEXT " or " EXIT" button
ページ13に含まれる内容の要旨
ANALOG MENU SCREENS 1. Plug in the power cord and switch on power switch . The power indicator will light up. If TV is in stand by mode. Then Press"¡¡ " Key. The picture will display in few minutes. MENU BUTTON 1.Press menu button to display menu, and press left/right arrow key to select sub menu. PICTURE SOUND INSTALLATION TIMER PREFERENCE PARENTAL CONTROL 2.After entering an item, you can select the desired adjusting item by the up/down arrow key and adjust It by the left/right
ページ14に含まれる内容の要旨
ANALOG MENU SCREENS Sound menu Enter Sound menu, you can select Sound Mode, Balance, Treble, Bass, Auto Volume Level. Items by pressing up/down arrow key. Sound Mode Press the left/right arrow key to select the audio mode. The audio mode are Standard, Music, Film, Voice, Personal. Balance Press the left/right arrow key to adjust to the left to right sound channel volume. Treble Press the left/right arrow key to adjust the high frequency signal value. Bass Press the left/right arrow key to
ページ15に含まれる内容の要旨
ANALOG MENU SCREENS Channel Name Installation menu Display channel name, you could edit it if press "OK" to enter edit sub menu. use up/down arrow key to change name of program in the edit sub menu. Colour Sys Press the button to select a new colour standard value in TV. The choices are AUTO, PAL,NTSC and SECAM. Sound Sys Press the button to select a new sound standard value in TV. The choices are B/G, D/K, I, M. It's better to select it before auto installation. Country Select cou
ページ16に含まれる内容の要旨
ANALOG MENU SCREENS Time menu Enter Timer menu, you could set time and turn on/off timer. With Time reference, you could set channel from which TV get teletext time. Current Time show the time of your TV remember, you could set this time manualy if you want. Otherwise, TV get it from channel for time reference . Turn off/Wake up time used for setting of TV turn off and/or wake up time according current time. you could select which channel you want when the TV wake up according wake up
ページ17に含まれる内容の要旨
ANALOG MENU SCREENS Parental Control menu Enter Parental Control menu you can set control of it .Press left/right arrow key to select Parental Control item, then press up/down arrow key to entry menu. Input correct password to entry sub menu when PIN item is high light . The initial password is "0000". Lock Installation Press left/right arrow key to lock installation menu or unlock it. This item is only available in TV mode . Channel Number Press left/right arrow key to select channel w
ページ18に含まれる内容の要旨
ANALOG MENU SCREENS PC MODE 15 Pin Mini D-Sub Connector and LCD TV. PC Input typical display modes. The following 1 640X480(recommend 60Hz) table is an illustration of some of the typical 2 800X600(recommend 60Hz) 3 1024X768(recommend 60Hz) video display modes. 4 480p 5 576p 6 720p(50/60Hz) 7 1080i(50/60Hz) MENU in PC Mode Geometry menu Enter menu by pressing the "MENU" button on the remote control. In PC mode state, there are 4 geneal menus (Picture, Sound, Time
ページ19に含まれる内容の要旨
ANALOG MENU SCREENS Enter preferences menu you can setup the Preferences menu Language, Zoom, Film mode, OSD Transparent. Select preferences menu by press the up/down arrow key and enter the caption function by pressing left/right arrow key, you can adjust the Style function items by pressing left/right arrow key buttons. Language Press the left/right arrow key and MENU buttons to select the osd Language. Zoom The picture display will change as 4:3 format , 16:9 format , when you change
ページ20に含まれる内容の要旨
ANALOG MENU SCREENS HDMI Input Resolutions HDMI Input typical display Modes. The following table is an illustration of some of typical Video display modes. 1 640X480(recommend 60Hz) 2 800X600(recommend 60Hz) 3 1024X768(recommend 60Hz) 4 480p 5 576p 6 720p(50/60Hz) 7 1080i(50/60Hz) 8 1080p(24/50/60Hz) Y Pb Pr Mode(Component input) The menu of Y Pb Pr mode is exactly same as the menu of HDMI mode. YPbPr Input typical display modes. The following table is an illust
