ページ1に含まれる内容の要旨
GS a GrILL
Built-In LP Gas Grill Installation Guide
Assembly - Pg. 7 • Tank Enclosure Installation - Pg. 26
ESNA
Guía de instalación de barbacoas de gas propano licuado empotradas - pg. 33
Guide pour l’installation du grill à gaz pl intégré - pg. 47
460 - LP
660 - LP
#56583
You must read this owner’s Guide
m warninG: follow all leak-check
before operatinG Your Gas Grill.
procedures carefully in this manual prior
to barbecue operation. do this even if the
barbecue was dealer-assembled.
m
ページ2に含まれる内容の要旨
WarNINGS m danGer failure to follow the dangers, warnings and Cautions contained in this owner’s manual may result in serious bodily injury or death, or in a fire or an explosion causing damage to property. m warninGs m do not attempt to disconnect any gas fitting while your barbecue is in operation. m do not store a spare or disconnected liquid propane m use heat-resistant barbecue mitts or gloves when operating cylinder under or near this barbecue. barbecue. m improper assembly may be dang
ページ3に含まれる内容の要旨
bUILT-IN UT c UT DI o ENSI m NS o “island” struCture ConfiGuration options “ISLaND” STU r c TUrE NFIGU co ra TIN o oPTIoNS There are many available options for locating the major components of your Island structure. Your major components are: 2 A) The Built in Grill A B) Gas supply enclosure C) Optional Side burner accessory The 3 common options (A, B, C) are illustrated in the “ ‘Island’ Structure Configuration Options” table. 3 Note: Gas Line Limitation 1 The gas supply hose from grill ma
ページ4に含まれる内容の要旨
bUILT-IN cUT oUT DIENSI m NS o loC atinG Y our Grill LE c araNcES ® When determining a suitable location for your Summit gas grill installation, give attention to concerns such as exposure to wind, proximity to traffic paths, and keeping ® any gas supply lines as short as possible. Never locate the Summit gas grill in a garage, breezeway, shed, under an unprotected overhang, or other enclosed area. 1 Locate the grill and structure so there is enough room to safely evacuate the area in case
ページ5に含まれる内容の要旨
bUILT-IN UT c UT DI o ENSI m NS o General ConstruCtion details ® Summit Built-In unit and all other accessory units should be on site before construction begins. For ease of installation, the grill will be pushed on its casters into the built-in structure. The installation of this grill requires a level floor pad surface (1) and countertop surface. The floor pad surface must be constructed from solid materials and must be level and smooth. Proper subgrade materials must be used under the floo
ページ6に含まれる内容の要旨
ParTS LIST • LISTa DE PIEZS a • LISTE DES PIEcES stainless steel Cooking Grates r ear Vent - 1 Parrillas de cocción de acero inoxidable Respiradero posterior - 1 Grilles de cuisson en acier inoxydable Aération arrière - 1 460 660 - 2 - 3 f ront wheel alignment p anel - 1 ® flavorizer bars Panel de alineación de las ruedas delanteras - 1 ® Barras Flavorizer Panneau d’alignement de la roue avant - 1 ® Barres Flavorizer 460 660 - 8 - 12 r ear wheel alignment p anel - 1 Panel de alineación de las
ページ7に含まれる内容の要旨
aSSEmbLY • ENSambLa JE • aSSEmbLa GE tools needed: herramientas reQ ueridas: outils neCessaires : the grill illustrated may have slight differences than the model purchased. l a barbacoa ilustrada puede tener ligeras diferencias con respecto al modelo comprado. il est possible que le grill de l’illustration présente de légères différences par rapport au modèle acheté. remove protective film from stainless surface before using m important: to properlY aliGn frame and grill. doors, assemble
ページ8に含まれる内容の要旨
aSSEL mb Y • ENSambLa JE • S a SEmbLa GE 460 660 1 2 8
ページ9に含まれる内容の要旨
S a SEL mb Y • ENSambLa JE • aSSEL mb a GE Requires 3 “D” alkaline batteries (included). Use alkaline batteries only. Do not mix old and new batteries or different types of batteries (standard, alkaline or rechargeable). 3 Requiere 3 baterías alcalinas “D” (incluidas). Use solamente baterías alcalinas. No mezcle baterías nuevas con viejas o diferentes tipos de baterías entre sí (normales, alcalinas o recargables). Nécessite 3 piles alcalines “D” (fournies). Utilisez des piles alcalines uni
ページ10に含まれる内容の要旨
aSSEmbLY • ENSL amb a JE • aSSEmbLa GE 5 6 10
ページ11に含まれる内容の要旨
S a SEL mb Y • ENSambLa JE • aSSEmbLa GE 7 8 ® WWW.WEE b r.com 11
ページ12に含まれる内容の要旨
aSSEmbLY • ENSL amb a JE • aSSEmbLa GE 9 10 12
ページ13に含まれる内容の要旨
S a SEL mb Y • ENSambLa JE • aSSEL mb a GE 11 Now that the side vents are installed, the grill should be placed directly in front of the cut-out opening (a) of the built-in structure. The grill will be pushed straight into the structure once the 12 wheel alignment panels are installed in the following steps. align grill with enclosure, but do not roll grill into enclosure at this time. Ahora que los respiraderos laterales están instalados, la barbacoa deberá colocarse directamente en fren
ページ14に含まれる内容の要旨
aSSEmbLY • ENSambLa JE • aSSEmbLa GE Remove two screws and two washers from back panel and set aside. do not discard hardware. 13 Retire dos tornillos y dos arandelas del panel posterior y póngalos a un lado. no deseche los herrajes. Retirez les deux vis et les deux rondelles du panneau arrière et mettez-les de côté. ne jetez pas la quincaillerie. Rotate rear casters so that the points of the casters (a) are facing outward toward the grill enclosure. 14 Gire las ruedas traseras de manera qu
ページ15に含まれる内容の要旨
S a SEmbLY • ENSambLa JE • aSSEmbLa GE 15 16 ® WWW.WEE b r.com 15
ページ16に含まれる内容の要旨
aSSEmbLY • ENSambLa JE • aSSEL mb a GE Rotate front casters so that caster points (a) are facing the front of the grill. 17 Gire las ruedas delanteras de manera que las puntas de las ruedas (a) den cara al frente de la barbacoa. Faites pivoter les roulettes avant de sorte que les points des roulettes (a) se trouvent face à l’avant du grill. a 18 16
ページ17に含まれる内容の要旨
aSSEmbLY • ENSambLa JE • aSSEmbLa GE 19 20 Temporarily install the front wheel alignment panel using just one screw on each side. Instale temporalmente el panel delantero de alineación de las ruedas utilizando sólo un tornillo en cada lado. Installez temporairement le panneau d’alignement des roues avant en utilisant juste une vis de chaque côté. ® WWW.WEE b r.com 17
ページ18に含まれる内容の要旨
aSSEmbLY • ENSL amb a JE • aSSEmbLa GE Roll grill straight back into enclosure. Important Note: Surface must be level. 21 Ruede la parrilla directamente atrás hacia el compartimiento. Nota importante: La superficie debe estar nivelada. Faites rouler le grill directement à l’intérieur du meuble. Remarque importante : La surface doit être plane. After the grill is properly located in the enclosure, remove the Front Wheel Alignment Panel. Reach underneath grill and lock the two front caste
ページ19に含まれる内容の要旨
S a SEL mb Y • ENSambLa JE • aSSEmbLa GE 23 Reinstall the Front Wheel Alignment Panel securing both sides with all four screws. Reinstale el Panel Delantero de Alineación de las Ruedas atornillándola a ambos lados con todos los cuatro tornillos. Remettez en place le Panneau d’alignement des roues avant en fixant les deux côtés à l’aide de la totalité des quatre vis. 24 The included filler strips may be used to fill any gaps at the countertop or front of the grill. Install as needed. Las tira
ページ20に含まれる内容の要旨
aSSEmbLY • ENSL amb a JE • aSSEmbLa GE 25 26 20
