Network Computing Devices NCD-6029-3の取扱説明書

ページ1に含まれる内容の要旨

2172
DO NOT INSTALL THIS KIT ON VEHICLES WITH
COMPOSITE LEAF SPRINGS. THIS KIT IS COMPATIBLE
WITH STEEL LEAF SPRINGS ONLY.
WARNING:
Do not inflate this assembly when it is
unrestricted. The assembly must be restricted
by the suspension or other adequate structure.
Do not inflate beyond 100 psi Improper use or
over inflation may cause property damage or
severe personal injury.
Installation of this kit requires a
minimum of 6-1/2" of clearance between
the tire side wall and the frame.
Your kit

ページ2に含まれる内容の要旨

ページ3に含まれる内容の要旨

FRONT STEP 1 - PREPARE THE VEHICLE Remove the positive battery cable. With the vehicle on a solid, level surface chock the front wheels. Raise the vehicle by the axle and remove the rear wheels. After the removal of the wheels lower the vehicle so the axle rests on jack stands rated for your vehicles weight. This installation assumes that there is no load in the bed of the truck. STEP 2 - PRE-ASSEMBLE THE KIT Select one air helper spring and an upper bracket from your kit. Before attaching th

ページ4に含まれる内容の要旨

STEP 5 - INSTALLATION OF THE PASSENGER'S SIDE ASSEMBLY Reverse any orientations when assembling and installing the right, or passenger side of the vehicle. STEP 6 - INSTALL THE AIR LINE AND THE INFLATION VALVE Uncoil the air line tubing and cut it into two equal lengths. DO NOT FOLD OR KINK THE TUBING. Try to make the cut as square as possible. Insert one end of the tubing into the elbow fitting installed in the top of the air helper spring. Push the tubing into the fitting as far as possi