ページ1に含まれる内容の要旨
OPERATOR'S MANUAL
1400677 Battery Charger
SPECIFICATIONS:
Charger 1400677
Input 120 Volts, 60 Hz, AC Only – 60 Watts
Charging Voltage 9.6 -18 Volt
Charging Current 1.8 Amperes
Net Weight 2.9 Lbs.
THANK YOU FOR BUYING A RYOBI BATTERY CHARGER.
Your new battery charger has been engineered and manufactured to Ryobi’s high standard for dependability, ease of
operation, and operator safety. Properly cared for, it will give you years of rugged, trouble-free performance.
CAUTION: Carefully read
ページ2に含まれる内容の要旨
RULES FOR SAFE OPERATION The purpose of safety symbols is to attract your attention to possible dangers. The safety symbols, and the explanations with them, deserve your careful attention and understanding. The safety warnings do not by themselves eliminate any danger. The instructions or warnings they give are not substitutes for proper accident prevention measures. SYMBOL MEANING SAFETY ALERT SYMBOL: Indicates danger, warning, or caution. May be used in conjunction with other symbols or pi
ページ3に含まれる内容の要旨
RULES FOR SAFE OPERATION (Continued) n Do not insert foreign matter into the hole for the battery n DO NOT OPERATE CHARGER WITH A DAMAGED in charger. CORD OR PLUG. If damaged, have replaced immediately by a qualified serviceman. n Do not charge by means of an engine generator or DC n Do not operate charger if it has received a sharp blow, power source. been dropped, or otherwise damaged in any way; take n Do not disassemble the battery. it to a qualified serviceman. n Do not store the tool and b
ページ4に含まれる内容の要旨
OPERATION USE1400677 BATTERY CHARGER ONLY WITH 1400677 BATTERY CHARGER BATTERY PACK NOS. 1400651, 1400652, GREEN LIGHT "ON" 1400655, 1400671 AND 1400672 CHARGER INDICATES FULLY CHARGED CHARGING BATTERY PACK OR IN SLOW CHARGING MODE See Figures 1 & 2. Battery pack's are shipped in a low charge condition to prevent possible problems. Therefore, you should charge it prior to use. NOTE: Batteries will not reach full charge the first time they are charged. Allow several cycles (operating tool followe
ページ5に含まれる内容の要旨
OPERATION IMPORTANT INFORMATION FOR RECHARGING HOT BATTERIES When using your tool continuously, the batteries in your battery pack will become hot. You should let a hot battery pack cool down for approximately 30 minutes before attempting to recharge. When the battery pack becomes discharged and is hot, this will cause the red light on your battery charger to flash. When battery pack cools down, red light will glow continuously indicating fast charging mode, 1 hour charge time. Once the battery
ページ6に含まれる内容の要旨
OPERATOR'S MANUAL 1400677 Battery Charger • SERVICE Now that you have purchased your charger, should a need ever exist for repair parts or service, simply contact your nearest Ryobi Authorized Service Center. Be sure to provide all pertinent facts when you call or visit. • PART NO. The part number of this charer will be found on a plate attached to the bottom of the housing. BATTERY CHARGER • NAME OF ITEM 1400677 • PART NUMBER • SERIAL NUMBER RYOBI AMERICA CORP. RYOBI CANADA INC. 1424 Pearman Da
