ページ1に含まれる内容の要旨
Use & Care Guide
Wine Cooler / Beverage Center
Guia de Uso y Cuidado
Refrigerador de Vinos / Centro de Bebidas
Guide D’utilisation et D’entretien
Refroidisseur à Vin / Centre de Boissons
241888404 Jan 2009
ページ2に含まれる内容の要旨
Finding Information 2 Product Registration Card Please Read and Save This The package containing this manual also includes Guide your product registration information. Warranty Thank you for choosing Electrolux, the new coverage begins at the time your Electrolux wine premium brand in home appliances. This Use & cooler / beverage center was purchased. Care Guide is part of our commitment to customer satisfaction and product quality throughout the NOTE service life of your new wine
ページ3に含まれる内容の要旨
Finding Information 3 Table of Contents Finding Information ................................................................................. 2 Please Read and Save This Guide ......................................................................................2 Make a Record for Quick Reference ...................................................................................2 Product Registration Card ...........................................................................................
ページ4に含まれる内容の要旨
Safety 4 Important Safety Instructions WARNING Safety Precautions • Ne ver attempt to repair or perf orm Do not attempt to install or operate your unit maintenance on the unit until the electricity until you have read the safety precautions in this has been disconnected. manual. Safety items throughout this manual are • Altering, cutting of po wer cor d, remo v al of labeled with a Danger, Warning or Caution based power cord, removal of power plug, or direct on the risk type.
ページ5に含まれる内容の要旨
Installation 5 Installing the Wine Cooler / Beverage Center Your Electrolux wine cooler / beverage center has been designed for either free-standing or built-in installation. When built-in, your wine cooler does not require additional air space for top, sides or rear. In either case, the front grille must NOT be obstructed. NOTE To ease unit installation and removal, it is recommended that the cabinet rough opening dimensions be increased by at least ¼ inch over the dimensions given
ページ6に含まれる内容の要旨
Installation 6 6 Wipe out inside of unit with a damp cloth. Site Preparation 7 Be sure to install the Anti-Tip bracket. Follow 1 Position the unit on a flat, level surface the instructions provided with the Anti-Tip capable of supporting the entire weight of the bracket kit. unit. Remember the unit will be significantly heavier once it is fully loaded. WARNING 2 This unit requires a grounded and polarized 115 VAC, 60Hz, 15A circuit (normal The Anti-Tip Kit m ust be installed o
ページ7に含まれる内容の要旨
Leveling 7 Leveling the Unit Position the unit on a flat, level surface capable of supporting the entire weight of the unit when full. This unit contains four (4) adjustable leveling legs. Turn the legs clockwise to raise and counterclockwise to lower.
ページ8に含まれる内容の要旨
Door Reversal 8 4 Remove upper RH hinge bracket by Reversing the Door loosening four (4) screws. Be careful to This model comes equipped with a right-hand (RH) support the door while loosening and swing door. To convert the unit to a left-hand (LH) removing the upper hinge bracket. swing door (as shown in the Use & Care Guide), certain components must be obtained before beginning the conversion. These components are available from your local dealer or by calling Electrolux. Order P
ページ9に含まれる内容の要旨
Door Reversal 9 6 Remove access cover by removing two (2) 9 Install metal LH door stop by installing screw. screws. Do not overtighten. 7 Shift door harness from one side to the other. 10 Install plastic LH door stop by installing Replace access cover. screw. 11 Remove lower RH door hinge by removing two (2) screws. Remove P-clamp and install in LH side. 12 Install lower LH door closer in lower LH door hinge by installing screw. 13 Install lower LH door hinge by installing two (2
ページ10に含まれる内容の要旨
Door Reversal 10 14 Remove button plug from upper left side of door and place in upper right side of door. Place door on lower LH hinge bracket. Remove Button Plug From Left Side And Install On Right Side 16 Route door harness behind lower front panel. Reconnect door harness to bracket. 17 Attach LH toe grille. 15 Install upper LH hinge bracket by installing four (4) screws. If door does not close properly after reversing, the following actions may be taken: a) Loosen lower hinge
ページ11に含まれる内容の要旨
Star t-Up and T emperature Contr ol 11 Starting the Unit Your wine cooler / beverage center is shipped in the ON position; however, you may turn it ON or OFF by pressing the ON/OFF for three (3) seconds. Adjusting the Temperature To accurately check the temperature, insert a reliable thermometer into a plastic (non-breakable) bottle, partially filled with water. Tighten the bottle cap securely. Place the bottle in the desired area for 24 hours. Refrain from opening the unit during the testi
ページ12に含まれる内容の要旨
Operation 12 high temp In the event of a high temperature condi- Description of Features (Beverage tion, an audible alarm will sound, the tem- vacation mode Conserves energy by disabling interior perature display will blink and display “HI” Center Only) lights and keypad inputs. and the high temp indicator on the right side of the display will blink. The mute mute sounds Tones emitted by each keypress can be turned sounds indicator will blink. Pressing the off based on user preference.
ページ13に含まれる内容の要旨
Storage 13 Proper Storage The wine cooler will accommodate 46 bottles (750 ml size). There are five (5) upper racks that will hold eight (8) bottles each and one lower display rack that will hold six (6) bottles. Specially designed wine racks allow for proper horizontal storage of the wine. The cork remains moist which keeps air from entering the bottle. The beverage center will accommodate six (6) bottles on the lower rack. Additional storage capacity is provided on the glass shelves
ページ14に含まれる内容の要旨
Maintenance 14 Interior Cleaning - as Required Maintaining Your Wine Cooler/ 1 Disconnect power to the wine cooler / Beverage Center beverage center. Periodic cleaning and proper maintenance will 2 Remove racks if desired, see “WINE RACK ensure efficiency, top performance, and long REMO V AL/INST ALLA TION” below. life. The maintenance intervals listed are based 3 Wipe down the interior with a solution of non- on normal conditions. You may want to shorten abrasive mild detergent and w
ページ15に含まれる内容の要旨
Maintenance 15 Glass Shelf Removal/Installation Air Filter (Beverage Center Only) Install the static air filter, located in the literature pack, in the proper housing. 1 Open door fully. 2 Method 1 - removal of entire shelf assembly: a. Lift up on front edge and rear portion of shelf. Cantilever brackets will disengage from ladder. b. To reinstall, slide shelf into cabinet ensuring the cantilever brackets engage fully in the proper holes. It may help to extend the glass portion. 3
ページ16に含まれる内容の要旨
Troubleshooting 16 Before You Call for Service If Service is Required If the unit appears to be malfunctioning, read Contact the dealer where you purchased the unit through this manual first. If the problem persists, if service is required. State the model and serial check the Troubleshooting Guide below. Locate number and explain the problem. The model and the problem in the guide and refer to the cause serial number plate is located on the ceiling of your and its remedy before calling for
ページ17に含まれる内容の要旨
Warranty Information 17 Major Appliance Warranty Information Your appliance is covered by a one year limited warranty. For one year from your original date of purchase, Electrolux will repair or replace any parts of this appliance that prove to be defective in materials or workmanship when such appliance is installed, used, and maintained in accordance with the provided instructions. In addition, the cabinet liner and sealed refrigeration system (compressor, condenser, evaporator, dryer or t
