Teleflex Marine 311482-002の取扱説明書

ページ1に含まれる内容の要旨

TELEFLEX MORSE Marine Products
Marine Ignition
Interrupt Switch
Part Numbers
311482-001 (For I/0s and Inboards)
311482-002 (For Outboards)
For Use With Teleflex Morse MV3 Side Mounted Controls
INSTALLATION, OPERATION and
Installation Manual
MAINTENANCE INSTRUCTIONS
This manual must be accessible to the owner/user of this
Teleflex Morse Marine Product
PLEASE READ THESE INSTRUCTIONS CAREFULLY
AND THOROUGHLY BEFORE INSTALLING OR OPERATING
THIS IGNITION INTERRUPT SYSTEM! YOU MUST HAVE
THE MV3 SIDE M

ページ2に含まれる内容の要旨

ë\ General Information Installation This Interrupt Switch is to be used solely with 1. Before drilling, check behind the panel for sufficient clearance around wires, pipes, Morse MV3 Side Mounted Controls to stop the control cables and other obstructions. engine of an inboard, I/O or outboard powered boat instantly in the event an operator is acciden- 2. Remove control and drill a 5/8 inch diam tally removed from the controls. The Interrupt eter hole in the cover from the backside. A Switch incl

ページ3に含まれる内容の要旨

Table 1.             (    %    $    %        Wire Color Table                                       For Late Model Outboards       Daihatsu Solid Brown +    2   2 3 /  0   1   % Evinrude Black with Yellow Stripe         Before 1969. Solid Blue #      +   "   ,            #        # Force Solid White $    5 4         % +   "   +   "   Johnson Black

ページ4に含まれる内容の要旨

8. Attach the other end of the second wire to Operating Instructions the ground point, using a suitable 1. Before each motor start. check that the insulated wire connection device as Lanyard Fork Clip is properly seated over the shown in Diagram B. switch and rotates freely. Inspect the Lanyard. 9. Recheck all connections. Install the If it is cut. worn or frayed. it must be replaced. Lanyard with the Fork Clip seated over the Plunger. 10. Replace engine cover.
      2 11. Reconnect ba