ページ1に含まれる内容の要旨
3-859-117-12(1)
CD Radio
Cassette-Corder
Operating Instructions
CFD-V20
CFD-V30
1996 by Sony Corporation
CFD-V20/V30.E_3-859-117-1X.U2/CA2/AU6/E92
ページ2に含まれる内容の要旨
Information Warning For customers in the United States To prevent fire or shock hazard, do This equipment has been tested and found to not expose the player to rain or comply with the limits for a Class B digital moisture. device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordan
ページ3に含まれる内容の要旨
Basic Operations Table of contents Basic Operations 4 Playing a CD 6 Listening to the radio 8 Playing a tape 10 Recording on a tape The CD Player Additional Information 12 Using the display 18 Precautions 13 Locating a specific track 20 Troubleshooting 14 Playing tracks repeatedly 22 Maintenance (Repeat Play) 23 Specifications 15 Creating your own program Back cover (Program Play) Index Setting Up 16 Choosing the power sources 17 Adjusting the sound emphasis (TONE/MEGA BASS) Introduction 3 CFD-V
ページ4に含まれる内容の要旨
Basic Operations Playing a CD 1 2,3 4 Connect the supplied AC power cord (see page 16). 1 Set FUNCTION to CD. 2 Press 6OPEN/CLOSE down to OPEN/CLOSE open the CD compartment and place a CD on the CD compartment. With the label side up 3 Close the CD compartment. OPEN/CLOSE 4 Basic Operations CFD-V20/V30.E_3-859-117-1X.U2/CA2/AU6/E92
ページ5に含まれる内容の要旨
Basic Operations Display 4 Press ^ . The player plays all the tracks once. Track number Playing time Use these buttons for additional operations VOLUME ^ p 6OPEN/CLOSE =/+ FUNCTION To Do this Adjust the volume Turn VOLUME. Stop playback Press p. Pause playback Press ^. Press again to resume play after pause. Go to the next track Press +. Go back to the previous track Press =. Remove the CD Press 6OPEN/CLOSE. Turn off the player Set FUNCTION to TAPE (CD/RADIO OFF). Basic Operations 5 CFD-V20/V30
ページ6に含まれる内容の要旨
Listening to the radio 1 2 Connect the supplied AC power cord (see page 16). 1 Set FUNCTION to FM or AM. 2 Turn TUNE to tune in a radio station. If the received FM stereo is too weak, the reception becomes monaural. 6 Basic Operations CFD-V20/V30.E_3-859-117-1X.U2/CA2/AU6/E92
ページ7に含まれる内容の要旨
Basic Operations Use these buttons for additional operations VOLUME FUNCTION To Do this Adjust the volume Turn VOLUME. Turn off the radio Set FUNCTION to TAPE (CD/RADIO OFF). To improve broadcast reception Reorient the antenna for FM. Reorient the player itself for AM. For FM For AM Basic Operations 7 CFD-V20/V30.E_3-859-117-1X.U2/CA2/AU6/E92
ページ8に含まれる内容の要旨
Playing a tape 32 1 Connect the supplied AC power cord (see page 16). 1 Set FUNCTION to TAPE (CD/ RADIO OFF). 2 Press p6 to open the tape compartment and insert a recorded tape. Use TYPE I (normal) tape only. Close the compartment. With the side you want to play facing upward 3 Press (. 8 Basic Operations CFD-V20/V30.E_3-859-117-1X.U2/CA2/AU6/E92
ページ9に含まれる内容の要旨
Basic Operations Use these buttons for additional operations 0/)p6 P VOLUME To Do this Adjust the volume Turn VOLUME. Stop playback Press p6. Fast-forward or rewind the tape Press ) or 0 for the side facing upward. Pause playback Press P. Press the button again to resume play after pause. Eject the cassette Press p6. Basic Operations 9 CFD-V20/V30.E_3-859-117-1X.U2/CA2/AU6/E92
ページ10に含まれる内容の要旨
Recording on a tape 31 Connect the supplied AC power cord (see page 16). 1 Press p6 to open the tape compartment and insert a blank tape. Use TYPE I (normal) tape only. With the side you want to record on facing upward 2 Select the program source you Display want to record. To record from the CD player, set FUNCTION to CD and insert a CD (see page 4). To record from the radio, set FUNCTION to FM or AM and tune in the station you want (see page 6). 10 Basic Operations CFD-V20/V30.E_3-859-117-1X.
ページ11に含まれる内容の要旨
Basic Operations 3 Press r to start recording. (( is depressed automatically). Use these buttons for additional operations p6 P Tips To Press • Adjusting the volume or the tone will not affect Stop recording p6. the recording level. Pause recording P. • For the best results, use Press the button again to the AC power as a resume recording. power source for recording. • To erase a recording, proceed as follows: 1 Set FUNCTION to TAPE (CD/RADIO OFF). 2 Press r . Basic Operations 11 CFD-V20/V30.
ページ12に含まれる内容の要旨
The CD Player Using the display DISPLAY/ENTER You can check information about the CD using the display. Checking the total track numbers and playing time Check the display in stop mode. Total playing time Total track numbers Checking the remaining time Press DISPLAY/ENTER while playing a CD. To display Press DISPLAY/ENTER Remaining time on the Once current track* Remaining time on the CD Twice and the number of tracks left Playing time and the current Three times track number * For a track whose
ページ13に含まれる内容の要旨
The CD Player Locating a specific track You can quickly locate any track using the number buttons (CFD-V30 only). Number You can also find a specific point in a buttons track while playing a CD. =/+ (CFD-V30) Note To locate Press CFD-V30 only: a specific track directly a number button of the You cannot locate a (CFD-V30 only) track. specific track if “PGM” or ”SHUF REP” is lit in a point while listening to + (forward) or = the display. Turn off the sound (backward) while playing the indication
ページ14に含まれる内容の要旨
Playing tracks PLAY MODE ^ FUNCTION =/+ repeatedly (Repeat Play) You can play tracks repeatedly in normal, shuffle or program play modes (see page 15 ). Tip 1 Set FUNCTION to CD. CFD-V30 only: 2 Press PLAY MODE until the repeat mode you To enjoy a short repeat play, use LOOP on the want appears in the display. remote. To repeat Select As soon as you press and hold LOOP during a single track REP 1 play, the player starts all tracks REP ALL a loop play of the part between the point tracks in rand
ページ15に含まれる内容の要旨
The CD Player Creating your ^ =/+ PLAY DISPLAY/ own program FUNCTION MODE ENTER (Program Play) You can arrange the playing order of the tracks on a CD. Tips 1 Set FUNCTION to CD. • CFD-V30 only: 2 Press PLAY MODE until “PGM” appears in the To create your own program on the remote, display. proceed as follows: 3 Press the = or + then press DISPLAY/ 1 Set FUNCTION to ENTER for the tracks you want to program in the CD on the player. order you want. You can program up to 20 tracks. 2 Press MODE unti
ページ16に含まれる内容の要旨
Setting Up Choosing the AC IN power sources You can use the AC power or batteries as a power source. Use the AC power source whenever you record since recording consumes much power. Battery compartment To a wall outlet Connecting the AC power cord Insert one end of the supplied AC power cord to the AC IN socket located at the rear of the player, and the other end to the wall outlet. CFD-V30 only: Inserting batteries into the remote Insert two size AA (R6) batteries (not supplied) Replacing
ページ17に含まれる内容の要旨
Setting Up Adjusting the MEGA BASS TONE sound emphasis (TONE/MEGA BASS) You can adjust the tone and reinforce the bass sound. Adjusting the tone Turn TONE. Turn the control clockwise to enhance the high tone and counterclockwise to enhance the low tone. Reinforcing the bass sound Press MEGA BASS. To return to normal sound, press the button again. Setting Up 17 CFD-V20/V30.E_3-859-117-1X.U2/CA2/AU6/E92
ページ18に含まれる内容の要旨
Additional Information Precautions On safety On placement • As the laser beam used in the CD • Do not leave the player in a location near heat sources, or in a place subject player section is harmful to the eyes, do not attempt to disassemble the to direct sunlight, excessive dust or casing. Refer servicing to qualified mechanical shock. personnel only. • Do not place the player on an inclined • Should any solid object or liquid fall or unstable place. into the player, unplug the player, and • D
ページ19に含まれる内容の要旨
Notes on CDs Notes on cassettes • Before playing, clean the CD with a • Break off the cassette tab from side A cleaning cloth. Wipe the CD from the or B to prevent accidental recording. If center out. you want to reuse the tape for recording, cover the broken tab with adhesive tape. Side A • Do not use solvents such as benzine, Tab for side A Tab for side B thinner, commercially available cleaners or anti-static spray intended for vinyl LPs. • The use of a cassette with more than • Do not expose
ページ20に含まれる内容の要旨
Troubleshooting Symptom Remedy The power does not come on. • Connect the AC power cord securely. • Make sure the batteries are inserted correctly. • Replace all the batteries with new ones if they are weak. There is no audio. • Make sure the FUNCTION selector is set to the function you want to operate. • Adjust the volume. • Unplug the headphones when listening through speakers. The audio is weak or has poor • Replace all the batteries with new ones if they quality. are weak. • Move the player a
